A case in which biventricular assist device support was required after aortic valve replacement with a bioprosthetic valve

Abstract

We report the case of a 45-year-old man with severe aortic regurgitation. The patient underwent aortic valve replacement with a bioprosthetic valve, but was unable to be weaned from cardiopulmonary bypass (CPB). Intraoperative coronary angiography revealed stenosis of the right coronary orifice, so an intra-aortic balloon pump was inserted and coronary artery bypass grafting to the right coronary artery was conducted; however, weaning from CPB again failed. Left ventricular assist using a Gyro centrifugal pump was performed between the left atrium and left femoral artery, along with right ventricular assist using a Nikkiso centrifugal pump between the right atrium and pulmonary artery. Flow rates averaged from 2.0 to 2.8 l/min for the left-side ventricular assist device (VAD) and 2.1–3.8 l/min for the right-side VAD. The bypass rate reached approximately 70% at maximum. No thromboembolic events were documented during VAD support. The patient underwent explantation of VADs on postoperative day 4. No thrombus was identified on the bioprosthetic aortic valve by transesophageal echocardiography. The left-side pump displayed no thrombus, while the right-side pump had a small thrombus at the shaft. The patient was discharged from the hospital and was alive as of 2 year postoperatively. To the best of our knowledge, no clinical study has yet compared the antithrombotic properties of two centrifugal pumps in one patient where mechanical support was performed for the same duration and flow rate.