Influence of Gas Solubility on Zero Gas Flow Characteristics in MPD Operation

In this paper the authors have put forward the concept of annular zero gas flow and developed the residual gas model, considering the parameters of gas solubility, slippage, and the oil-based drilling fluid volume coefficient [1-3]. The calculation results show that in the process of continuous gas influx at the bottom of the well, the phenomenon of annular zero gas flow can be defined in terms of gas solubility [4-6]. The increase in the back pressure, the decrease in the gas invasion rate, and the decrease in the oil-based ratio can cause an increase in the length of the annular zero gas flow well section. When the back pressure increases from 0.1 to 4.0 MPa, the length of the annular zero gas flow section increases from 1000 to 2700 m. If the zero gas flow is not taken into consideration, the maximum error of the annular void ratio is 21.22% [7-10]. When the CO2, gas invades the bottom of the well, the oil-based ratio increases from 0.1 to 5, the length of the annular zero gas flow section increases from 1500 to 2250 m, and the maximum error of the annular void ratio is 26.57%.

This is a preview of subscription content, log in to check access.

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.

References

  1. 1.

    W. Bacon, “Consideration of compressibility effects for applied-back pressure dynamic well control response to a gas kick in managed pressure drilling operations,” Master’s thesis, University of Texas, Arlington, USA (2011).

    Google Scholar 

  2. 2.

    W. Guo, F. Honghai, and L. Gang, “Design and calculation of a MPD model with constant bottom hole pressure,” Pet. Explor Dev., 38(1), 103-108 (2011).

    CAS  Article  Google Scholar 

  3. 3.

    H. Santos et. al., “Micro-flux control: the next generation in drilling process for ultra deepwater,” 15062-OTC, Offshore Technology Conference, Houston, Texas, 5-8 May (2003).

  4. 4.

    C. Vogelpohl, C. Brandenbusch, and G. Sadowski, “High-pressure gas solubility in multicomponent solvent systems for hydroformylation. Part II: Syngas solubility,” J. Supercrit. Fluids, 88, 74-84 (2014).

    CAS  Article  Google Scholar 

  5. 5.

    A. Bahadori, H. B. Vuthaluru, and S. Mokhatab, “Analyzing solubility of acid gas and light alkenes in triethylene glycol,” J. Nat. Gas Chem., 01, 51-58 (2008).

    Article  Google Scholar 

  6. 6.

    F. Esmaeilzadeh, I. Goodarznia, and R. Danesh, “Solubility calculation of oil-contaminated drill cuttings in supercritical carbon dioxide using statistical associating fluid theory (PC-SAFT),” Chem. Eng. Tech., 31(1), 66-70 (2008).

    CAS  Article  Google Scholar 

  7. 7.

    J. J. Hidalgo, C. W. MacMinn, and R. Juanes, “Dynamics of convective dissolution from a migrating current of carbon dioxide,” Adv. Water Res., 62, 511-519 (2013).

    CAS  Article  Google Scholar 

  8. 8.

    E. Khamehchi, F. Rashidi, H. Rasouli, and A. Ebrahimian, “Novel empirical correlations for estimation of bubble point pressure, saturated viscosity, and gas solubility of crude oils,” Pet. Sci., 6, 86-90 (2009).

    CAS  Article  Google Scholar 

  9. 9.

    B. Yu, H. Cong, and X. Zhao, “Hybrid brominated sulfonated poly (2,6-diphenyl-l,4-phenylene oxide) and SiO2, nanocomposite membranes for CO2/N2 separation,” Prog. Nat. Set.: Mater. Int., 22(6), 661-667 (2012).

    Article  Google Scholar 

  10. 10.

    P. L. O’Bryan, A. T. Bourgoyne, T. G. Monger, et al., “An experimental study of gas solubility in oil-based drilling fluids,” SPE Drill. Eng., 3, 33-42 (1988).

    Article  Google Scholar 

Download references

Acknowledgment

The research has been funded by the Scientific Research and Technological Development of CNP? as part of the project “Integration and test of quick drilling and completion technology in key areas such as the south edge of Junggar and Mahu,” project No.2019F-33.

Author information

Affiliations

Authors

Corresponding author

Correspondence to Weiwei Teng.

Additional information

Translated from Khimiya i Tekhnologiya Topliv i Masel, No. 5, pp. 79 – 82, September – October, 2020.

Rights and permissions

Reprints and Permissions

About this article

Verify currency and authenticity via CrossMark

Cite this article

Teng, W., Shi, J., Wu, B. et al. Influence of Gas Solubility on Zero Gas Flow Characteristics in MPD Operation. Chem Technol Fuels Oils (2020). https://doi.org/10.1007/s10553-020-01195-7

Download citation

Keywords

  • solubility
  • zero gas flow
  • gas-liquid two-phase flow
  • drilling
  • annulus