Abstract
Acoustic emissions (AE) and stress–strain curve analysis are well accepted ways of analysing crack propagation and monitoring the various failure stages (such as crack closure, crack initiation level during rock failure under compression) of rocks and rock-like materials. This paper presents details and results of experimental investigations conducted for characterizing the brittle failure processes induced in a rock due to monocyclic uniaxial compression on loading of two types of sandstone core samples saturated in NaCl brines of varying concentration (0, 2, 5, 10 and 15 % NaCl by weight). The two types of sandstone samples were saturated under vacuum for more than 45 days with the respective pore fluid to allow them to interact with the rocks. It was observed that the uniaxial compressive strength and stress–strain behaviour of the rock specimens changed with increasing NaCl concentration in the saturating fluid. The acoustic emission patterns also varied considerably for increasing ionic strength of the saturating brines. These observations can be attributed to the deposition of NaCl crystals in the rock’s pore spaces as well some minor geo-chemical interactions between the rock minerals and the brine. The AE pattern variations could also be partly related to the higher conductivity of the ionic strength of the high-NaCl concentration brine as it is able to transfer more acoustic energy from the cracks to the AE sensors.
Similar content being viewed by others
References
Agustawijaya DS (2001) The development of design criteria for underground excavations in Coober Pedy arid soft rocks. PhD dissertation, University of South Australia
Akai K (1997) Testing methods for indurated soils and soft rocks—Interim report. In: Geotechnical Engineering of hard soils–soft rocks, proceedings of the first international conference on hard soils and soft rocks (3) Balkemam, Rotterdam, pp 1707–1737
Bachu S (2000) Sequestration of carbon dioxide in geological media: criteria and approach for site selection. Energy Conserv Mgmt 41(9):953–970
Bell FG, Culshaw MG (1998) Petrographic and engineering properties of sandstones from the Sneinton formation. Notts Engl Q J Eng Geol 31:5–19
Bishop SR (1997) The experimental investigation of formation damage due to the induced flocculation of clays within a sandstone pore structure by a high salinity brine. In: BP Exploration Source, SPE European Formation Damage Conference, 2–3 June 1997, The Hague, Netherland
Bro A (1996) A weak rock triaxial cell. Int J Rock Mech Min Sci Geomech Abstr 33(1):71–74
Broch E, Franklin JA (1972) The point load strength test. Int J Rock Mech Min Sci Geomech 9(6):669–697
Cai M, Kaiser PK, Morioka H, Minami M, Maejima T, Tasaka Y, Kurose H (2007) FLAC/PFC coupled numerical simulation of AE in large-scale underground excavations. Int J Rock Mech Min Sci 44(4):550–564
Dahab AE, Omar El-Gassier MM, El Kariem HA (1992) Formation damage effects due to salinity, temperature and pressure in sandstone reservoirs as indicated by relative permeability measurements. J Petrol Sci Eng 6(4):403–412
David P, Lesmes K, Frye M (2001) Influence of pore fluid chemistry on the complex conductivity and induced polarization responses of Berea sandstone. J Geophys Res 106(B3):4079–4090
Dobereiner L, DeFreitas MH (1986) Geotechnical properties of weak sandstones. Geotechnique 36(1):79–94
Dunning JD, Miller ME (1985) Effects of ore fluid chemistry on stable sliding of Berea sandstone. Pure Appl Geophys 122(2–4):447–462
Dyke CG, Dobereiner L (1991) Evaluating the strength and deformability of sandstone. Q J Eng Geol 24:123–134
Eberhardt E, Stead D, Stimpson B, Read RS (1998) Identifying crack initiation and propagation thresholds in brittle rock. Can Geotech J 35(2):222–233
Eberhardt E, Stimpson B, Stead D (1999a) Quantifying progressive pre-peak brittle fracture damage in rock during uniaxial compression. Int J Rock Mech Min Sci 36:361–380
Eberhardt E, Stead D, Stimpson B (1999b) Effects of grain size on the initiation and propagation thresholds of stress-induced brittle fractures. Rock Mech Rock Eng 32(2):81–99
Erguler ZA, Ulusay R (2009) Water-induced variations in mechanical properties of clay-bearing rocks. Int J Rock Mech Min Sci 46(2):355–370
Garrouch A, Sharma MM (1994) The influence of clay content, salinity, stress and wettability on the dielectric properties of brine-saturated rocks: 10 Hz to 10 MHz. Geophysics 59(6):909–914
Gray DH, Rex R (1966) Formation damage in sandstones caused by clay dispersion and migration. In: Bailey SW(ed) Clay & clay minerals, Proc. l4th Nat. Conf. Clays and Clay Mins, vol 14. Pergamon press, Berkeley, pp 355–366
Hawkins AB, McConnell BJ (1992) Sensitivity of sandstone strength and deformability to changes in moisture content. Q J Eng Geol 25:115–130
International Society for Rock Mechanics (ISRM) (1981) Rock characterization, testing and monitoring, ISRM suggested methods In: Brown ET (ed) Pergamon Press, Oxford
Lockner D (1993) The role of acoustic emission in the study of rock fracture. lnt J Rock Mech Min Sci Geomech Abstr 30(7):88–899
Mackenzie FT, Lerman A, Ver LMB (2001) Recent past and future of the global carbon cycle. In: Studies in geology, vol 47. American Association of Petroleum Geologists, Tulsa, pp 51–82
Mohan KK, Vaidya RN, Reed MG, Fogler HS (1993) Water sensitivity of sandstones containing swelling and non-swelling clays. Coll Surf A Physicochem Eng Aspects 73:237–254
Mohan KK, Reed MG, Fogler HS (1999) Formation damage in smectic sandstones by high ionic strength brines. Coll Surf A Physicochem Eng Aspects 154:249–257
Mungan N (1965) Permeability reduction through changes in pH and salinity. J Petrol Technol 17(12):1449–1453
Omar AE (1990) Effect of brine composition and clay content on the permeability damage of sandstone cores. J Petrol Sci Eng 4:245–256
Ranjith PG, Fourar M, Chain SF, Haque A (2004) Characterization of fractured rocks under uniaxial loading states. Int J Rock Mech Min Sci 41:361–366
Ranjith PG, Jasinge D, Song JY, Choi SK (2008) A study of the effect of strain rate and moisture content on mechanical properties of concrete: use of acoustic emission. Mech Mater 40:453–469
Ranjith PG, Jasinge D, Choi SK, Mehic M, Shannon B (2010) The effect of CO2 saturation on mechanical properties of Australian black coal using acoustic emission. Fuel 89:2110–2117
Shukla R, Ranjith PG, Haque A, Choi X (2010) A review of studies on CO2 sequestration and caprock integrity. Fuel 89(10):2651–2664
Shukla R, Ranjith PG, Haque A, Choi X (2012) A novel testing apparatus for hydromechanical investigation of rocks in carbon geosequestration. Rock Mech Rock Eng. doi:10.1007/00603-012-0241-2
Smith J, Durucan S, Korre A, Shi JQ (2011) Carbon dioxide storage risk assessment: analysis of caprock fracture network connectivity. Int J Greenh Gas Cont 5:226–240
Zhu WC, