Abstract
A novel electrochemical sensor based on LaNi0.5Ti0.5O3/CoFe2O4 nanoparticle-modified electrode (LNT–CFO/GCE) for sensitive determination of paracetamol (PAR) was presented. Experimental conditions such as the concentration of LNT–CFO, pH value, and applied potential were investigated. Under the optimum conditions, the electrochemical performances of LNT–CFO/GCE have been researched on the oxidation of PAR. The electrochemical behaviors of PAR on LNT–CFO/GCE were investigated by cyclic voltammetry. The results showed that LNT–CFO/GCE exhibited excellent promotion to the oxidation of PAR. The over-potential of PAR decreased significantly on the modified electrode compared with that on bare GCE. Furthermore, the sensor exhibits good reproducibility, stability, and selectivity in PAR determination. Linear response was obtained in the range of 0.5 to 901 μM with a detection limit of 0.19 μM for PAR.
Similar content being viewed by others
References
Willner I, Willner B, Katz E (2007) Biomolecule–nanoparticle hybrid systems for bioelectronic applications. Bioelectrochemistry 70:2–11
Zhang JD, Oyama M (2005) Gold nanoparticle-attached ITO as a biocompatible matrix for myoglobin immobilization: direct electrochemistry and catalysis to hydrogen peroxide. J Electroanal Chem 577:273–279
Feng WY, Xu XH, Wang H, Zhou JT, Yang XN, Zhang Y, Shang SX, Huang BB (2004) Photocatalytic property of perovskite bismuth titanate. Appl Catal B: Environ 52:109–116
Rached H, Rached D, Rabah M, Khenata R, Reshak A (2010) Full-potential calculation of the structural, elastic, electronic and magnetic properties of XFeO3 (X ¼Sr and Ba) perovskite. Physica B 405:3515–3519
Li GB, Liu SX, Liao FH, Tian SJ, Jing XP, Lin JH, Uesu Y, Kohn K, Saitoh K, Terauchi M, Di N, Cheng ZH (2004) The structural and electric properties of the perovskite system BaTiO3–Ba(Fe1/2Ta1/2)O3. J Solid State Chem 177:1695–1703
Liao KF, Chang YS, Chai YL, Tsai YY, Chen HL (2010) Structure and dielectric properties of sodium-doped Ba(FeNb)0.5O3. Mater Sci Eng B 172:300–304
Kim CY, Niihara OSK (2010) Optical, mechanical, and dielectric properties of Bi1/2Na1/2TiO3 thin film synthesized by sol–gel method. J Sol-Gel Sci Technol 55:306–310
Mazaheri M, Akhavan M (2010) Electrical behavior of nano-polycrystalline (La1/y K y )0.7Ba0.3MnO3 manganites. J Magn Magn Mater 322:3255–3261
Bai SL, Luo RX, Shi BJ, Liu ZY, Li DQ (2010) Gas sensing property of MgO modified LaFeO3 nanocomposites. IEEE Sens J 10:1633–1634
Yoon KJ, Cramer CN, Stevenson JW, Marina OA (2010) Advanced ceramic interconnect material for solid oxide fuel cells: electrical and thermal properties of calcium- and nickel-doped yttrium chromites. J Power Sources 195:7587–7593
Ding XF, Kong X, Jiang JG, Cui C, Guo XX (2010) Characterization and V electrochemical performance of (Ba0.6Sr0.4)1−x La x Co0.6Fe0.4O3−δ (x = 0, 0.1) cathode for intermediate temperature solid oxide fuel cells. Mater Res Bull 1272:1271–1277
Zhao F, Wang SW, Kyle B, Chen FL (2010) Layered perovskite PrBa0.5Sr0.5Co2O5+δ as high performance cathode for solid oxide fuel cells using oxide proton-conducting electrolyte. J Power Sources 1955:468–5473
Ding HP, Xue XJ (2010) Novel layered perovskite GdBaCoFeO5Dd as a potential cathode for proton-conducting solid oxide fuel cells international. J Hydrogen Energy 35:4311–4315
