Abstract
In the present study, flow fields in the three-dimensional, tangentially crossing micro-channels were studied. The effect of the relevant geometrical parameters such as the aspect ratio, contact surface area, surface to volume factor, flow rate and cross angle on the flow turning was reported. When the geometries and the flow conditions of the two crossing channels were the same, the fraction of turning flow was found to be dependent on the aspect ratio of the channel as reported previously in the literature. However, if the configuration and flow conditions of the two channels were different, the results need to be clarified. A parameter of non-dimensionalized surface to volume ratio was devised to characterize the flow turning. And the parameter was tested against its validity using numerical simulation and the available experimental data. The experiments on the crossing angle were conducted to show that larger angle in general yielded higher turning flow ratio. The results are expected to be useful in the passive control of flow in micro-fluidic devices among others.
Similar content being viewed by others
References
Bai TY (2007) A study of geometric effect on the flow-field of three-dimensional tangential microchannels. Thesis, National Cheng Kung University, Taiwan
Beebe DJ, Moore JS, Bauer JM, Yu Q, Liu RH, Devadoss C, Jo BH (2000) Functional hydrogel structures for autonomous flow control inside microfluidic channels. Nature 404:588–590
Chen YT, Lee D (2007) A bonding technique using hydrophilic SU-8. J Micromech Microeng 17:1978–1984
Dittrich PS, Tachikawa K, Manz A (2006) Micro total analysis systems. Latest advancements and trends. Anal Chem 76:3887–3907
Duffy DC, Schueller OJA, Brittan ST, Whitesides GM (1999) Rapid prototyping of microfluidic switches in poly(dimethylsiloxane) and their actuation by electro-osmotic flow. J Micromech Microeng 9:211–217
Hardt S, Drese KS, Hessel V, Schonfeld F (2005) Passive micromixers for applications in the microreactor and μTAS field. Microfluid Nanofluid 1:108–118
Ismagilov RF, Rosmarin D, Kenis PJA, Chiu DT, Zhang W, Stone HA, Whitesides GM (2001) Pressure-driven laminar flow in tangential microchannels: an elastomeric microfluidic switch. Anal Chem 73:4682–4687
Karniadakis G, Beskok A, Aluru N (2005) Microflows and nanoflows. Springer, New York
Kim JH, Na KH, Kang CJ, Jeon D, Kim YS (2004) A disposable thermopneumatic-actuated microvalve stacked with PDMS layers and ITO-coated glass. Microelectron Eng 73–74:864–869
Kundu A, Jang JH, Gil JH, Jung CR, Lee HR, Kim SH, Ku B, Oh YS (2007) Micro-fuel cells-current development and applications. J Power Sources 170:67–78
Lee D, Chiu JJ (1992) Computation of physiological bifurcation flows using a patched grid. Comput Fluids 21:519–535
Lee D, Tsuei YM (1992) A formula for estimation of truncation errors of convection terms in a curvilinear coordinate system. J Comput Phys 98:90–100
Lee D, Yeh CL (1993) Computation of reacting flames stabilizer flows using a zonal grid method. Numer Heat Transf Part A 24:273–285
Lin LW (1998) Microscale thermal bubble formation: thermophysical phenomena and applications. Microscale Thermophys Eng 2:71–85
Luque A, Quero JM, Hibert C, Fluckiger P, Ganan-Calvo AM (2005) Integrable silicon microfluidic valve with pneumatic actuation. Sens Actuators A 118:144–151
Nguyen NT, Wu Z (2005) Micromixers—a review. J Micromech Microeng 15:R1–R16
Ottino JM, Wiggins S (2004) Introduction: mixing in microfluidics. Philos Trans R Soc Lond A 362:923–935
Schumann CA, Dittrich PS, Franzke J, Manz A (2007) Towards multi dimensional chemical manipulation of living cells: chemotaxis analysis of social amoebae. In: Proceedings of 11th international conference on miniaturized systems for chemistry and life sciences (MicroTAS2007), pp 766–768
Stone HA, Stroock AD, Ajdari A (2004) Engineering flows in small devices: microfluidics toward a lab-on-a-chip. Annu Rev Fluid Mech 36:381–411
Wang L, Yang JT, Lyu PC (2007) An overlapping crisscross micromixer. Chem Eng Sci 62:711–720
Weibel DB, Kruithof M, Potenta S, Sia SK, Lee A, Whiteside GM (2005) Torque-actuated valves for microfluidics. Anal Chem 77:4726–4733
White FM (2006) Viscous fluid flow, 3rd edn, McGraw Hill, New York
Xia HM, Shu C, Wan SYM, Chew YT (2006) Influence of the Reynolds number on chaotic mixing in a spatially periodic micromixer and its characterization using dynamical system techniques. J Micromech Microeng 16:53–61
Acknowledgments
This study was partially sponsored by the National Science Council of Taiwan under the grant NSC 96-2221-E-006-299.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Lee, D., Chen, YT. & Bai, TY. A study of flows in tangentially crossing micro-channels. Microfluid Nanofluid 7, 169–179 (2009). https://doi.org/10.1007/s10404-008-0370-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10404-008-0370-9