The subject of the study is a steam-gas (combined-cycle) contact plant with overexpansion of the working fluid inside the gas turbine and a hot-water recovery boiler. A special feature of the design is that dry saturated steam is used for injection and a regenerator serves as the mixing point. A hot-water recovery boiler is also installed to reduce heat loss into the environment. The study was carried out using the software package, System for Automated Calculation of the Parameters of Gas-Turbine Plants and Combined-Cycle Steam-Gas Plants. Results of variant parametric optimization of the working fluids of the plant performed according to a given design are presented. An additional increase in the useful power of the steam plant is due to the use of the regenerator as a steam superheater. In this case, the efficiency reaches 46.43% and the capacity of the hot-water recovery boiler, 4.7 MW. The method of mathematical simulation based on graph theory is used to verify the correctness of calculations.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
G. G. Ol’khovskii, “First tests of high-power gas-turbine power plants,” Teploenergetika, No. 1, 6−13 (2014).
S. V. Panev, V. D. Burov, and A. N. Remezov, Gas-Turbine and Steam-Gas Plants of Thermal Power Plants, Izd. MEI, Moscow (2009).
Invent. Certif. No. 724786 USSR, “A steam-gas plant,” Byull., No. 12 (1980).
Invent. Certif. No. 918458 USSR, “A steam-gas plant,” Byull., No. 13 (1982).
Invent. Certif. No. 987126 USSR, “A steam-gas plant,” Byull., No. 1 (1983).
I. V. Sherstobitov and B. V. Biryukov, “On the efficiency of a steam-gas plant with overexpansion of the working fluid in the gas turbine,” Izv. Vuz. Energetika, No. 4, 82−87 (1987).
V. V. Shaposhnikov, B. V. Biryukov, and A. V. Shaposhnikov, “Comparison of the efficiency of thermal circuits and cycles of steam-gas plants with injection of water vapor from a recovery boiler into the gas path,” Sovrem. Probl. Nauki Obrazov., No. 2 (2015), www.science-education.ru/1222-21208.
A. M. Gaponenko, B. V. Biryukov, and V. V. Shaposhnikov, “On the efficiency of steam-gas plants with overexpansion of the working fluid in the gas turbine and injection of dry saturated steam from a recovery boiler into a high-pressure regenerator,” Izv. Vuz. Severo-Kavkaz. Region. Tekh. Nauki, No. 1, 52−56 (2016).
G. G. Ol’khovskii, “Gas-turbine and steam-turbine plants in Russia,” Teploenergetika, No. 1, 2−9 (1999).
V. V. Shaposhnikov and B. V. Biryukov, Certif. State Registr. Comp. Progr. No. 2015613955 RF, “System for automatic calculation of the parameters of gas-turbine plants and combined-cycle steam-gas plants.”
L. S. Popyrin, Mathematical Simulation and Optimization of Thermal and Electric Power Plants, Energiya, Moscow (1978).
B. V. Biryukov and V. V. Shaposhnikov, “A mathematical model of a generalized circuit of a gas-turbine plant with the use of graph theory,” Prom. Energet., No. 2, 29−33 (2015).
N. I. Vasil’ev, N. N. Avakimyan, and E. N. Datsenko, “Selection of the parameters of elements of thermal and electric power plants and networks by the method of successive approximation,” Prom. Energet., No. 11, 35−37 (2010).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, No. 2, pp. 18–21, February, 2018.
Rights and permissions
About this article
Cite this article
Shaposhnikov, V.V., Biryukov, B.V. On the Efficiency of Heat and Electric Power Plants Based on Combined-Cycle Plants with Overexpansion of the Working Fluid in the Gas Turbine and Injection of Steam into the Gas Path. Chem Petrol Eng 54, 94–99 (2018). https://doi.org/10.1007/s10556-018-0445-8
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10556-018-0445-8