Abstract.
The conversion of hydrocarbon fuels such as gasoline and diesel is a potential source for hydrogen production towards various fuel cell systems. A novel spray pulsed mode reactor to create alternate wet and dry conditions on the catalyst surface has been used in this study to enhance the rates of hydrogen production compared with the solid-gas phase reaction due to the improvement of the catalyst reactant contact. The production of hydrogen-rich gas by reforming of iso-octane (2,2,4-trimethylepentane) in the presence of steam and air has been studied at 600 and 700 °C over Ni–Mn and Rh–Ce bimetallic catalysts supported on alumina mesh. The feed rate of iso-octane was varied from 0.553 to 5.53 m mol min−1 by controlling pulse injection in terms of the width and frequency of injection of iso-octane. Based on the product analysis optimized condition for higher hydrogen production and high H2/CO ratio has been deduced.
Similar content being viewed by others
References
P.J. Berlowitz and P. Darnell, SAE Technical Paper 2000-01-0003
A.A Praharso D.L Adesina S Trimm N.W Cant (2004) Chem. Eng. J. 99 131
K. Murata L. Wang M. Saito M. Inaba I. Takahara N. Mimura (2004) Energy Fuels 18 122
M.G. Sobacchi A.V. Saveliev A.A. Fridman L.A. Kennedy S. Ahmed T. Krause (2002) Int. J. Hydrogen Energy 27 635
S. Springmann G. Friedrich M. Himmen M. Sommer G. Eigenberger (2002) Appl. Catal. A 235 101
G.A. Deluga J.R. Salge L.D. Schmidt X.E. Verykios (2004) Science 303 993
M. Pacheo J. Sira J. Kopasz (2003) Appl. Catal. A: Gen. 250 161
A. Ersoz H. Olgun S. Ozdogan C. Gungor F. Akgun M. Tiris (2003) J. Power Sources 118 384
T. Inui K. Saigo Y. Fujii K. Fujioka (1995) Catal. Today 26 295
V.R. Choudhary B.S. Uphade A.S. Mamman (1998) Microporous and Mesoporous Materials 23 61
C. Palm P. Crener R. Peters D. Stolten (2002) J. Power Sources 106 231
S. Ahmed M. Krumpelt (2001) Int. J. Hydrogen Energy 26 291
J.R. Rostrup-Nielsen, in: Catalysis Science and Technology, J.R. Anderson and M. Boudart (eds), Vol. 5 (Springer-Verlag, Berlin, 1984) Ch. 1
A.K. Avci Z.I. Onsan D.L. Trimm (2001) Appl. Catal. A: Gen. 216 243
N. Kariya A. Fukuoka M. Ichikawa (2002) Appl. Catal. A 233 91
N. Kariya A. Fukuoka T. Utagawa M. Sakuramoto Y. Goto M. Ichikawa (2003) Appl. Catal. A: Gen. 247 1
P.E. Savage (2000) J. Anal. Appl. Pyrol. 54 109
J.P. Kopasz, R. Wilkenhoener, S. Ahmed, J.D. Carter and M. Krumpelt, Chemical Technology Division, Argonne National Laboratory, Argonne, IL, USA. Preprints of Symposia – American Chemical Society, Division of Fuel Chemistry 44(4) (1999) 899
J.R. Rostrup-Nielsen I. Alstrup (1999) Catal. Today 53 311
J.R. Rostrup-Nielsen (1973) J. Catal. 31 173
E. Kikuchi K. Ito Y. Ino Y. Morita (1977) J. Catal. 46 382
D.C. Grenoble (1978) J. Catal. 51 203
J.R. Rostrup-Nielsen J.H. BakHansen (1993) J. Catal. 144 38
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Biniwale, R.B., Ichikawa, N.K.M. Production of hydrogen-rich gas via reforming of iso-octane over Ni–Mn and Rh–Ce bimetallic catalysts using spray pulsed reactor. Catal Lett 100, 17–25 (2005). https://doi.org/10.1007/s10562-004-3080-2
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/s10562-004-3080-2