Skip to main content

Advertisement

SpringerLink
Log in

Three-Proof Optimization of Gas Turbine Generator Set of Offshore Platform

  • INNOVATIVE TECHNOLOGIES OF OIL AND GAS
  • Published:
Chemistry and Technology of Fuels and Oils Aims and scope

The Marine environment is characterized by high salt content and humidity in the air, and the gas components in gas generators are complicated and corrosive, leading to the occurrence of low temperature and hot corrosion on the surface and inside of gas generators, which seriously affects the performance, reliability and service life of gas turbines. Taking AGT-7B gas turbine as the research object, this paper conducts a theoretical analysis on the corrosion resistance of low-temperature components, high-temperature components and non-metallic components of gas turbine.By conducting salt spray corrosion test, anti-corrosion ability test after surface protection and gas corrosion test before and after coating on the selected alloys of high-temperature components, a series of anti-corrosion design schemes of gas turbine components under marine environment are obtained, and the protection measures of the whole gas turbine generator set under marine environment are given.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.
Fig. 6.

Similar content being viewed by others

References

  1. Xu Haibo; Hong Yi; Wang Wenxiang; An Weizheng; Hou Guangxin; Yu Bangting. “Analysis of the technologies for the new type of power generators on offshore oilfields,” China Offshore Oil and Gas. 151-155,2,28(2016).

  2. Ni, Shentong; Tang, Yang; Wang, Guorong; Yang, Liu; Lei, Bo; Zhang, Zhidong. “Risk identification and quantitative assessment method of offshore platform equipment,” ENERGY REPORTS. 7219-7229,8(2022).

  3. Krishnan, Vaidyanathan; Bharani, Sanjeev; Kapat, J. S.; Sohn, Y. H.; Desai, V. H. “A simplistic model to study the influence of film cooling on low temperature hot corrosion rate in coal gas/syngas fired gas turbines,” International journal of heat and mass transfer. 1049-1060, 51,5-6(2008).

  4. Sumner, Joy; Encinas-Oropesa, Adriana;Simms, Nigel J.; Oakey, John E. “High temperature oxidation and corrosion of gas turbine component materials in burner rig exposures,”MATERIALS AT HIGH TEMPERATURES. 369-376, 28, 04(2012).

  5. Yang Hongbo; Wang Yuansheng; Wang Xuan; Wu Qiang. “Research Progress of Hot Corrosion and Protection Technology of Gas Turbine under Marine Environment,” Surface Technology. 163-172, 49, 01(2020).

  6. Eliaz, N; Shemesh, G; Latanision, RM. “Hot corrosion in gas turbine components,” Engineering failure analysis. 31-43, 9,01(2002).

  7. Sumner, Joy; Encinas-Oropesa, Adriana; Simms, Nigel J; Oakey, John E. “High temperature oxidation and corrosion of gas turbine component materials in burner rig exposures,” materials at high temperatures. 369-376, 28, 04(2012).

  8. Hollaeder, Christian; Kiliani, Stefan; Stamm, Werner; Lusebrink, Oliver; Harders, Harald; Wessel, Egbert; Muller, Michael;Singheiser, Lorenz. “Hot corrosion of TBC-coated components upon combustion of low-sulfur fuels,” Materials and corrosion-werkstoffe und korrosion. 1643-1655, 72, 10(2021).

  9. Wang Li; Liu Chunyang; Han Zhenyu; Tong Wenwei. “hot corrosion behavior and evaluation of turbine components and materials used for gas turbine engine,” Journal of Chinese Society of Corrosion and Protection. 399-403,31,05(2021).

  10. Wang Jianfeng; Zhang Chao; Jing Yong; Jia Zhiming. “Thermodynamics-based Hot Corrosion Evaluation for Turbine Blade of Gas Turbine for Offshore Platformt,” Journal of Engineering for Thermal Energy and Power. 51-57,31,4(2019).

  11. Deodeshmukh, V. P. “Evaluating the Hot Corrosion Behavior of High-Temperature Alloys for Gas Turbine Engine Components,” JOM. 2608-2614,67,11(2015).

  12. Xu, Yong;Huang, Yanliang; Cai, Fanfan; Lu, Dongzhu;Wang, Xiutong. “Study on corrosion behavior and mechanism of AISI 4135 steel in marine environments based on field exposure experiment,” SCIENCE OF THE TOTAL ENVIRONMENT. 830(2022).

  13. SONG Zhao-xing; LI Wei-hua; WANG Li. “Research on coordinated control strategy for gas-steam combined cycle unit with double shaft,” Electric Power. 64-67,42,7(2009).

  14. LU Tai; SUN Rui; ZHANG Xuerong. “Discussion on the design of 350 MW-class gas-steam combined cycle units,” Electric Power. 14-17,39,3,(2006).

  15. Goyal, Khushdeep;Singh, Hazoor; Bhatia, Rakesh. “Hot corrosion behaviour of carbon nanotubes reinforced chromium oxide composite coatings at elevated temperature,” Materials research express. 5,11(2018).

  16. Savrai, R. A.;Skorynina, P. A. “Structural-phase transformations and changes in the properties of AISI 321 stainless steel induced by liquid carburizing at low temperature,” Surface & coatings technology. 443(2022).

  17. Ali, Rawaid; Song, Peng; Khan, Muhammad; Huang, Taihong; Ali, Shabir; Sha, Syed Hatim; Lu, Jiansheng; Ul Wahab, Zain; Pervaiz, Seemab. “The effect of pre-oxidation on the hot corrosion behavior of CoNiCrAlHf alloy in Na2SO4 environment at elevated temperature,” Applied physics a-materials science & processing. 128,9(2022).

  18. Derelizade, K.; Rincon, A.; Venturi, F.;Wellman, R. G.; Kholobystov, A. ; Hussain, T. “High temperature (900 degrees C) sliding wear of CrNiAlCY coatings deposited by high velocity oxy fuel thermal spray,” Surface & coatings technology. 432(2022).

  19. Chen, Zhonghua; Cai, Yuande; Lu, Yunyun; Cao, Qi; Lv, Peibin; Zhang, Yiru; Liu, Wenjie. “Preparation and Performance Study of Carboxy-Functionalized Graphene Oxide Composite Polyaniline Modified Water-Based Epoxy Zinc-Rich Coatings,” COATINGS. 12,6(2022).

  20. Liu, Xing-liang; Dai, Yu; Wang, Zhuo-jian; Wu, Jian. “Research progress on tantalum carbide coatings on carbon materials,” New carbon materials. 36,6(2022).

Download references

Author information

Authors and Affiliations

  1. CNOOC China Ltd._Zhanjiang, Zhanjiang, Guangdong, China

    Kongzhong Liu

  2. CNOOC China Ltd._Hainan, Haikou, Hainan, China

    Xiaoyu Dong, Pingan Duan & Jiu Cheng

  3. China University of Petroleum-Beijing, Beijing, China

    Yao Zhou

Authors
  1. Kongzhong Liu
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Xiaoyu Dong
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Yao Zhou
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Pingan Duan
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. Jiu Cheng
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Yao Zhou.

Additional information

Translated from Khimiya i Tekhnologiya Topliv i Masel, No. 5, pp. 87–90 September–October, 2022.

Rights and permissions

Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Liu, K., Dong, X., Zhou, Y. et al. Three-Proof Optimization of Gas Turbine Generator Set of Offshore Platform. Chem Technol Fuels Oils 58, 820–827 (2022). https://doi.org/10.1007/s10553-022-01457-6

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10553-022-01457-6

Keywords

Search

Navigation