Abstract
An experimental study has been conducted on the promotion and control of turbulent thermal mixing of hot and cold airflows in a T-junction with rectangular cross sections, which simulates the HVAC unit for automobile air-conditioning system. In order to promote the turbulent thermal mixing, small jets have been blown into the main channel at the upstream edge of the T-junction in the direction of 45° against the main flow. Turbulence intensity in the upper part of the thermal mixing layer can be increased with these jets, and consequently the turbulent mixing of hot and cold airflows is promoted effectively. Moreover, it has been found that the degree of thermal mixing can be controlled by changing the jet velocity.
Similar content being viewed by others
References
Bruecker, C.: Study of the three-dimensional flow in a T-junction using a dual-scanning method for Three-Dimensional Scanning-Particle-Image-Velocimetry (3-D SPIV). Exp. Therm. Fluid Sci. 14, 35–44 (1997)
Igarashi, M., Tanaka, M., Kawashima, S., Kamide, H.: Experimental study on fluid mixing for evaluation of thermal striping in T-pipe junction. Proc. 10th Int. Conf. Nuclear Eng. ICONE10-22255 (2002)
Kawamura, T., Shiina, K., Ohtsuka, K.M., Tanaka, I., Hirayama, H., Tanimoto, K., Fukuda, T., Sakashita, A., Mizutani, J., Minami, Y., Moriya, S., Madarame, H.: Experimental study on thermal striping in a mixing tee with hot and cold water. Proc. 10th Int. Conf. Nuclear Eng. ICONE10-22214 (2002)
Wu, H.L., Peng, X.F., Chen, T.K.: Influence of sleeve tube on the flow and heat transfer behavior at a T-junction. Int. J. Heat Mass Transfer 46:2637–2644 (2003)
Fukushima, N., Fukagata, K., Kasagi, N., Noguchi, H., Tanimoto, K.: Numerical and Experimental Study on Turbulent Thermal Mixing in a T-junction Flow. Proc. 6th ASME–JSME Joint Thermal Eng. Conf., TED-AJ03-582, in CD-ROM (2003)
Kitada, M., Asano, H., Kanbara, M., Akaike, S.: Development of automotive air-conditioning system basic performance simulator: CFD technique development. JSAE Review 21:91–96 (2000)
Asano, H., Hirota, M., Nakayama, H., Asano, T., Hirayama, S.: Experimental study on turbulent flow and thermal mixing in T-junction modeled after automobile HVAC unit. Proc. ASME Summer Heat Transfer Conf, HT2005-72478, in CD-ROM (2005)
Hirota, M., Asano, H., Nakayama, H., Asano, T., Goto, H., Hirayama, S.: Turbulent thermal mixing of hot and cold airflows in T-junction. Proc. 13th Int. Heat Transfer Conf., TRB-11, in CD-ROM (2006)
Kaehler, C.J., Sammler, B., Kompenhans, J.: Generation and control of tracer particles for optical flow investigation in air. Exp. Fluids 33:736–742 (2002)
Raffel, M., Willert, C., Kompenhans, J.: Particle Image Velocimetry, pp. 129–134. Springer, Berlin (1998)
Scarano, F.: Iterative image deformation methods in PIV. Meas. Sci. Technol. 13:R1–R19 (2002)
Su, L.K., Mungal, M.G.: Simultaneous measurements of scalar and velocity field evolution in turbulent crossflowing jets. J. Fluid Mech. 513:1–45 (2004)
Nakajima, N., Hibara, H., Muramatsu, T., Tanaka, M., Iwamoto, Y., Ochi, J.: Effects of turbulence promoter on flow in T-junction piping system. Proc. Int. Conf. Jets, Wakes and Separated Flows :617–622 (2005)
Muppidi, S., Mahesh, K.: Direct numerical simulation of round turbulent jets in crossflow. J. Fluid Mech. 574:59–84 (2007)
Wegner, B., Huai, Y., Sadiki, A.: Analysis of the turbulent mixing in counterflow and jet in cross-flow configuration. In: Hanjalic, K., Nagano, Y., Tummers, M.J. (eds.) 4th Int. Symp. Turbulence Heat and Mass Transfer, pp. 903–910 (2003)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Hirota, M., Kuroki, M., Nakayama, H. et al. Promotion of Turbulent Thermal Mixing of Hot and Cold Airflows in T-junction. Flow Turbulence Combust 81, 321–336 (2008). https://doi.org/10.1007/s10494-007-9111-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10494-007-9111-5