Skip to main content
Log in

Advanced combustion methods for simultaneous reduction of emissions and fuel consumption of compression ignition engines

  • Original paper
  • Published:
Clean Technologies and Environmental Policy Aims and scope Submit manuscript

Abstract

In this work, advanced combustion modes i.e. improved low-temperature combustion (LTC) and reactivity controlled compression ignition (RCCI) have been achieved in a diesel engine. LTC mode has been improved using oxidized EGR (OEGR). Studies were carried out for a pre-optimized set of operating parameters of the engine. Reduction in NOx and PM, improved LTC, was achieved with higher OEGR percentages. Higher concentrations of CO2 and lower concentrations of reacting species with increased OEGR created higher ignition delays, and hence, lower PM. Results also showed the importance of catalytic converter in reduction of tail-pipe HC, CO and PM. RCCI has been achieved using fuels with different reactivities. Liquefied petroleum gas (LPG) with low reactivity was inducted along with air, and diesel with high reactivity was injected into the cylinder. Percentage of LPG was varied from 0 to 40 % with step size of 10 %. Results showed that PM, NOx and CO were reduced with increased LPG. Due to the possibility of a minor amount of LPG-air mixture being trapped in crevices during the compression stroke, HC was increased and BTE was decreased with increased LPG percentage. The results indicate that RCCI achieved with lower amount of LPG (~10 %) is more beneficial for the reduction of PM, NOx and CO with acceptable change in values of HC and BTE. A reduction in premixed heat release peak and minor increase in ignition delays were observed with increased LPG percentage. It indicates that LPG slows down the reaction rate during premixed combustion.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10

Similar content being viewed by others

References

  • Amann CA (1980) Control of the homogeneous–charge passenger–car engine—defining the problem. SAE-801440

  • Asad U, Zheng M (2008) EGR oxidation and catalytic fuel reforming for diesel engines. ASME ICE; ICES2008–1684

  • Asad U, Zheng M, Han X, Reader GT, Wang M (2008) Fuel injection strategies to improve emissions and efficiency of high compression ratio diesel engines. SAE 2008-01-2472

  • Bauner D, Laestadius S, Iida N (2009) Evolving technological systems for diesel engine emission control: balancing GHG and local emissions. Clean Techn Environ Policy 11:339–365

    Article  CAS  Google Scholar 

  • Brijesh P, Sreedhara S (2013) Exhaust emissions and its control methods in compression ignition engines: a review. Int J Automot Technol 14:195–206

    Article  Google Scholar 

  • Brijesh P, Chowdhury A, Sreedhara S (2013) Effect of ultra-cooled EGR and retarded injection timing on low temperature combustion in CI engines. SAE 2013-01-0321

  • Brijesh P, Chowdhury A, Sreedhara S (2014a) Simultaneous reduction of NOx and soot using ultra-cooled EGR and retarded injection timing in a diesel engine. Int J Green Energy. doi:10.1080/15435075.2013.841164

    Google Scholar 

  • Brijesh P, Harshvardhan A, Sreedhara S (2014b) A study of combustion and emissions characteristics of a compression ignition engine processes using a numerical tool. Int J Adv Eng Sci Appl Math 6:17–30

    Article  Google Scholar 

  • Dec JE (2009) Advanced compression ignition engines—understanding the in-cylinder processes. Proc Combust Inst 32:2727–2742

    Article  CAS  Google Scholar 

  • Dec JE, Sjöberg M, Hwang W (2009) Isolating the effects of EGR on HCCI heat-release rates and NOx emissions. SAE 2009-01-2665

  • Dempsey AB, Reitz RD (2011) Computational optimization of reactivity controlled compression ignition in a heavy-duty engine with ultra low compression ratio. SAE 2011-24-0015

  • Ekoto IW, Colban WF, Miles PC, Park SW, Foster DE, Reitz RD, Aronsson U, Andersson O (2009) UHC and CO emissions sources from a light duty diesel engine undergoing dilution controlled low temperature combustion. SAE 2009-24-0043

  • Fernandez JR, Tsolakis A, Cracknell RF, Clark RH (2009) Combining GTL fuel, reformed EGR and HC-SCR after treatment system to reduce diesel NOx emission-A statistical approach. Int J Hydrogen Energy 34:2789–2799

    Article  Google Scholar 

  • Heywood JB (1988) Internal combustion engine fundamentals. McGraw-Hill, New York

    Google Scholar 

  • Hill SC, Smoot LD (2000) Modeling of nitrogen oxides formation and destruction in combustion systems. Prog Energy Combust Sci 26:417–458

