Skip to main content
Log in

Influence mechanism of additives on the crystal structure and desulfurization performance of magnesium slag

  • ORIGINAL ARTICLE
  • Published:
Journal of Material Cycles and Waste Management Aims and scope Submit manuscript

Abstract

In this thesis, three additives, BaO, B2O3 and P2O5, were added to modify the original magnesium slag in the process of quenching hydration of magnesium slag. The crystal phase composition, crystal structure parameters and crystal morphology of different modified magnesium slags were studied by various characterization analysis methods. Combined with the corresponding calcium conversion rate of the samples, the influence mechanism of different additive modification conditions on the desulfurization performance of magnesium slag was obtained. The results showed that the incorporation of BaO, B2O3 and P2O5 could inhibit the nucleation of γ-C2S and prevented the crystal phase transformation of β-C2S during cooling, thus increasing the content of β-C2S with high activity. Among them, MS-950–4% BaO desulfurizer had the best adsorption effect. The β-C2S content, lattice distortion and calcium conversion rate of the samples were 49.6%, 0.057% and 29.8%. The higher activity of β-C2S could generate C–S–H through hydration and then enhanced the physical adsorption capacity of magnesium slag; the increase in crystal structure defects could enhance the chemical adsorption capacity of magnesium slag, so as to improve the overall adsorption capacity of magnesium slag, and then improved the desulfurization performance of magnesium slag. The influence of chemical adsorption capacity on desulfurization performance was greater than that of physical adsorption capacity.

Graphical abstract

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14

Similar content being viewed by others

References

  1. de Correia NS, Caldas RCS, Oluremi JR (2020) Feasibility of using CDW fine fraction and bentonite mixtures as alternative landfill barrier material. J Mater Cycles Waste Manag 22:1877–1886. https://doi.org/10.1007/s10163-020-01075-6

    Article  Google Scholar 

  2. Song Z, Zeng J, Wang C et al (2020) Application and mechanism of an ore-washing sludge in the remediation of chromium (III) and copper (II)-contaminated soils. J Mater Cycles Waste Manag 22:897–906. https://doi.org/10.1007/s10163-020-00980-0

    Article  Google Scholar 

  3. Pantazopoulou E, Ntinoudi E, Zouboulis AI et al (2020) Heavy metal stabilization of industrial solid wastes using low-grade magnesia, Portland and magnesia cements. J Mater Cycles Waste Manag 22:975–985. https://doi.org/10.1007/s10163-020-00985-9

    Article  Google Scholar 

  4. Nguyen H, Moghadam MJ, Moayedi H (2019) Agricultural wastes preparation, management, and applications in civil engineering: a review. J Mater Cycles Waste Manag 21:1039–1051. https://doi.org/10.1007/s10163-019-00872-y

    Article  Google Scholar 

  5. Rahman MT, Kameda T, Miura T et al (2019) Removal of Mn and Cd contained in mine wastewater by Mg-Al-layered double hydroxides. J Mater Cycles Waste Manag 21:1232–1241. https://doi.org/10.1007/s10163-019-00875-9

    Article  Google Scholar 

  6. Lee S, Lee M-G, Park J (2018) Catalytic upgrading pyrolysis of pine sawdust for bio-oil with metal oxides. J Mater Cycles Waste Manag 20:1553–1561. https://doi.org/10.1007/s10163-018-0716-7

    Article  Google Scholar 

  7. Li H, Huang Y, Yang X et al (2018) Approach to the management of magnesium slag via the production of Portland cement clinker. J Mater Cycles Waste Manag 20:1701–1709. https://doi.org/10.1007/s10163-018-0735-4

    Article  Google Scholar 

  8. Sun Y, Meng Y, Guo X et al (2016) Study of nitrogen oxide absorption in the calcium sulfite slurry. J Mater Cycles Waste Manag 18:618–624. https://doi.org/10.1007/s10163-016-0526-8

