Abstract
Filamentous bulking is the most common solid-separation problem in wastewater treatment systems. The phenomenon is attributed to competition between filamentous bacteria and floc-forming bacteria, a tradeoff between kinetic selection (KST) and substrate diffusion limitation (SDL). Previously, we explained our contradictory experimental results by both effects and developed a conceptual framework with three regions (bulking, intermediate, and non-bulking). However, within this purely qualitative framework, the range of substrate concentrations for each region was not determined. To test the framework and quantify the critical concentrations for the three regions, we here integrate KST and SDL into a model that simulates the growth rates of filaments and floc formers inside activated sludge flocs. Bulking and non-bulking sludges were produced in laboratory-scale reactors, and the kinetic model parameters were measured by respirometry. We then extended the model to verify our previous experimental results from sequencing batch reactors (SBRs). The effects of oxygen limitation and decay rates of floc formers and filaments on the modeled growth rates were also evaluated. In basic simulations, the model successfully determined the critical values of substrate concentrations in the framework. The results of the extended model were consistent with our experimental data, indicating that large flocs induce bulking whereas small flocs do not. Simulation results were more sensitive to the kinetic parameters than to the diffusion parameters, and the parameters more sensitively affected the growth of floc formers than filament growth.
Similar content being viewed by others
References
Atkinson, B., Daoud, I. S., & Williams, D. A. (1968). A theory for the biological film reactor. Transactions. Institute of Chemical Engineers, 46, 245–250.
Benefield, L., & Molz, F. (1983). A kinetic model for the activated sludge process which considers diffusion and reaction in the microbial floc. Biotechnology and Bioengineering, XXV, 2591–2615.
Chudoba, J., Blaha, J., & Madera, V. (1973). Control of activated sludge filamentous bulking-III. Effect of sludge loading. Water Research, 8, 231–237.
Chudoba, J., Grau, P., & Ottova, V. (1973). Control of activated-sludge filamentous bulking-II. Selection of microorganisms by means of a selector. Water Research, 7, 1389–1406.
Chudoba, J., Ottova, V., & Madera, V. (1973). Control of activated sludge filamentous bulking-I. Effect of the hydraulic regime or degree of mixing in an aeration tank. Water Research, 7, 1163–1182.
Grady, C. P. L., & Daigger, G. T. (1999). Biological wastewater treatment: theory and applications. New York: Marcel Dekker Inc.
Gujer, W., Henze, M., Mino, T., et al. (1999). Activated sludge model no. 3. Water Science and Technology, 39(1), 183–193.
Jenkins, D., Richard, M., & Daigger, G. T. (2003). Manual on the causes and control of activated sludge bulking, foaming and other solids separation problems. London: IWA Publishing.
Kappeler, J., & Gujer, W. (1994). Development of a mathematical model for “aerobic bulking”. Water Research, 28, 303–310.
Lau, A. O., Strom, P. F., & Jenkins, D. (1984). The competitive growth of floc-forming and filamentous bacteria: a model for activated sludge bulking. Journal Water Pollution Control Federation, 56(1), 52–61.
Lau, A. O., Strom, P. F., & Jenkins, D. (1984). Growth kinetics of Sphaerotilus natans and a floc former in pure and dual continuous culture. Journal Water Pollution Control Federation, 56(1), 41–51.
Liao, J., Lou, I., & de los Reyes, F. L., 3rd. (2004). Relationship of species-specific filament levels to filamentous bulking in activated sludge. Applied and Environmental Microbiology, 70(4), 2420–2428.
Lou, I., & de los Reyes, F. L., 3rd. (2005). Substrate uptake tests and quantitative FISH show differences in kinetic growth of bulking and non-bulking activated sludge. Biotechnology and Bioengineering, 92(6), 729–739.
Lou, I., & de los Reyes, F. L., III. (2005). Integrating decay, storage, kinetic selection, and filamentous backbone factors in a bacterial competition model. Water Environment Research, 77(3), 287–296.
Lou, I. C., & de los Reyes, F. L., 3rd. (2008). Clarifying the roles of kinetics and diffusion in activated sludge filamentous bulking. Biotechnology and Bioengineering, 101(2), 327–336.
Martins, A. M. P., Heijnen, J. J., & van Loosdrecht, M. C. M. (2003). Effect of feeding pattern and storage on the sludge settleability under aerobic conditions. Water Research, 37, 2555–2570.
Martins, A. M. P., Picioreanu, C., Heijnen, J. J., et al. (2004). Three-dimensional dual-morphotype species modeling of activated sludge flocs. Environmental Science & Technology, 38(21), 5632–5641.
Pochana, K., Keller, J., & Lant, P. (1999). Model development for simultaneous nitrification and denitrification. Water Science and Technology, 39(1), 235–243.
Sezgin, M., Jenkins, D., & Parker, D. S. (1978). A unified theory of filamentous activated sludge bulking. Journal - Water Pollution Control Federation, 50, 362–381.
Sheintuch, M., & Tartakovsky, B. (1997). Activated sludge system design for species selection: analysis of a detailed multispecies model. Chemical Engineering Science, 52, 3033–3046.
van Niekerk, A. M., Jenkins, D., & Richard, M. (1987). The competitive growth of Zooglea ramigera and Type 021N in activated sludge and pure culture—a model for low F:M bulking. Journal Water Pollution Control Federation, 59(5), 262–273.
van Niekerk, A. M., Jenkins, D., & Richard, M. G. (1988). A mathematical model of the carbon-limited growth of filamentous and floc-forming organisms in low F/M sludge. Journal Water Pollution Control Federation, 60(1), 100–106.
Williams, K., & McCarty, P. L. (1976). A model of substrate utilization by bacterial films. Journal of the Water Pollution Control Federation, 48, 9–24.
Acknowledgments
We thank our senior student, Wa Kam Ip, for the assistance with partial modeling analysis. This research was partially supported by the Research Committee of University of Macau, with grant No. SRG005-FST11-LIC and MYRG106(Y1-L3)-FST12-LIC.
Author information
Authors and Affiliations
Corresponding author
Additional information
Inchio Lou holds a Ph.D., University of Macau.
Iek In Ieong holds a B.S., University of Macau.
Rights and permissions
About this article
Cite this article
Lou, I., In Ieong, I. Modeling Growth of Filaments and Floc Formers in Activated Sludge Flocs: Integrating the Effects of Kinetics and Diffusion. Environ Model Assess 20, 225–237 (2015). https://doi.org/10.1007/s10666-015-9453-7
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10666-015-9453-7