Skip to main content
Log in

Numerical simulation investigation on the seismic performance of high-strength concrete columns reinforced with PVA fibers and HTRB630 steel bars

  • Original Article
  • Published:
Bulletin of Earthquake Engineering Aims and scope Submit manuscript

Abstract

In this article, the seismic performance of PVA fibers and HTRB630 steel bars reinforced with high-strength concrete column specimens (FTRHCs) are investigated numerically. Based on the available experimental data, the fiber model is established considering the bond-slip effect and shear deformation of reinforcements. The numerical simulation and test seismic performance indexes of FTRHCs are compared and analyzed. On this basis, the effect of axial load ratio and shear-to-span ratio on the seismic performance indexes of FTRHCs is further investigated. The results indicate that the hysteresis curves and skeleton curves obtained from the numerical simulation are relatively similar to the test results. The simulated seismic performance indexes are not much different from the test results with a relative error below 15%. As the axial load ratio increases, the bearing capacity and cumulative energy-dissipation of the specimen increase, the displacement ductility decreases, and the stiffness degradation improves little. As the shear-to-span ratio increases, the bearing capacity decreases, the displacement ductility increases, the cumulative energy-dissipation capacity increases, and the stiffness degradation changes little. The seismic performance of FTRHCs improves insignificantly as the PVA fiber volume content increases. It is recommended to use PVA fibers with a volume content of 0.5% in the plastic hinge zone of FTRHCs. The established fiber models are of great practical significance for the application of high-strength concrete members reinforced with fibers and high-strength steel bars in building structures.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15

Similar content being viewed by others

References

  • Dong B, Pan J, Cai J, Zeng H (2020) Experimental study on local compressive behaviour of ECC ring beam connections. Structures 27:2069–2081

    Article  Google Scholar 

  • Engineering Construction Standard Station of Jiangsu Province (2016) Heat treatment technical specification for ribbed high strength reinforced concrete structure: Q/321182. KBC001-2016. Engineering Construction Standard Station of Jiangsu Province, Nanjing

    Google Scholar 

  • Fischer G, Li VC (2002) Effect of matrix ductility on deformation behavior of steel-reinforced ECC flexural members under reversed cyclic loading conditions. ACI Struct J 99(6):781–790

    Google Scholar 

  • Gao L, Sun C, Zhuang ML et al (2022) Fatigue life prediction of HTRB630E steel bars based on modified Coffin-Manson model under pre-strain. Structures 38:28–39

    Article  Google Scholar 

  • Gencturk B, Elnashai AS, Lepech MD et al (2013) Behavior of concrete and ECC structures under simulated earthquake motion. J Struct Eng 139(3):389–399

    Article  Google Scholar 

  • Han Q, Hu M, Xu K, Du X (2019) Hysteretic behavior and modelling of ultra-high-strength steel bar including buckling. Bull Earthq Eng 17(9):5265–5289

    Article  Google Scholar 

  • Ji J, Zhang W, Yuan C et al (2019) Finite element model based test and analysis on ACHC short columns and hoop coefficient. Clust Comput 22:S5333–S5345

    Article  Google Scholar 

  • Kale V, Shelar A, Javanjal V et al (2023) Experimental study on fiber reinforced concrete using PVA fiber and glass powder. Mater Today: Proc. https://doi.org/10.1016/j.matpr.2023.10.155

    Article  Google Scholar 

  • Kolozvari K, Orakcal K, Tran TA et al (2015) Modeling of cyclic shear-flexure interaction in reinforced concrete structural walls. II: experimental validation. J Struct Eng 141(5):04014136

    Article  Google Scholar 

  • Li X, Pan JL, Leung CKY, Yin W et al (2018) Shaking table tests on precast reinforced concrete and engineered cementitious composite/reinforced concrete composite frames. Adv Struct Eng 21(6):824–837

    Article  Google Scholar 

  • Liang XW, Wang YJ, Tao Y et al (2016) Seismic performance of fiber-reinforced concrete interior beam-column joints. Eng Struct 126:432–445

    Article  Google Scholar 

  • Liu BQ, Bai GL, Zhang GJ (2005) An experimental study on the seismic behavior of high strength reinforced concrete frame columns with high axial load ratio. Chin Civ Eng J 38(1):45–50

    CAS  Google Scholar 

  • Lü DG, Li YJ, Wang ZY (2013) Numerical simulation of seismic performance of reinforced concrete columns under biaxial lateral loads. J Southeast Univ 43(2):414–419

    Google Scholar 

  • Mander JB, Priestley MJN, Park R (1988) Theoretical stress–strain model for confined concrete. J Struct Eng 114(8):1804–1826

    Article  Google Scholar 

  • National standards of People’s Republic of China (2017) Steel for the reinforcement of concrete: Part 1: Hot rolled plain bars: GB/T 1499. 1-2017. Standards Press of China, Beijing

