Mesoscale Convective System over the Yellow Sea – A Numerical Case Study

Summary

 A mesoscale convective system (MCS) case that developed over the Yellow Sea (12–13 July 1993) is studied by using a 23-level, 30 km-mesh Penn State/NCAR mesoscale model MM5. This MCS was generated in northern China, south of the Changma front, in a convectively unstable environment, under the influence of a short-wave trough accompanied by a marked cold vortex aloft.

The model with all model physics (refereed to as CNTL) captured the major features of this MCS. A mesoscale low-level jet (mLLJ), with a horizontal scale of a few hundred km, developed within the MCS. Available wind data support the realism of this mLLJ. This mLLJ not only transports convectively unstable air directly toward the MCS but is also responsible for a strong low-level convergence in the MCS. At 200 hPa, an anticyclonic northwesterly flow with a relatively high wind speed core on the east of MCS was simulated. This relatively high-speed flow can be regarded as a mesoscale upper level jet (mULJ), acted as an upper outflow over the MCS. Low-level convergence on the left-front of the mLLJ and upper divergence in the right-rear of the mULJ creates a strong upward motion (≅ 40 cm s⁻¹) in the MCS.

Heavy precipitation up to 45 mm between 1800–2100 UTC was observed after this MCS landed on the southern Korean Peninsula. The CNTL run captured this heavy rainfall event. A maximum rainfall of 50 mm 3 h⁻¹ was simulated. In another experiment, with surface sensible and moisture fluxes withheld (NOSF), the 3-h simulated rainfall was decreased to 30 mm. Less latent heat released in the NOSF led to a weaker MCS and mLLJ. The concurrent surface fluxes sustained a high low-level moisture field over the Yellow Sea, which helped the development of the MCS and enhanced its precipitation in this case.