Skip to main content

Characterisation of particulate matter on the receptor level in a city environment

Abstract

Airborne particulate matter (PM) has become one of the dominant pollutants with the increasing material and energy demand due to global economic growth. The main objective of this research is to provide a comprehensive receptor level characterisation of the particulate matter collected in a city environment. Particulate matter samples were collected on Tapered Element Oscillating Microbalance (TEOM) filters from five monitoring sites over a period of 1 year. An Andersen eight-stage cascade impactor was also used to collect airborne PM samples from three other locations to compare with the samples collected by TEOM. All the samples were then subjected to individual particle morphology and chemical composition analysis by SEM/EDS. Bulk chemical composition of the samples were also analysed through ICP–OES. Based on these analyses, possible sources of the PM samples were identified. The results showed that the monitoring sites in residential environments were dominated by transportation-derived particles and other migratory particulates. Monitoring sites near the city centre were dominant by particles from transportation, with biological particles abundant for the site closer to a river. The monitoring station located close to the industrial area, despite only 200 m away from a motorway, has low contribution of non-exhaust particulates from vehicles. Instead, the particulates collected from this site were dominated by industrial sources. An air dispersion modelling package was also used to model the particulate matter dispersion in the city area for the period of sampling. The results from the model showed that the points of high emissions were around industrial areas.

This is a preview of subscription content, access via your institution.

References

  • Ariola, V., D’Alessandro, A., Lucarelli, F., Marcazzan, G., Mazzei, F., Nava, S., et al. (2006). Elemental characterisation of PM10, PM2.5 and PM1 in the town of Genoa (Italy). Chemosphere, 62(2), 226–232.

    Article  CAS  Google Scholar 

  • Bacci, P., Del Monte, M., Longhetto, A., Piano, A., Prodi, F., Redaelli, P., et al. (1983). Characterization of the particulate emission by a large oil fuel fired power plant. Journal of Aerosol Science, 14(4), 557–572.

    Article  CAS  Google Scholar 

  • Brook, R. D., Franklin, B., Cascio, W., Hong, Y., Howard, G., Lipsett, M., et al. (2004). Air pollution and cardiovascular disease: A statement for healthcare professionals from the expert panel on population and prevention science of the American Heart Association. Circulation, 109, 2655–2671.

    Article  Google Scholar 

  • Callister, W. D., & Rethwisch, D. G. (2007). Materials science and engineering: An introduction. New York: Wiley.

    Google Scholar 

  • Chung, W., Sharifi, V. N., Swithenbank, J., Ossamor, O., & Nolan, A. (2008). Characterisation of airborne particulate matter in a city environment. Journal of Modern Applied Science, 2(4), 17–32.

    CAS  Google Scholar 

  • Daly, M., & Elleker, A. (2004). Environmental Protection Service. Sheffield: Sheffield City Council.

    Google Scholar 

  • Dockery, D. W., & Pope, C. A. (1994). Acute respiratory effects of particulate air pollution. Annual Review of Public Health, 15, 107–132.

    Article  CAS  Google Scholar 

  • Donaldson, K., Mills, N., MacNee, W., Robinson, S., & Newby, D. (2005). Role of inflammation in cardiopulmonary health effects of PM. Toxicology and Applied Pharmacology, 207, 483–488.

    Article  Google Scholar 

  • Dore, C., Brophy, N., Hann, M. R., Jackson, J., King, K., Murrells, T., et al. (2007). Air quality pollutant inventories for England, Scotland, Wales and Northern Ireland: 1990–2005. National Atmospheric Emissions Inventory (NAEI) UK. Report No. AEAT/ENV/R/2480, http://www.naei.org.uk/reports.php.

  • Eatough, D. J., Long, R. W., Modey, W. K., & Eatough, N. L. (2003). Semi-volatile secondary organic aerosol in urban atmospheres: Meeting a measurement challenge. Atmospheric Environment, 37, 1277–1292.

    Article  CAS  Google Scholar 

  • Gehrig, R., Hueglin, C., Schwarzenbach, B., Seitz, T., & Buchmann, B. (2005). A new method to link PM10 concentrations from automatic monitors to the manual gravimetric reference method according to EN12341. Atmospheric Environment, 39, 2213–2223.

