The article presents the results of a numerical study of the operation of welded movable hull supports of technological pipelines. An assessment of the influence of design parameters and the sliding degree of the supports from the support substructure on their stress-strain state has been carried out. It has been established that such parameters as the pipe wall rigidity, the height of the support, the size and location of the contact zone with the support substructure have influence on the operability of the support. The results obtained can be used in the design of pipeline supports.
Similar content being viewed by others
References
OST 36-146–8, Supports of Steel Technological Pipelines for Pconv up to 10 MPa [in Russian], Standartinform, Moscow (1989).
O. Zenkevich, Finite Element Method in Engineering [in Russian], Mir, Moscow (1975).
V. I. Surikov, V. M. Varshitskii, V. V. Bondarenko, et al., “Using finite element method in the strength calculation for the pipeline supports in above-ground areas of “Zapolyar’e — NPS “PUR-PE”” oil pipeline,” Vestn. MGSU, No. 1, 66–74 (2014).
GOST 34233.1-2017, Vessels and Apparatuses. Norms and Methods for Strength Calculations [in Russian], Standartinform, Moscow (2019).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, Vol. 58, No. 3, pp. 25–29, March, 2022.
Rights and permissions
Springer Nature or its licensor holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Provorov, A.V., Pavlov, A.A. & Lebedev, A.E. Study of the Operation of Movable Hull Supports of Technological Pipelines. Chem Petrol Eng 58, 217–223 (2022). https://doi.org/10.1007/s10556-022-01078-0
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10556-022-01078-0