    Article  Google Scholar 

  9. Mao L, Cui H, Miao C et al (2016) Preparation of MgCr2O4 from waste tannery solution and effect of sulfate, chloride, and calcium on leachability of chromium. J Mater Cycles Waste Manag 18:573–581. https://doi.org/10.1007/s10163-015-0354-2

    Article  Google Scholar 

  10. Ren Y, Kang S, Zhu J (2015) Mechanochemical degradation of hexachlorobenzene using Mg/Al2O3 as additive. J Mater Cycles Waste Manag 17:607–615. https://doi.org/10.1007/s10163-015-0398-3

    Article  Google Scholar 

  11. Cabrera-Real H, Romero-Serrano A, Zeifert B et al (2012) Effect of MgO and CaO/SiO2 on the immobilization of chromium in synthetic slags. J Mater Cycles Waste Manag 14:317–324. https://doi.org/10.1007/s10163-012-0072-y

    Article  Google Scholar 

  12. Hong MH, Joo SY, Kim S et al (2020) Asbestos-containing waste detoxification by a microwave heat treatment using silicon carbide as an inorganic heating element. J Mater Cycles Waste Manag 22:826–835. https://doi.org/10.1007/s10163-020-00977-9

    Article  Google Scholar 

  13. Ha S, Lee JW, Choi S-H et al (2019) Calcination characteristics of oyster shells and their comparison with limestone from the perspective of waste recycling. J Mater Cycles Waste Manag 21:1075–1084. https://doi.org/10.1007/s10163-019-00860-2

    Article  Google Scholar 

  14. Back S-K, Mojammal AHM, Jo H-H et al (2019) Increasing seawater alkalinity using fly ash to restore the pH and the effect of temperature on seawater flue gas desulfurization. J Mater Cycles Waste Manag 21:962–973. https://doi.org/10.1007/s10163-019-00852-2

    Article  Google Scholar 

  15. Kwak YH, Lee YM, Bae WK et al (2011) Absorption behavior of chlorine and sulfur by Ca(OH)2 under simulated conditions with a fluidized bed combustor. J Mater Cycles Waste Manag 13:314–320. https://doi.org/10.1007/s10163-011-0030-0

    Article  Google Scholar 

  16. Moni SMFK, Ikeora O, Pritzel C et al (2020) Preparation and properties of fly ash-based geopolymer concrete with alkaline waste water obtained from foundry sand regeneration process. J Mater Cycles Waste Manag 22:1434–1443. https://doi.org/10.1007/s10163-020-01032-3

    Article  Google Scholar 

  17. Jia L, Fan B, Huo R et al (2018) Study on quenching hydration reaction kinetics and desulfurization characteristics of magnesium slag. J Clean Prod 190:12–23. https://doi.org/10.1016/j.jclepro.2018.04.150

    Article  Google Scholar 

  18. Tang Y, Xin X, Shih K, Wang Z (2018) Effect of crystal size on zinc stabilization in aluminum-rich ceramic matrix. J Mater Cycles Waste Manag 20:2110–2116. https://doi.org/10.1007/s10163-018-0765-y

    Article  Google Scholar 

  19. Zhou X, Zhang T, Wan S et al (2020) Immobilizatiaon of heavy metals in municipal solid waste incineration fly ash with red mud-coal gangue. J Mater Cycles Waste Manag 22:1953–1964. https://doi.org/10.1007/s10163-020-01082-7

    Article  Google Scholar 

  20. Fan B, Jia L, Li B et al (2018) Study on desulfurization performances of magnesium slag with different hydration modification. J Mater Cycles Waste Manag 20:1771–1780. https://doi.org/10.1007/s10163-018-0744-3

    Article  Google Scholar 

  21. Fan B, Jia L, Han F et al (2019) Study on magnesium slag desulfurizer modified by additives in quenching hydration. J Mater Cycles Waste Manag 21:1211–1223. https://doi.org/10.1007/s10163-019-00877-7

