Results are provided for a study of specimen microstructure and strength properties obtained by 3Dprinting (selective laser melting) of Al–Mg–Sc alloy also subjected to heat treatment.
Similar content being viewed by others
References
A. E. Shkuro and P. S. Krivonogov, 3D-Printing Technology and Materials [in Russian], Ural State Forestry University, Ekaterinburg (2017).
I. S. Loginova, Study of Structure Formation in Aluminum Alloy Laser Treatment Process Intended for Additive Technology [in Russian], Diss. Cand. Techn. Sci. National Research Technology Institute, MISiS (2019).
W. Stautner, et al., “The scope of additive manufacturing in cryogenics, component design, and applications,” IOP Conf. Ser.: Mater. Sci. Eng. (2017).
D. Jia, F. Li, and Y. Zhang, 3D-Printing Process Design of Lattice Compressor Impeller Based on Residual Stress and Deformation, Scientific Reports, 10, Article number 600 (2020).
A. V. Bronz, V. I. Efremov, A. D. Plotnikov, and A. G. Chernyavskii, “Alloy 1570 – material for sealing structures of prospective constructions for RKK ÉNERGIYa repeated use objects,” Kosm. Tekhnika Tekhnol., No. 4, 62–67 (2014).
A. P. Gulyaev, Materials Science [in Russian], Metallurgiya, Moscow (1977).
N. Van Keulen, and A. A. Goh, “A digital future for spare part management,” Jun 21 (2021); https://www.shell.com/energyand-innovation/digitalisation/a-digitalfuture-for-spare-part-management.html. Referral date 05.05.2022.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, Vol. 58, No. 6, pp. 43−44, June, 2022.
Rights and permissions
Springer Nature or its licensor holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Stepanov, A.V., Skoltsov, V.I., Voronin, A.S. et al. Study of the Mechanical Properties of Al–Mg–Sc Alloy Specimens Prepared by Selective Laser Melting. Chem Petrol Eng 58, 523–527 (2022). https://doi.org/10.1007/s10556-022-01123-y
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10556-022-01123-y