Skip to main content
Log in

Mechanical behaviour of MICP-treated silty sand

  • Original Paper
  • Published:
Bulletin of Engineering Geology and the Environment Aims and scope Submit manuscript

Abstract

Most chemical substances utilized in traditional soil improvement methods are environmentally detrimental. As a more ecologically friendly ground improvement method, the microbially induced calcium carbonate precipitation (MICP) technique offers an alternative to most traditional soil improvement methods. The role of bacteria is to produce the urease enzyme to catalyze the hydrolysis of urea. In the presence of calcium ions, the produced carbonate ions in the hydrolysis of urea react with the calcium ions, and calcium carbonate sediment is formed. This paper investigates the effects of this treatment procedure on mechanical behavior change and the microstructure of loose sand and silty sand. To evaluate the influence of treatment, a series of laboratory experiments were conducted, including shear wave velocity, unconfined compressive strength, calcium carbonate content, triaxial shear test, and scanning electron microscopy. The study revealed that this bio-mediated technique causes the improvement of soil strength due to the cementation of sand particles. This method has the potential of making a stable bio-stabilized column of sand and silty sand. Besides, the two-way introduction method is also able to produce a homogeneous bio-cemented soil sample. Results also showed that the increase of cohesion is not significant in the lightly bio-cemented soil samples, but the friction angle increase is notable, especially in biotreated sand. Plus, there is no significant difference between the amounts of calcium carbonate precipitation between sand and silty sand.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18

taken from Disk 1 (0–2.5 cm) of bio-treated sand, a calcium carbonate precipitated on the surface and at contact points, b higher magnification of zone A of the part (a) showing grain bonds and calcite coating, (c) higher magnification of precipitated calcite polymorph

Fig. 19

taken from Disk 2 (2.5–5 cm) of bio-treated sand, a calcium carbonate precipitated on the surface and at contact points, b higher magnification of zone A of the part (a) showing grain bonds, debonding and calcite coating, c higher magnification of precipitated calcite polymorph

Fig. 20

taken from Disk 3 (5–7.5 cm) of bio-treated sand, a calcium carbonate precipitated on the surface and at contact points, b higher magnification of precipitated calcite polymorph

Fig. 21

taken from Disk 4 (7.5–10 cm) of biotreated sand, a calcium carbonate precipitated on the surface and at contact points, b higher magnification of precipitated calcite polymorph

Fig. 22

taken from silty sand a untreated, b to d bio-treated showing calcium carbonate precipitation and bio-cemented silt aggregates

Similar content being viewed by others

References

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Akram Karimian.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Karimian, A., Hassanlourad, M. Mechanical behaviour of MICP-treated silty sand. Bull Eng Geol Environ 81, 285 (2022). https://doi.org/10.1007/s10064-022-02780-2

Download citation

  • Received:

  • Accepted:

  • Published:

  • DOI: https://doi.org/10.1007/s10064-022-02780-2

Keywords

Navigation