    Article  Google Scholar 

  22. Wang W, Li G, Zhou L, Ren C (2019) Thermodynamic data calculation for iron phases in sulfoaluminate cementitious materials prepared using solid wastes. Chinese J Chem Eng 27:2989–2993. https://doi.org/10.1016/j.cjche.2019.01.010

    Article  Google Scholar 

  23. Lu L, Li C, Zhang G et al (2018) Decomposition behavior of CaSO4 during potassium extraction from a potash feldspar-CaSO4 binary system by calcination. Chinese J Chem Eng 26:838–844. https://doi.org/10.1016/j.cjche.2017.10.001

    Article  Google Scholar 

  24. Jia L, Fan B, Li B et al (2018) Effects of pyrolysis mode and particle size on the microscopic characteristics and mercury adsorption characteristics of biomass char. Bio Res 13:5450–5471

    Google Scholar 

  25. Jia L, Fan B, Yao Y et al (2018) Study on the elemental mercury adsorption characteristics and mechanism of iron-based modified biochar materials. Energy Fuels 32:12554–12566. https://doi.org/10.1021/acs.energyfuels.8b02890

    Article  Google Scholar 

  26. Liu S, Lin W, Zhao Y et al (2020) Effect of silicon addition on the microstructures, mechanical properties and helium irradiation resistance of NiCoCr-based medium-entropy alloys. J Alloys Compd. https://doi.org/10.1016/j.jallcom.2020.156162

    Article  Google Scholar 

  27. Chorghe D, Sari MA, Chellam S (2017) Boron removal from hydraulic fracturing wastewater by aluminum and iron coagulation: mechanisms and limitations. Water Res 126:481–487. https://doi.org/10.1016/j.watres.2017.09.057

    Article  Google Scholar 

  28. Jia L, Fan B, Zheng X et al (2020) Mercury emission and adsorption characteristics of fly ash in PC and CFB boilers. Front Energy. https://doi.org/10.1007/s11708-020-0682-3

    Article  Google Scholar 

  29. Wan C, Liu M, He P et al (2020) A novel reactive flame retardant for cotton fabric based on a thiourea-phosphoric acid polymer. Ind Crops Prod. https://doi.org/10.1016/j.indcrop.2020.112625

    Article  Google Scholar 

  30. Shi J, Zhang T, Sun B et al (2020) Isothermal oxidation and TGO growth behavior of NiCoCrAlY-YSZ thermal barrier coatings on a Ni-based superalloy. J Alloys Compd. https://doi.org/10.1016/j.jallcom.2020.156093

    Article  Google Scholar 

  31. Borik MA, Gerasimov MV, Kulebyakin AV et al (2020) Structure and phase transformations in scandia, yttria, ytterbia and ceria-doped zirconia-based solid solutions during directional melt crystallization. J Alloys Compd. https://doi.org/10.1016/j.jallcom.2020.156040

    Article  Google Scholar 

  32. Al-Gunaid MQA, Somesh TE, Gayitri HM et al (2019) Optimized nano-perovskite lanthanum cuprate decorated PVA based solid polymer electrolyte. Polym Technol Mater. https://doi.org/10.1080/25740881.2019.1634729

    Article  Google Scholar 

  33. Zhang J-H, Xie S-M, Zi M, Yuan L-M (2020) Recent advances of application of porous molecular cages for enantioselective recognition and separation. J Sep Sci 43:134–149. https://doi.org/10.1002/jssc.201900762

    Article  Google Scholar 

Download references

Acknowledgements

The authors acknowledge the financial support for this work provided by National Natural Science Foundation of China (No. U1510135), National Natural Science Foundation of China (No. U1810126), National Natural Science Foundation of China (No. U1910214), Shanxi Province Science and Technology Innovation Project of Colleges and Universities (No. 2020L0073).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Yan Jin.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Jia, L., Han, F., Li, Zp. et al. Influence mechanism of additives on the crystal structure and desulfurization performance of magnesium slag. J Mater Cycles Waste Manag 23, 1114–1125 (2021). https://doi.org/10.1007/s10163-021-01200-z

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10163-021-01200-z

Keywords

Navigation