    Article  CAS  Google Scholar 

  • Green, D., & Fuller, G. W. (2006). The implications of tapered element oscillating microbalance (TEOM) software configuration on particulate matter measurements in the UK and Europe. Atmospheric Environment, 40, 5608–5616.

    Article  CAS  Google Scholar 

  • Green, D., Fuller, G., & Barratt, B. (2001). Evaluation of TEOM ‘correction factors’ for assessing the EU Stage 1 limit values for PM10. Atmospheric Environment, 35, 2589–2593.

    Article  CAS  Google Scholar 

  • Green, D., Fuller, G. W., & Baker, T. (2009). Development and validation of the volatile correction model for PM10 – An empirical method for adjusting TEOM measurements for their loss of volatile particulate matter. Atmospheric Environment, 43, 2132–2141.

    Article  CAS  Google Scholar 

  • Harrison, D., Maggs, R., & Booker, J. (2006). UK equivalence programme for monitoring of particulate matter. Bureau Veritas, Report No. BV/AQ/AD202209/DH/2396, http://www.laqmsupport.org.uk/publications.php.

  • Hitzenberger, R., Berner, A., Galambos, Z., Maenhaut, W., Cafmeyer, J., Schwarz, J., et al. (2004). Intercomparison of methods to measure the mass concentration of the atmospheric aerosol during INTERCOMP2000 – influence of instrumentation and size cuts. Atmospheric Environment, 38, 6467–6476.

    Article  CAS  Google Scholar 

  • Laskin, A., Cowin, J. P., & Iedema, M. J. (2006). Analysis of individual environmental particles using modern methods of elecron microscopy and X-ray microanalysis. Journal of Electron Spectroscopy and Related Phenomena, 150, 260–274.

    Article  CAS  Google Scholar 

  • Li, N., Sioutas, C., Cho, A., Schmitz, D., Misra, C., Sempf, J., et al. (2003). Ultrafine particulate pollutants induce oxidative stress and mitochondrial damage. Environmental Health Perspectives, 111, 455–460.

    Article  CAS  Google Scholar 

  • Little, B., Wagner, P., Ray, R., Pope, R., & Scheetz, R. (1991). Biofilms: An ESEM evaluation of artifacts introduced during SEM preparation. Journal of Industrial Microbiology and Biotechnology, 8, 213–221.

    CAS  Google Scholar 

  • Mahmood, K. (1973). Lognormal size distribution of particulate matter. Journal of Sedimentary Research, 43, 1161–1166.

    Google Scholar 

  • Moreno, T., Jones, T. P., & Richards, R. J. (2004). Characterisation of aerosol particulate matter from urban and industrial environments: Examples from Cardiff and Port Talbot, South Wales, UK. Science of The Total Environment, 334–335, 337–346.

    Article  Google Scholar 

  • Muir, D. (2000). New directions: The suitability of tapered element oscillating microbalances (TEOMs) for PM10 monitoring in Europe—The use of PM10 data as measured by TEOM for compliance with the European Air Quality Standard. Atmospheric Environment, 34, 3209–3211.

    Article  CAS  Google Scholar 

  • Osammor, O. (2006). Airborne Particulate Matter (PM 10 and PM 2.5) Levels in Sheffield. Dioxin Research Network. Sheffield: Sheffield City Council, Environment and Regulatory Services.

    Google Scholar 

  • Palanco, S., Conesa, S., & Laserna, J. J. (2004). Analytical control of liquid steel in an induction melting furnace using a remote laser induced plasma spectrometer. Journal of Analytical Atomic Spectrometry, 19, 462–467.

    Article  CAS  Google Scholar 

  • Paoletti, L., De Berardis, B., & Diociaiuti, M. (2002). Physico-chemical characterisation of the inhalable particulate matter (PM10) in an urban area: An analysis of the seasonal trend. Science of The Total Environment, 292, 265–275.

    Article  CAS  Google Scholar 

  • Price, M., Bulpitt, S., & Meyer, M. B. (2003). A comparison of PM10 monitors at a Kerbside site in the northeast of England. Atmospheric Environment, 37, 4425– 4434.

    Article  CAS  Google Scholar 

  • Savaroglu, F., Potoglu, Erkara, I., Baycu, C., & Alkan, M. (2007). Spore morphology of some Bryaceae Schwagr. species (Bryophyta) from Turkey. International Journal of Natural and Engineering Sciences, 1, 49–54.

