Abstract
Appropriate amorphous material composition and annealing conditions providing the magneto-elastic efficiency and linearity of the transfer characteristics in a wide interval of strain were found. A prototype of the two-coil strain sensor based on these materials was tested at different magnetizing conditions. The obtained results show a possibility to use the stress annealed·amorphous ribbons of the composition Co69Fe2Cr7Si8B14 (λs<0) and Co67Fe4Si8B14 (λs>0) for sensors in civil engineering applications.
Similar content being viewed by others
References
A. Hernando, M. Vázquez and J.M. Barandiaran: J. Phys. E: Sci. Instrum. 21 (1988) 1129.
M. Wien-Fogle, H. T. Savage and A. E. Clark: Sensors and actuators 12 (1987) 323.
J. M. Barandiaran and J. Gutierrez: Sensors and actuators, A 59 (1997) 38.
L. Kraus, F. Fendrych and J. Bydžovský: To be published.
M. Kollár, J. Bydžovský and P. Švec: Journal of Electrical Engineering 50 (1999) 96.
J. Bydžovský, M. Kollár, P. Švec, V. Jančárik and I. Vávra: in Proceedings of MM'2000 Conference, Prague 2000, p. 5.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Bydžovský, J., Kollár, M., Jančárik, V. et al. Strain sensors for civil engineering application based on CoFeCrSiB amorphous ribbons. Czech J Phys 52 (Suppl 1), A117–A120 (2002). https://doi.org/10.1007/s10582-002-0027-y
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/s10582-002-0027-y