    Google Scholar 

  • National standards of People’s Republic of China (2018) Steel for the reinforcement of concrete: Part 2: ribbed bars: GB/T 1499. 2-2018. Standards Press of China, Beijing

    Google Scholar 

  • Ni X, Cao S, Liang S, Li Y, Liu Y (2019) High-strength bar reinforced concrete walls: cyclic loading test and strength prediction. Eng Struct 198:109508

    Article  Google Scholar 

  • Park R (1989) Valuation of ductility of structures and structural assemblages from laboratory testing. Bull N Z Natl Soc Earthq Eng 22(3):155–166

    Google Scholar 

  • Pereira EB, Fischer G, Barros JAO (2012) Effect of hybrid fiber reinforcement on the cracking process in fiber reinforced cementitious composites. Cement Concr Compos 34(10):1114–1123

    Article  CAS  Google Scholar 

  • Shan QF, Pan JL, Chen JH (2015) Mechanical behaviors of steel reinforced ECC/concrete composite columns under combined vertical and horizontal loading. J Southeast Univ 31(02):259–265

    Google Scholar 

  • Spacone E, Filippou FC, Taucer FF (1996) Fibre beam–column model for non-linear analysis of R/C frames: part I. Formulation. Earthq Eng Struct Dynam 25(7):711–725

    Article  Google Scholar 

  • Sun ZG (2012) Research on the seismic deformation capacity of RC bridge columns. China Earthquake Administration, Harbin

    Google Scholar 

  • Sun L, Hao Q, Zhao J et al (2018) Stress strain behavior of hybrid steel-PVA fiber reinforced cementitious composites under uniaxial compression. Constr Build Mater 188:349–360

    Article  CAS  Google Scholar 

  • Sun CZ, Zhuang ML, Dong B (2022) Experimental evaluation of effect factors on seismic performance of concrete columns reinforced with HTRB630 high-strength steel bars. Int J Concrete Struct Mater 16:45

    Article  Google Scholar 

  • Wang XF, Fu JP, Zhu AP (2011) Numerical simulation of seismic behavior of RC columns reinforced with HRB500 steel bars. J Build Eng 32(8):99–105

    CAS  Google Scholar 

  • Xiong ZW (2005) Nonlinear analysis of R/C sections based on MCFT. Chongqing University, Chongqing

    Google Scholar 

  • Zhang YT, Zhao BG, Li RG et al (2016) Monotonic and low cycle fatigue testing and research for HRB400 steel. Eng Mech 33(04):121–129

    CAS  Google Scholar 

  • Zhang JW, Liu J, Li XY et al (2021) Hysteretic behavior of steel fiber-reinforced high-strength concrete columns with high-strength steel bars. Structures 33:1833–1852

    Article  Google Scholar 

  • Zhang Y, Zhang HM, Lu XL (2022) Seismic performance evaluation and experimental validation of steel-fiber-reinforced high-strength-concrete composite shear walls. Structures 35:765–779

    Article  Google Scholar 

  • Zhao J, Sritharan S (2007) Modeling of strain penetration effects in fiber-based analysis of reinforced concrete structures. ACI Struct J 104(2):133–141

    Google Scholar 

  • Zhuang ML, Sun CZ, Gao L et al (2022a) Investigation on drift ratio limits of PVA fiber reinforced concrete columns under different performance levels based on the Kunnath damage model. Case Stud Constr Mater 17:e01403

    Google Scholar 

  • Zhuang ML, Sun CZ, Dong B (2022b) Experimental and numerical investigations on seismic performance of HTRB630 high-strength steel bars reinforced concrete columns. Case Stud Constr Mater 17:e01185

    Google Scholar 

Download references

Funding

This research has been supported by the Natural Science Research Project of Jiangsu Province Colleges and Universities (21KJD560002 and 23KJA560007), China; Research and Innovation Team Project of Suqian College (2021TD04), China; Suqian Sci & Tech Program (H202313), China; Jiangsu Civil Architecture Society project ((2023) No. 4 Item 9), China; the Youth Fund Project of Suqian College (2023XQNA03), China; and the Fifth Provincial Research Funding Project of “333 High-level Talent Training” in 2020 (BRA2020241), China.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Chuanzhi Sun.

Ethics declarations

Conflict of interest

The authors declare that there are no competing interests.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Zhuang, ML., Sun, C., Chen, J. et al. Numerical simulation investigation on the seismic performance of high-strength concrete columns reinforced with PVA fibers and HTRB630 steel bars. Bull Earthquake Eng (2024). https://doi.org/10.1007/s10518-024-01915-y

Download citation

  • Received:

  • Accepted:

  • Published:

  • DOI: https://doi.org/10.1007/s10518-024-01915-y

Keywords

Navigation