Abstract
Simulating turbulent flows in a city of many thousands of buildings using general high-resolution microscopic simulations requires a grid number that is beyond present computer resources. We thus regard a city as porous media and divide the whole hybrid domain into a porous city region and a clear fluid region, which are represented by a macroscopic k–\({\varepsilon}\) model. Some microscopic information is neglected by the volume-averaging technique in the porous city to reduce the calculation load. A single domain approach is used to account for the interface conditions. We investigated the turbulent airflow through aligned cube arrays (with 7, 14 or 21 rows). The building height H, the street width W, and the building width B are the same (0.15 m), and the fraction of the volume occupied by fluid (i.e. the porosity) is 0.75; the approaching flow is parallel to the main streets. There are both microscopic and macroscopic simulations, with microscopic simulations being well validated by experimental data. We analysed microscopic wind conditions and the ventilation capacity in such cube arrays, and then calculated macroscopic time-averaged properties to provide a comparison for macroscopic simulations. We found that the macroscopic k–\({\varepsilon}\) turbulence model predicted the macroscopic flow reduction through porous cube clusters relatively well, but under-predicted the macroscopic turbulent kinetic energy (TKE) near the windward edge of the porous region. For a sufficiently long porous cube array, macroscopic flow quantities maintain constant conditions in a fully developed region.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Antohe BV, Lage JL (1997) A general two-equation macroscopic turbulence model for incompressible flow in porous media. Int J Heat Mass Transf 40(13): 3013–3024
Baik JJ, Kim JJ (2002) On the escape of pollutants from urban street canyons. Atmos Environ 36(3): 527–536
Belcher SE (2005) Mixing and transport in urban areas. Philos Trans R Soc A 363: 2947–2968
Belcher SE, Jerram N, Hunt JCR (2003) Adjustment of turbulent boundary layer to a canopy of roughness elements. J Fluid Mech 488: 369–398
Britter RE, Hanna SR (2003) Flow and dispersion in urban areas. Annu Rev Fluid Mech 35: 469–496
Brown MJ, Lawson RE, Decroix DS, Lee RL (2001) Comparison of centerline velocity measurements obtained around 2D and 3D buildings arrays in a wind tunnel. Report LA-UR-01-4138, Los Alamos National Laboratory, Los Alamos, 7 pp
Chan HC, Huang WC, Leu JM, Lai CJ (2007) Macroscopic modelling of turbulent flow over a porous medium. Int J Heat Fluid Flow 28(5): 1157–1166
Chandesris M, Serre G, Sagaut P (2006) A macroscopic turbulence model for flow in porous media suited for channel, pipe and rod bundle flows. Int J Heat Mass Transf 49(15–16): 2739–2750
Chang CH, Meroney RN (2003) The effect of surroundings with different separation distances on surface pressures on low-rise buildings. J Wind Eng Ind Aerodyn 91(8): 1039–1050
Cheng Y, Lien FS, Yee E, Sinclair R (2003) A comparison of large Eddy simulations with a standard k–\({\varepsilon}\) Reynolds-averaged Navier—Stokes model for the prediction of a fully developed turbulent flow over a matrix of cubes. J Wind Eng Ind Aerodyn 91(11): 1301–1328
Choi CY, Waller PM (1997) Momentum transport mechanism for water flow over porous media. J Environ Eng-ASCE 123(8): 792–799
Coceal O, Belcher SE (2005) Mean winds through an inhomogeneous urban canopy. Boundary-Layer Meteorol 115(1): 47–68
de Lemos MJS (2005) Turbulent kinetic energy distribution across the interface between a porous medium and a clear region. Int Commun Heat Mass Transf 32(1–2): 107–115
Ding A, Wang T, Zhao M, Wang TJ, Li ZK (2004) Simulation of sea-land breezes and a discussion of their implications on the transport of air pollution during a multi-day ozone episode in the Pearl River Delta of China. Atmos Environ 38(39): 6737–6750
Etheridge D, Sandberg M (1996) Building ventilation: theory and measurement. Wiley, New York, 724 pp
Fenger J (1999) Urban air quality. Atmos Environ 33(29): 4877–4900
Finnigan JJ (2000) Turbulence in plant canopies. Annu Rev Fluid Mech 32: 519–571
Getachew D, Minkowycz WJ, Lage JL (2000) A modified form of the k–\({\varepsilon}\) model for turbulent flows of an incompressible fluid in porous media. Int J Heat Mass Transf 43(16): 2909–2915
Hang J, Sandberg M, Li YG (2009) Effect of urban morphology on wind condition in idealized city models. Atmos Environ 43(4): 869–878
Hanna SR, Tehranian S, Carissimo B, Macdonald RW, Lohner R (2002) Comparisons of model simulations with observations of mean flow and turbulence within simple obstacle. Atmos Environ 36(32): 5067–5079
Kanda M (2006) Large-eddy simulations on the effects of surface geometry of building arrays on turbulent organized structures. Boundary-Layer Meteorol 118(1): 151–168
Kuwahara F, Yamane I, Nakayama A (2006) Large eddy simulation of turbulent flow in porous media. Int Commun Heat Mass Transf 33(4): 411–418
