The article presents the layout and technical data of the developed small-sized two-roll pressing machine for pressing moisture-containing industrial waste. The analysis of the model of the material layer deformation in the range of the machine drums and the dynamic forces acting on the layer of moisturecontaining waste during its pressing is carried out.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
V. A. Panfilov and O. A. Urakov, Technological Lines of Food Production: Creating a Technological Flow [in Russian], Pishchevaya Promyshlennost’, Moscow (1996).
Z. Tadmor and K. Gogos, Theoretical Foundations of Polymer Processing [Russian translation], Khimiya, Moscow (1984).
J. M. McKelvey, Polymer Processing [Russian translation], Khimiya, Moscow (1965).
K. J. Valentas, E. Rotstein, and R. P. Singh, Handbook of Food Engineering Practice [Russian translation], Professiya, St. Petersburg (2004).
V. V. Volkov and V. A. Avrorov, Simulation of Technological Operations and Development of Structural Diagrams of Equipment for Cotton Spinning Production [in Russian], PGTA, Penza (2011).
M. A. Poldjaeva, “On the technology of processing moisture-containing food waste,” XXI Vek: Itogi Proshl. Probl. Nastoyashch. Plyus, No. 01 (29), 79–84 (2016).
Yu. A. Kaloshin, Yu. M. Berezovsky, and L. V. Vernyaeva, Physical and Mechanical Properties of Raw Materials and Finished Products [in Russian], MGUTU, Moscow (2009).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, Vol. 57, No. 2, pp. 20–22, February, 2021.
Rights and permissions
About this article
Cite this article
Avrorov, V.A., Redchenko, M.A. & Murashkina, O.A. Drum Pressing Machine for Pressing Moisture-Containing Industrial Waste. Chem Petrol Eng 57, 122–128 (2021). https://doi.org/10.1007/s10556-021-00904-1
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10556-021-00904-1