Abstract
Flow device analyses and micromanipulation were used to assess the adhesive and cohesive integrity of the immobilised bacterial populations (biomass) of Pseudomonas fluorescens, which were harvested at different growth times and applied to a substrate made of stainless steel subsequently accommodated in a specially designed flow chamber. After the biomass was exposed to a fluidic environment for a period of time, the biomass samples were removed from the flow chamber and the apparent adhesion and cohesion of the remaining biomass was measured using a micromanipulation technique. The surface area of the substrate covered by the biomass exposed to the fluid flow was monitored by a digital camera and then quantified by image analysis. The results indicate a strong correlation between micromanipulation measurements and flow chamber experiments. The micromanipulation data show that the apparent adhesive strength of the biomass increased with the growth time. Moreover, the apparent adhesive strength was found to be stronger than the bacterial cohesive strength. The data was used to interpret the removal behaviour of the biomass from the flow chamber. Using these techniques, specific mechanisms of biomass detachment from a surface and optimised cleaning strategies can be postulated.
Similar content being viewed by others
References
Chen MJ, Zhang Z, Bott TR (1998) Direct measurement of the adhesive strength of biofilms in pipes by micromanipulation. Biotechnol Techn 12:875–880
Chen MJ, Zhang Z, Bott TR (2005) Effects of operating conditions on the adhesive strength of Pseudomonas fluorescens biofilms in tubes. Colloids Surf B Biointerf 43:59–69
Duddridge J, Kent CA, Laws JF (1982) Effects of surface shear stress on the attachment of Pseudomonas fluorescens to stainless steel under defined flow conditions. Biotechnol Bioeng 24:153–164
Heydorn A, Ersboll B, Hentzer M et al (2000) Experimental reproducibility in flow-chamber biofilms. Microbiology 146:2409–2415
Jass J, Lappin-Scott H (1997) Microbial biofilms in industry: wanted dead or alive. Chem Ind 16:682–685
Liu W, Christian GK, Zhang Z, Fryer P (2002) Development and use of a micromanipulation technique for measuring the force required to disrupt and remove fouling deposits. Trans Inst Chem Eng 80:286–291
Liu W, Christian GK, Zhang Z, Fryer P (2006) Direct measurement of the force required to disrupt and remove fouling deposits of whey protein concentrate. Int Diary J 16:164–172
McClaine J, Ford R (2002) Characterizing the adhesion of motile and nonmotile Escherichia coli to glass surface using a parallel-plate flow chamber. Biotechnol Bioeng 78:179–189
Ohashi A, Harada HA (1996) Novel concept for evaluation of biofilm adhesion strength by applying tensile force and shear force. Water Sci Technol 34:201–211
Schmid T, Panne U, Adams J, Nessner R (2004) Investigation of biocide efficacy by photoacoustic biofilm monitoring. Water Res 38:1189–1196
Stoodley P, Lewandowski Z, Boyle J, Lappin-Scott H (1999) Structural deformation of bacterial biofilms caused by short-term fluctuations in fluid shear: an in situ investigation of biofilm rheology. Biotechnol Bioeng 65:83–92
Stoodley P, Hall-Stoodley L, Scott H (2001) Detachment, surface migration, and other dynamic behaviour in bacterial biofilms revealed by digital time-lapse imaging. Methods Enzymol 337:306–319
Stoodley P, Cargo R, Rupp CJ et al (2002) Biofilm material properties as related to shear-induced deformation and detachment phenomena. J Ind Microbiol Biotechnol 29:361–367
Verran J, Jones M (2000) Problems of biofilms in the food and beverage industry. In: Walker J, Surman S, Jass J (eds) Industrial biofouling. John Wiley and Sons Ltd., New York
Acknowledgements
This work was supported the Biotechnology and Biological Sciences Research Council, UK. We would like to thank Dr. M.V. Jones (Unilever R&D Port Sunlight) for providing scientific input throughout this work.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Garrett, T.R., Bhakoo, M. & Zhang, Z. Characterisation of bacterial adhesion and removal in a flow chamber by micromanipulation measurements. Biotechnol Lett 30, 427–433 (2008). https://doi.org/10.1007/s10529-007-9580-6
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10529-007-9580-6