Li Y, Stathopoulos T (1997) Numerical evaluation of wind-induced dispersion of pollutants around a building. J Wind Eng Ind Aerodyn 67: 757–766
Li XX, Liu CH, Leung DYC (2009) Numerical investigation of pollutant transport characteristics inside deep urban street canyons. Atmos Environ 43: 2410–2418
Lien FS, Yee E (2004) Numerical modelling of the turbulent flow developing within and over a 3-D building array, part I: a high-resolution Reynolds-averaged Navier–Stokes approach. Boundary-Layer Meteorol 112(3): 427–466
Lien FS, Yee E (2005) Numerical modelling of the turbulent flow developing within and over a 3-D building array, part III: a distributed drag force approach, its implementation and application. Boundary-Layer Meteorol 14(2): 287–313
Lien FS, Yee E, Wilson JD (2005) Numerical modelling of the turbulent flow developing within and over a 3-d building array, part II: mathematical formulation for a distributed drag force approach. Boundary-Layer Meteorol 114(2): 245–285
Liu HP, Zhang BY, Sang JG, Cheng AYS (2001) A laboratory simulation of plume dispersion in stratified atmospheres over complex terrain. J Wind Eng Ind Aerodyn 89(1): 1–15
Liu CH, Leung DYC, Barth MC (2005) On the prediction of air and pollutant exchange rates in street canyons of different aspect ratios using large-eddy simulation. Atmos Environ 39(9): 1567–1574
Martilli A, Santiago JL (2007) CFD simulation of airflow over a regular array of cubes. Part II: analysis of spatial average properties. Boundary-Layer Meteorol 122(3): 635–654
Meroney RN, Pavegeau M, Rafailidis S, Schatzmann M (1996) Study of line source characteristics for 2-D physical modelling of pollutant dispersion in street canyons. J Wind Eng Ind Aerodyn 62(1): 37–56
Nakayama A, Kuwahara F (1999) A macroscopic turbulence model for flow in a porous medium. J Fluid Eng-T ASME 121(2): 427–433
Neale G, Nader W (1974) Practical significance of Brinkman’s extension of Darcy’s law: coupled parallel flows within a channel and a bounding porous medium. Can J Chem Eng 52(4): 475–478
Oke TR (1988) Street design and urban canopy layer climate. Energy Build 11(1–3): 103–113
Pedras MHJ, de Lemos MJS (2000) On the definition of turbulent kinetic energy for flow in porous media. Int Commun Heat Mass Transf 27(2): 211–220
Pedras MHJ, de Lemos MJS (2001) Macroscopic turbulence modelling for incompressible flow through undeformable porous media. Int J Heat Mass Transf 44(6): 1081–1093
Prakash M, Turan OF, Li YG, Mahoney J, Thorpe GR (2001a) Impinging round jet studies in a cylindrical enclosure with and without a porous layer: part I–flow visualizations and simulations. Chem Eng Sci 56(12): 3855–3878
Prakash M, Turan OF, Li YG, Mahoney J, Thorpe GR (2001b) Impinging round jet studies in a cylindrical enclosure with and without a porous layer: part II—LDV measurements and simulations. Chem Eng Sci 56(12): 3879–3892
Santiago JL, Martilli A, Martin F (2007) CFD simulation of airflow over a regular array of cubes. Part I: Three-dimensional simulation of the flow and validation with wind-tunnel measurements. Boundary-Layer Meteorol 122(3): 609–634
Santiago JL, Coceal O, Martilli A, Belcher SE (2008) Variation of the sectional drag coefficient of a group of buildings with packing density. Boundary-Layer Meteorol 128(3): 445–457
Silva RA, de Lemos MJS (2003) Turbulent flow in a channel occupied by a porous layer considering the stress jump at the interface. Int J Heat Mass Transf 46(26): 5113–5121
Sini JF, Anquetin S, Mestayer PG (1996) Pollutant dispersion and thermal effects in urban street canyons. Atmos Environ 30(15): 2659–2677
Tong H, Walton A, Sang JG, Chan JCL (2005) Numerical simulation of the urban boundary layer over the complex terrain of Hong Kong. Atmos Environ 39(19): 3549–3563
Xie XM, Huang Z, Wang J (2006) The impact of urban street layout on local atmospheric environment. Build Environ 41(10): 1352–1363
Acknowledgements
The study is supported by a grant from the Research Grants Council of the Hong Kong SAR Government (Project No. HKU 7145/07E).
Open Access
This article is distributed under the terms of the Creative Commons Attribution Noncommercial License which permits any noncommercial use, distribution, and reproduction in any medium, provided the original author(s) and source are credited.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
Open Access This is an open access article distributed under the terms of the Creative Commons Attribution Noncommercial License (https://creativecommons.org/licenses/by-nc/2.0), which permits any noncommercial use, distribution, and reproduction in any medium, provided the original author(s) and source are credited.
About this article
Cite this article
Hang, J., Li, Y. Wind Conditions in Idealized Building Clusters: Macroscopic Simulations Using a Porous Turbulence Model. Boundary-Layer Meteorol 136, 129–159 (2010). https://doi.org/10.1007/s10546-010-9490-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10546-010-9490-3