    Article  CAS  Google Scholar 

  • Ilyas SZ, Khattak AI, Nasir SM, Qurashi T, Durrani R (2010) Air pollution assessment in urban areas and its impact on human health in the city of Quetta, Pakistan. Clean Technol Environ Policy 12:291–299

    Article  CAS  Google Scholar 

  • Kline SJ, Mcclintock FA (1953) Describing the uncertainties in single sample experiments. Mech Eng 75:3–8

    Google Scholar 

  • Kokjohn SL, Hanson RM, Splitter DA, Reitz RD (2009) Experiments and modeling of dual-fuel HCCI and PCCI combustion using in-cylinder fuel blending. SAE 2009-01-2647

  • Kook S, Bae C, Miles P, Choi D, Pickett LM (2005) The influence of charge dilution and injection timing on low temperature diesel combustion and emissions. SAE 2005-01-3837

  • Lata DB, Misra A, Medhekar S (2011) Investigations on the combustion parameters of a dual fuel diesel engine with hydrogen and LPG as secondary fuels. Int J Hydrogen Energy 36:13808–13819

    Article  CAS  Google Scholar 

  • Maiboom A, Tauzia X, Hetet JF (2008) Influence of high rates of supplemental cooled EGR on NOx and PM emissions of an automotive HSDI diesel engine using an LP EGR loop. Int J Energy Res 32:1383–1398

    Article  CAS  Google Scholar 

  • Nazar J, Ramesh A, Nagalingam B (2006) Studies on dual fuel operation of Karanja oil and its bio-diesel with LPG as the inducted fuel. SAE 2006-01-0237

  • Nieman DE, Dempsey AD, Reitz RD (2012) Heavy-duty RCCI operation using natural gas and diesel. SAE 2012-01-0379

  • Pickett LM, Siebers DL (2004) Soot in diesel fuel jets: effects of ambient temperature, ambient density, and injection pressure. Combust Flame 138:114–135

    Article  CAS  Google Scholar 

  • Pohlkamp K, Reitz R (2012) Reactivity controlled compression ignition (RCCI) in a single-cylinder air-cooled HSDI diesel engine. SAE 2012-32-0074

  • Poonia MP, Ramesh A, Gaur RR (1999) Experimental investigation of the factors affecting the performance of a LPG—diesel dual fuel engine. SAE 1999-01-1123

  • Splitter D, Wissink M, Kokjohn S, Reitz R (2012) Effect of compression ratio and piston geometry on RCCI load limits and efficiency. SAE 2012-01-0383

  • Taniguchi S, Masubuchi M, Kitano K, Mogi K (2012) Feasibility study of exhaust emissions in a natural gas diesel dual fuel (DDF) engine. SAE 2012-01-1649

  • Thompson T, Kimura Y, Durrenberger C, Webb A, Matias AIT, Fraser M, Allen DT (2009) Estimates of the air quality benefits of using natural gas in industrial and transportation applications in Lima, Peru. Clean Technol Environ Policy 11:409–423

    Article  CAS  Google Scholar 

  • Westbrook CK, Dryer FL (1981) Simplified reaction mechanisms for the oxidation of hydrocarbon fuels in flames. Combust Sci Technol 27:31–43

    Article  CAS  Google Scholar 

  • Zheng M, Irick DK, Hodgson J (2002) Stabilizing excessive EGR with an oxidation catalyst on a modern diesel engine. ASME ICE 38: 2002-ICE-455

  • Zheng M, Reader GT, Hawley JG (2004) Diesel engine exhaust gas recirculation—a review on advanced and novel concepts. Energy Convers Manag 45:883–900

    Article  CAS  Google Scholar 

  • Zheng M, Asad U, Kumar R, Reader GT, Mulenga MC, Bombardier W, Wang M, Tjong J (2007) An investigation of EGR treatment on the emissions and operating characteristics of modern diesel engines. SAE 2007-01-1083

Download references

Acknowledgments

The authors gratefully acknowledge the Industrial Research and Consultancy Centre (IRCC), IIT Bombay and Department of Science and Technology (DST), India for funding towards the VCR engine for research work. The authors are also thankful to the Sophisticated Analytical Instrument Facility (SAIF), IIT Bombay for permitting to find the properties of LPG and diesel fuel.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to P. Brijesh.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Brijesh, P., Chowdhury, A. & Sreedhara, S. Advanced combustion methods for simultaneous reduction of emissions and fuel consumption of compression ignition engines. Clean Techn Environ Policy 17, 615–625 (2015). https://doi.org/10.1007/s10098-014-0811-y

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10098-014-0811-y

Keywords

Navigation