Ding HP, Xue XJ (2010) Cobalt-free layered perovskite GdBaFe2O5+x as a novel cathode for intermediate temperature solid oxide fuel cells. J Power Sources 195:4718–4721
Smith EA, Lokuhewa IN, Misture ST, Edwards DD (2010) p-type thermoelectric properties of the oxygen-deficient perovskite Ca2Fe2O5 in the brown millerite structure. J Solid State Chem 183:1670–1677
Wang Y, Sui Y, Wang XJ, Su WH, Cao WW, Liu XY (2010) Thermoelectric response driven by spin-state transition in La1−x Ce x CoO3 perovskites. ACS Appl mater interfaces 8:2213–2217
Chen XH, Hu JQ, Chen ZW, Feng XM, Li AQ (2009) Nanoplated bismuth titanate sub-microspheres for protein immobilization and their corresponding direct electrochemistry and electrocatalysis. Biosens Bioelectron 24:3448–3454
Wang GL, Bao YY, Tian YM, Xia J, Cao DX (2010) Electrocatalytic activity of perovskite La1−x Sr x MnO3 towards hydrogen peroxide reduction in alkaline medium. J Power Sources 195:6463–6467
Dam TVA, Olthuis W, Bergveld P (2004) Sensing properties of perovskite oxide La0.5Sr0.5CoO3−δ obtained by using pulsed laser deposition. Sens Actuators B 103:165–168
Safavi A, Maleki N, Moradlou O (2008) A selective and sensitive method for simultaneous determination of traces of paracetamol and p-aminophenol in pharmaceuticals using carbon ionic liquid electrode. Electroanalysis 19:2158–2162
Goyal RN, Gupta VK, Oyama M, Bachheti N (2005) Differential pulse voltammetric determination of paracetamol at nanogold modified indium tin oxide electrode. Electrochem Commun 7:803–807
Kachoosangi RT, Wildgoose GG, Compton RG (2008) Sensitive adsorptive stripping voltammetric determination of paracetamol at multiwalled carbon nanotube modified basal plane pyrolytic graphite electrode. Anal Chimi Acta 618:54–60
Lourenc BC, Medeirosb RA, Rocha RCF, Mazoa LH, Fatibello OF (2009) Simultaneous voltammetric determination of paracetamol and caffeine in pharmaceutical formulations using a boron-doped diamond electrode. Talanta 78:748–752
Lohmann W, Karst U (2006) Simulation of the detoxification of paracetamol using on-line electrochemistry/liquid chromatography/mass spectrometry. Anal Bioanal Chem 386:1701–1708
Knochen M, Giglio J, Reis BF (2003) Flow-injection spectrophotometric determination of paracetamol in tablets and oral solutions. J Pharm Biomed Anal 33:191–197
Easwaramoorthy D, Yu YC, Huang HJ (2001) Chemiluminescence detection of paracetamol by a luminol-permanganate based reaction. Anal Chimi Acta 439:95–100
Reddy TM, Balaji K, Reddy SJ (2007) Voltammetric behavior of some fluorinated quinolone antibacterial agents and their differential pulse voltammetric determination in drug formulations and urine samples using ab-cyclodextrin-modified carbon-paste electrode. J Anal Chem 2:168–175
Babaei A, Afrasiabi M, Babazadeh M (2010) A glassy carbon electrode modified with multiwalled carbon nanotube/chitosan composite as a new sensor for simultaneous determination of acetaminophen and mefenamic acid in pharmaceutical preparations and biological samples. Electroanalysis 15:1743–1749
Li Y, Umasankar Y, Chen SM (2009) Polyaniline and poly(flavin adenine dinucleotide) doped multi-walled carbon nanotubes for p-acetamidophenol sensor. Talanta 79:486–492
Wang SF, Xie F, Hu RF (2007) Carbon-coated nickel magnetic nanoparticles modified electrodes as a sensor for determination of acetaminophen. Sens Actuators B 123:495–500
