Advertisement

Chemical and Petroleum Engineering

, Volume 53, Issue 1–2, pp 71–77 | Cite as

Conditions of Stable Ignition of Coal-Water Slurry Containing Petrochemicals Based on Carbon Residue of Tire Pyrolysis

  • K. Yu. Vershinina
  • D. O. Glushkov
  • P. A. Strizhak
  • D. P. Shabardin
RESEARCH, DESIGN, CALCULATIONS, AND OPERATING EXPERIENCE PROCESSES AND EQUIPMENT FOR CHEMICAL AND OIL-GAS PRODUCTION
  • 60 Downloads

The results of experimental investigations of ignition of single droplets (radius of 0.5–1.5 mm) of coal-water slurry containing petrochemicals (CWSP) in a stream of air (oxidizer) with a temperature of 600–1200 K and velocity of 0.5–5 m/sec are presented. Carbon residue (particle sizes of 80–100 μm) from pyrolysis of used automobile tires, water, and exhausted engine, turbine and transformer oils were used as the main fuel components. The times of ignition delay and complete combustion of CWSP droplets were determined atvarying concentrations of the components in the ranges corresponding to modern combustion and burner devices. The conditions at which stable combustion of CWSP is initiated were determined.

Keywords

automobile tires processing pyrolysis products carbon residue coal-water slurry containing petrochemicals droplet ignition 

References

  1. 1.
    T. A. Kulagina and O. A. Troshkin, “Increasing ecological safety of heat engineering plants at the transition to coal-water slurry fuel,” Khim. Neftegaz. Mashinostr., No. 7, 11–13 (2006).Google Scholar
  2. 2.
    G. S. Khodakov, “Water-coal suspensions in power engineering,” Teploenergetika, No. 1, 35–45 (2007).Google Scholar
  3. 3.
    A. Kijo-Kleczkowska, “Combustion of coal-water suspensions,” Fuel, 90, 865–877 (2011).CrossRefGoogle Scholar
  4. 4.
    J. Yu., K. Zhou, and W. Ou, “Mass transfer coefficients considering effects of steam in oxy-fuel combustion of coal char,” Fuel, 111, 48–56 (2013).Google Scholar
  5. 5.
    J. Zhu, G. Zhang, G. Liu, et al., “Investigation on the rheological and stability characteristics of coalwater slurry with a long side-chain polycarboxylate dispersant,” Fuel Process. Technol., 118, 187–191 (2014).CrossRefGoogle Scholar
  6. 6.
    E. G. Gorlov, “Composite water-containing fuels from coals and petroleum products,” Khim. Tv. Topl., No. 6, 50–61 (2004).Google Scholar
  7. 7.
    Yu. F. Patrakov, N. I. Fedorova, and A. I. Efremov, “Composite water-containing fuel from low-grade coals of Kuzbass,” Vest. Kuzbass. GTU, No. 3, 81–83 (2006).Google Scholar
  8. 8.
    Yu. V. Ovchinnikov, A. I. Tsepenok, A. V. Shikhotinov, and E. V. Tatarnikova, “Investigation of the ignition of solid fuels and artificial composite liquid fuels,” Reports of the Academy of Sciences of Higher Education of Russia (2011), pp. 117–126.Google Scholar
  9. 9.
    D. O. Glushkov, D. P. Shabardin, P. A. Strizhak, and K. Yu. Vershinina, “Influence of organic coal-water fuel composition of the characteristics of sustainable droplet ignition,” Fuel Process. Technol., 143, 60–68 (2016).CrossRefGoogle Scholar

Copyright information

© Springer Science+Business Media New York 2017

Authors and Affiliations

  • K. Yu. Vershinina
    • 1
  • D. O. Glushkov
    • 1
  • P. A. Strizhak
    • 1
  • D. P. Shabardin
    • 1
  1. 1.National Research Tomsk Polytechnic UniversityTomskRussia

Personalised recommendations