Skip to main content
Log in

Optimization of synthesis procedures for structured PSA adsorbents

  • Published:
Adsorption Aims and scope Submit manuscript

Abstract

Structured adsorbents in the form of supported thin zeolite films may represent a competitive alternative to traditional zeolite adsorbents in form of beads or pellets used in PSA processes, due to the reduction of mass- and heat-transfer limitations typical of packed beds. Thin NaX films were grown by hydrothermal treatment using a clear solution on cordierite monoliths. Films grown by a multiple synthesis procedure were dense and uniform with a very small amount of sediments adjacent to the film, which may be an advantage in PSA applications. The CO2 adsorption capacity and the pressure drop for the supported films were compared to those of a packed NaX bed. Although the adsorption capacity of the column filled with the structured adsorbents was 67 times lower than when the column was filled with zeolite beads, the pressure drop was 100 times lower for the structured adsorbent. The adsorption capacity can be increased by increasing the film thickness or the cell density of the monoliths without increasing the pressure drop significantly, indicating the potential advantage of structured adsorbents in PSA processes. Further investigations are needed in order to prove this hypothesis.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Subscribe and save

Springer+ Basic
$34.99 /Month
  • Get 10 units per month
  • Download Article/Chapter or eBook
  • 1 Unit = 1 Article or 1 Chapter
  • Cancel anytime
Subscribe now

Buy Now

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  • Brandani, F., et al.: Adsorption kinetics and dynamic behaviour of a carbon monolith. Adsorption 10, 99–109 (2004)

    Article  CAS  Google Scholar 

  • Chou, C.T., Chen, C.Y.: Carbon dioxide recovery by vacuum swing adsorption. Sep. Purif. Technol. 39, 51–65 (2004)

    Article  CAS  Google Scholar 

  • Chue, K.T., et al.: Comparison of activated carbon and zeolite 13X for CO2 recovery from flue gas by pressure swing adsorption. Ind. Eng. Chem. Res. 34, 591–598 (1995)

    Article  CAS  Google Scholar 

  • Cybulski, A., Moulijn, J.A.: In: Cybulski, A., Moulijn, J.A. (eds.) Structured Catalysts and Reactors. Dekker, New York (1998). Chap. 2

    Google Scholar 

  • Glueckauf, E., Coates, J.I.: Theory of chromatography. Part IV: the influence of incomplete equilibrium on the front boundary of chromatograms and on the effectiveness of separation. J. Chem. Soc. 1315–1321 (1947)

  • Gomes, V.G., Yee, K.W.K.: Pressure swing adsorption for carbon dioxide sequestration from exhaust gases. Sep. Purif. Technol. 28, 161–171 (2002)

    Article  CAS  Google Scholar 

  • Jain, R., et al.: Air separation using monolith adsorbent bed. US Patent 6,231,644 (2001)

  • Lassinantti, M., et al.: Faujasite-type films synthesized by seeding. Microporous Mesoporous Mater. 38, 25–34 (2000)

    Article  CAS  Google Scholar 

  • Lee, L.Y., et al.: Manufacture and characterization of silicalite monoliths. Adsorpt. Sci. Technol. 18, 147–170 (2000)

    Article  CAS  Google Scholar 

  • Li, Y.Y., et al.: Zeolite monoliths for air separation. Part I: Manufacture and characterization. Trans. Inst. Chem. Eng. Part A 76, 921–930 (1998a)

    Article  CAS  Google Scholar 

  • Li, Y.Y., et al.: Zeolite monoliths for air separation. Part II: Oxygen enrichment, pressure drop and pressurization. Trans. Inst. Chem. Eng. Part A 76, 931–941 (1998b)

    Article  CAS  Google Scholar 

  • Li, Y.Y., et al.: The effect of the binder on the manufacture of a 5A monolith. J. Powder Technol. 116, 85–96 (2001)

    Article  CAS  Google Scholar 

  • Öhrman, O., et al.: Synthesis and evaluation of ZSM-5 films on cordierite monoliths. Appl. Catal. A Gen. 270, 193–199 (2004a)

    Article  Google Scholar 

  • Öhrman, O., et al.: ZSM-5 structured catalysts coated with silicalite-1. In: Proceedings of the 14th International Zeolite Conference, Cape Town (2004b)

  • Patton, A., et al.: Use of the linear driving force approximation to guide the design of monolithic adsorbents. Chem. Eng. Res. Design A8 82, 999–1009 (2004)

    Article  CAS  Google Scholar 

  • Reynolds, S.P., et al.: Stripping PSA cycles for CO2 recovery from flue gas at high temperature using a hydrotalcite-like adsorbent. Ind. Eng. Chem. Res. 12, 4278–4294 (2006)

    Article  Google Scholar 

  • Ruthven, D.M.: Principles of Adsorption and Adsorption Processes. Wiley, New York (1984). Chap. 1

    Google Scholar 

  • Todd, R.S.: A theoretical and experimental study of a rapid pressure swing adsorption system for air separation. PhD thesis, Monash University, Australia (2003)

  • Williams, J.L.: Monolith structures, materials, properties and uses. Catal. Today 69, 3–9 (2001)

    Article  CAS  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Alessandra Mosca.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Mosca, A., Hedlund, J., Ridha, F.N. et al. Optimization of synthesis procedures for structured PSA adsorbents. Adsorption 14, 687–693 (2008). https://doi.org/10.1007/s10450-008-9126-9

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10450-008-9126-9

Keywords

Navigation