Kang XH, Wang J, Wu H, Liu J, Aksay IA, Lin YH (2010) A graphene-based electrochemical sensor for sensitive detection of paracetamol. Talanta 81:754–759
Li F, Liu JJ, Evans DG, Duan X (2004) Stoichiometric synthesis of pure MFe2O4 (M = Mg, Co, and Ni) spinel ferrites from tailored layered double hydroxide (hydrotalcite-like) precursors. Chem Mater 16:1597–1602
Wang YL, Xu YH, Luo LQ, Ding YP, Liu XJ (2010) Preparation of perovskite-type composite oxide LaNi0.5Ti0.5O3–NiFe2O4 and its application in glucose biosensor. J Electroanal Chem 642:35–40
Nematollahi D, Shayani-Jama H, Alimoradi M, Niroomand S (2009) Electrochemical oxidation of acetaminophen in aqueous solutions: kinetic evaluation of hydrolysis, hydroxylation and dimerization processes. Electrochimi Acta 54:7407–7415
Falcon H, Carbonio RE, Fierro JLG (2001) Correlation of oxidation states in LaFe x Ni1−x O3+δ oxides with catalytic activity for H2O2 decomposition. J Catalysis 203:264–272
Fabiana SF, Christopher MA, Brett LA (2007) Carbon film resistor electrode for amperometric determination of acetaminophen in pharmaceutical formulations. J Pharm Biomed Anal 43:1622–1627
Liu XJ, Luo LQ, Ding YP, Xu YH (2011) Amperometric biosensors based on alumina nanoparticles–chitosan–horseradish peroxidase nanobiocomposites for the determination of phenolic compounds. Analyst 136:696–701
Shan D, Wang SX, He YY, Xue HG (2008) Amperometric glucose biosensor based on in situ electropolymerized polyaniline/poly(acrylonitrile-co-acrylic acid) composite film. Mater Sci Eng C 28:213–217
Maria DPTS, Anderson S, Marcos RVL, Auro AT, Lauro TK (2008) Construction and application of an electrochemical sensor for paracetamol determination based on iron tetrapyridinoporphyrazine as a biomimetic catalyst of P450 enzyme. J Braz Chem Soc 19:734–743
Mariana CQO, Marcos RVL, Auro AT, Maria DPTS (2010) Flow injection analysis of paracetamol using a biomimetic sensor as a sensitive and selective amperometric detector. Anal Methods 2:507–512
Zhang Y, Luo LQ, Ding YP, Liu X, Qian ZY (2010) A highly sensitive method for determination of paracetamol by adsorptive stripping voltammetry using a carbon paste electrode modified with nanogold and glutamic acid. Microchim Acta 171:133–138
Acknowledgement
This research is supported by the National Natural Science Foundation of China (No. 20975066, 41140031, 20975066) and the Nano-Foundation of Science and Techniques Commission of Shanghai Municipality (No.0952 nm01500), Leading Academic Discipline Project of Shanghai Municipal Education Commission (J50102), and the Ph.D. Innovation Foundation of Shanghai University (No. SHUCX091030). We are grateful to the assistance of Dr. Galina Tsirlina in analysis of XRD and mechanism.
Author information
Authors and Affiliations
Corresponding author
Electronic supplementary material
Below is the link to the electronic supplementary material.
ESM Fig. S1
(PDF 151 kb)
Rights and permissions
About this article
Cite this article
Ye, D., Xu, Y., Luo, L. et al. LaNi0.5Ti0.5O3/CoFe2O4-based sensor for sensitive determination of paracetamol. J Solid State Electrochem 16, 1635–1642 (2012). https://doi.org/10.1007/s10008-011-1568-4
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10008-011-1568-4