The basic aspects of mathematical tools for developing a module for calculating parameters of blades of sectional axial tools are elucidated. The place of the module in the CAD/CAM system of designing sectional tools developed around graph models is determined. The main stages of CAD/CAM system operation are indicated. The results of operation of the module for designing sectional drill fitted with two detachable plates are reported.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
S. I. Lashnev, A. N. Borisov, and S. G. Emel’yanov, Geometrical Theory of Shaping Surfaces by Cutting Tools, Kursk State Techn. Univ., Kursk (1997).
S. G. Emel’yanov, O. S. Sorokina, and Yu. G. Shirokonosov, “Mathematical aspects of designing and fabricating sectional axial tools based on graph models,” STIN, No. 7, 21–24 (1999).
O. S. Zubkova, “Distinctive features of orientation of detachable many-sided plates (DMP) in designing sectional drill fitted with two DMPs in CAD/CAM/CAE system of sectional axial tool,” Proc. 1st Int. Sci.-Pract. Conf., Kursk State Techn. Univ., Kursk (2009), Pt. 1, pp. 98–100.
O. S. Zubkova, “Modeling of process of machining holes by sectional drill fi tted with two detachable many-sided plates.” Izv. Kursk. Gos. Tekhn. Univ., Ser. Tekhn. Tekhnol., No. 4 (25), 20–23 (2013).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, No. 11, pp. 3–6, November, 2016.
Rights and permissions
About this article
Cite this article
Zubkova, O.S. Development of Mathematical Tools of a Module for Calculating Parameters of Blades in Cad/Cam System for Designing Sectional Axial Tools . Chem Petrol Eng 52, 729–734 (2017). https://doi.org/10.1007/s10556-017-0260-7
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10556-017-0260-7