Skip to main content
SpringerLink
Log in

Designing the pressing fitting for a vulcanizing mold

  • Published:
Chemical and Petroleum Engineering Aims and scope

A simple and reasonably accurate method is proposed for the engineering design on a strength basis for the toroidal shells linked to ring plates with allowance for the stress and strain state of the internal toroidal shell. Two forms of pressing fitting are considered and two modes of calculation based on the canonical equations in the forced method. There is not more than 3% difference between the results from the finite-element method and from the proposed method.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. V. L. Legostaev and E. D. Mordovin, A Method of Resolving the Static Uncertainty at Contact Joints for Toroidal Shells With Ring Plates [in Russian], Vestnik TGTU, Vol. 12, No. 2A, Tambov (2006).

  2. G. S. Pisarenko, A. B. Yakovlev, and A. A. Matveev, Handbook on the Resistance of Materials [in Russian], Naukova Dumka, Kiev (1975).

    Google Scholar 

  3. V. I. Anur'ev, Engineering Designer's Handbook, Vol. 1 [in Russian], Mashinostroenie, Moscow (1978).

    Google Scholar 

  4. V. I. Myachenkov, V. P. Mal'tsev, V. P. Maiboroda, et al., Finite-Element Calculations on Engineering Structures: A Handbook [in Russian], Mashinostroenie, Moscow (1989).

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. NIIRTmash OAO, Tambov, Russia

    V. I. Kochetov

  2. Tambov State Technical University, Tambov, Russia

    A. S. Klinkov, M. V. Sokolov & D. V. Tulyakov

Authors
  1. V. I. Kochetov
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. A. S. Klinkov
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. M. V. Sokolov
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. D. V. Tulyakov
    View author publications

    You can also search for this author in PubMed Google Scholar

Additional information

Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, No. 10, pp. 18–21, October, 2008.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Kochetov, V.I., Klinkov, A.S., Sokolov, M.V. et al. Designing the pressing fitting for a vulcanizing mold. Chem Petrol Eng 44, 568–574 (2008). https://doi.org/10.1007/s10556-008-9101-z

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10556-008-9101-z

Keywords

Search

Navigation