Abstract
An analysis is presented of fluoroplast bellows designs and manufacturing methods. A method is considered for making bellows from PTFE powder by pressing in special molds, which provides high reliability, preset pressure strength, and axial, angular, and cyclic working lives.
Similar content being viewed by others
References
E. N. Kashigin, N. F. Popov, and D. I. Shetulov, “Design of end seals with fluoroplast bellows,” in: General Sector Aspects of Chemical Industry Development, Issue 12 (142) [in Russian], NIITÉ KhIM, Moscow (1978).
E. N. Kashigin, “Fluoroplast end-seal bellows,” Informatsionyi Listok, Gorkii (1977), TsNTI No. 241-77.
Ya. P. Volosin and B. I. Popov, “Experience with making fluoroplast bellows,” Khim. Neft. Mashinostr., No. 3 (1970).
“Faltenbalge aus PTFE,” Information für die Chemische Industrie, Pampus, C1, 67, 21–22.
“42LD fluoroplast bellows,” Informats. List. No. 0018-76, TsINTIKhIMNEFTEMASh (1975).
V. Didenko and A. Savenkov, “A line for making tubes with diameters from 10 to 50 mm out of fluoroplast-4D,” in: Express Information on the Operations of Research Institutes and Design Offices in the Sector, Series KhM-2, No. 3 [in Russian], TsINTIKhIMNEFTEMASh (1976), pp. 15–16.
M. P. Stepochkina, Express Information on Conferences, Meetings, and Exhibitions, Series KhM-2, No. 1 [in Russian], TsINTIKhIMNEFTEMASh (1975).
Fluorocarbon Plastics: Guideline Catalog [in Russian], NIITÉKhIM, Cherkassy (1974), p. 80.
Author information
Authors and Affiliations
Additional information
__________
Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, No. 8, pp. 46–47, August, 2006.
Rights and permissions
About this article
Cite this article
Kashigin, E.N., Zershchikov, K.Y. & Kalmykova, Y.L. Design and manufacture of PTFE bellows. Chem Petrol Eng 42, 473–477 (2006). https://doi.org/10.1007/s10556-006-0129-7
Issue Date:
DOI: https://doi.org/10.1007/s10556-006-0129-7