Abstract
Water ingress represents one of the main challenges in subsea tunnelling, particularly when this occurs in sections with poor rock mass quality. This paper is discussing the main characteristics of water ingress in subsea hard rock tunnels based on the experience from almost 50 such tunnels that have been built in Norway. Following a brief description of the geological conditions and the basic design of the subsea tunnels, pre-construction investigations and investigations during excavation are discussed with particular emphasis on prediction of water ingress. Two cases with particularly difficult conditions; the Bjorøy tunnel and the Atlantic Ocean tunnel, are discussed in detail. In these cases, large water inflow with pressure of up to 2.4 MPa was encountered at major faults/weakness zones during excavation, and special procedures were required to cope with the problems. Based on the experience from the Norwegian projects, it is concluded that continuous follow-up by experienced engineering geologists, probe drilling with the drilling jumbo and pre-grouting where required are the most important factors for coping with water ingress and ensuring stability.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Barton N (2002) Some new Q-value correlations to assist in site characterization and tunnel design. Int J Rock Mech Min Sci 39(2):185–216
Bollingmo P, Nilsen B, Norgulen Ø (2007) The cave-in at the Hanekleiv tunnel, 25 December 2006. Report from investigation panel established by the Norwegian Department of Transportation, 53 p (in Norwegian)
Dahl Johansen E (1995) Bjorøy subsea road tunnel, tunnelling through a sandy zone. Proceedings of Norwegian tunnelling conference, Oslo 1995 (in Norwegian). Norwegian Tunnelling society (NFF), Oslo, pp 6.1–6.23
Gilje AM (2009) Practical experience from the Finnfast tunnel. Proceedings of Tekna training course on heavy rock support of tunnels and caverns, Sandefjord, Norway, Tekna/NFF (in Norwegian), pp 9.1–9.16
Haug R (1999) The Oslofjord subsea crossing—importance of investigations during excavation in addition to preinvestigations. Proceedings of ITA World tunnel Congress, Workshop Strait Crossings—Subsea tunnels, Oslo 2009. Tekna/ITA, Oslo, pp 97–102
Høien AH, Nilsen B (2012) Evaluation of drill parameter interpretation in the Løren tunnel, focusing on water and rock mass grouting. Rock Mech Rock Eng (submitted)
Karlsson KI (2008) Highway 64, the Atlantic ocean tunnel—leakage zone 230 m below sea level. Proceedings of Norwegian tunnelling conference, Oslo 2008 (in Norwegian). Norwegian Tunnelling society (NFF), Oslo, pp 11.1–11.16
Lien JE (2000) The Frøya tunnel—from geological mapping to completed tunnel. Proceedings of Norwegian tunnelling conference, Oslo 2000 (in Norwegian). Norwegian Tunnelling society (NFF), Oslo, pp 6.1–6.46
Melby K, Øvstedal E (1999) Daily life of subsea rock tunnels—construction, operation and maintenance. Proceedings of ITA World tunnel Congress, Workshop Strait Crossings—Subsea tunnels, Oslo 2009. Tekna/ITA, Oslo, pp 14–27
Melby K, Øvstedal E, Amundsen FH, Ranes G (2002) Subsea road tunnels in Norway. Publication no. 98, Directorate of Public Roads, 30 p
Moen PA (2011) Rockma—use of MWD as tool in tunnel production. Norwegian Public Roads Administration. Internal memo, 3 p (in Norwegian)
NFF (2008) Heavy rock support of underground excavations. Handbook no. 5, Norwegian Tunnelling Society, 72 p (in Norwegian)
Nilsen B (2010) Cases of instability caused by weakness zones in Norwegian tunnels. Bull Eng Geol Environ 70:7–13
Nilsen B (2011) Hard rock tunnelling with particular focus on deep subsea tunnels in difficult rock conditions. Proceedings of ESCO-seminar Lectures for New Horizons by eminent Scholars, Seoul 2011, pp 1–25
Nilsen B, Henning JE (2009) Thirty years of experience with subsea tunnels. Proceedings of strait crossings 2009. Tapir, Trondheim, pp 35–44
Nilsen B, Palmstrøm A (2001) Stability and water leakage of hard rock subsea tunnels. In: Modern tunnelling science and technology, proceedings of international symposium IS-Kyoto 2001. Balkema, Rotterdam, pp 497–502
Nilsen B, Palmstrøm A (2009) Engineering geological key factors for planning and constructing hard rock subsea tunnels. Proceedings of strait crossings 2009. Tapir, Trondheim, 403–408
Nilsen B, Palmstrøm C, Stille H (1999) Quality control of a sub-sea tunnel project in complex ground conditions. In: Challenges for the 21st Century, Proceedings of World Tunnel Congress Oslo 1999. Balkema, Rotterdam, pp 137–145
NPRA (2006) Handbook 021: road tunnels. Norwegian Public Roads Administration, Directorate of Public Roads (in Norwegian, 2004-edition in English), 140 p
Olsen A, Blindheim OT (1989) Prevention is better than cure—experience with probe drilling, stability control and pre-grouting in the Ålesund-Giske subsea road tunnels. Tunn Tunn 20(9):41–44
Palmstrøm A, Nilsen B, Pedersen KB, Grundt L (2003) Correct extent of site investigations for underground facilities. Publication no. 101, Directorate of Public Roads (in Norwegian), 116 p
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Nilsen, B. Characteristics of Water Ingress in Norwegian Subsea Tunnels. Rock Mech Rock Eng 47, 933–945 (2014). https://doi.org/10.1007/s00603-012-0300-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00603-012-0300-8