    Google Scholar 

  • Shi, Z., Shao, L., Jones, T. P., Whittaker, A. G., Lu, S., Berube, K. A., et al. (2001). Characterization of airborne individual particles collected in an urban area, a satellite city and a clean air area in Beijing, 2001. Atmospheric Environment, 37, 4097–4108.

    Article  Google Scholar 

  • Spengler, J. D., Samet, J. M., & McCarthy, J. F. (2001). Indoor air quality handbook. New York: McGraw-Hill.

    Google Scholar 

  • Stanger, C. (2004). Intercomparison between the TEOM Analyser and the European Reference Sampler for the Determination of PM10 Concentrations. London, Report No. CS/AQ/AD102099. http://www.airquality.co.uk/reports/cat13/0406301532_Intercomparison_report_FINAL.pdf.

  • Stanmore, B. R., Brilhac, J. F., & Gilot, P. (2001). The oxidation of soot: A review of experiments, mechanisms and models. Carbon, 39, 2247–2268.

    Article  CAS  Google Scholar 

  • Stefaniak, A. B., Hoover, M. D., Day, G. A., Dickerson, R. M., Peterson, E. J., Kent, M. S., et al. (2004). Characterization of physicochemical properties of beryllium aerosols associated with prevalence of chronic beryllium disease. Journal of Environmental Monitoring, 6, 523–532.

    Article  CAS  Google Scholar 

  • Suzuki, K. (2006). Characterisation of airborne particulates and associated trace metals deposited on tree bark by ICP–OES, ICP–MS, SEM-EDX and laser ablation ICP–MS. Atmospheric Environment, 40, 2626–2634.

    Article  CAS  Google Scholar 

  • Thermo (2003). SERIES 20–800 Eight Stage Non-viable Impactor–Instruction manual P/N 100073–00. Thermo Electron Corporation Environmental Instruments; Massachusetts.

    Google Scholar 

  • Thorpe, A., & Harrison, R. M. (2008). Sources and properties of non-exhaust particulate matter from road traffic: A review. Science of The Total Environment, 400, 270–282.

    Article  CAS  Google Scholar 

  • Vallack, H. W., & Chadwick, M. J. (1993). Monitoring airborne dust in a high density coal-fired power station region in North Yorkshire. Environmental Pollution, 80, 177–183.

    Article  CAS  Google Scholar 

  • Van Malderen, H., Van Grieken, R., Bufetov, N. V., & Koutzenogii, K. P. (1996). Chemical characterization of individual aerosol particles in Central Siberia. Environmental Science & Technology, 30, 312–321.

    Article  Google Scholar 

  • Vassilev, S. V., & Vassileva, C. G. (1996). Mineralogy of combustion wastes from coal-fired power stations. Fuel Processing Technology, 47, 261–280.

    Article  CAS  Google Scholar 

  • Vassilev, S. V., Menendez, R., Diaz-Somoano, M., & Martinez-Tarazona, M. R. (2004). Phase-mineral and chemical composition of coal fly ashes as a basis for their multicomponent utilization. 2. Characterization of ceramic cenosphere and salt concentrates. Fuel, 83, 585–603.

    Article  CAS  Google Scholar 

  • White, E. W., & DeNee, P. B. (1972). Characterization of coal mine dust by computer processing of scanning electron microscope information. Annals of the New York Academy of Sciences, 200, 666–675.

    Article  CAS  Google Scholar 

  • Zanobetti, A., Schwartz, J., & Dockery, D. W. (2000). Airborne particles are a risk factor for hospital admissions for heart and lung disease. Environmental Health Perspectives, 108, 1071–1077.

    Article  CAS  Google Scholar 

Download references

Author information

Affiliations

Authors

Corresponding author

Correspondence to Qun Chen.

Rights and permissions

Reprints and Permissions

About this article

Cite this article

Chung, W., Chen, Q., Osammor, O. et al. Characterisation of particulate matter on the receptor level in a city environment. Environ Monit Assess 184, 1471–1486 (2012). https://doi.org/10.1007/s10661-011-2054-2

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10661-011-2054-2

Keywords

  • Airborne particulate matter
  • Particle morphology
  • PM dispersion modeling
  • Urban environment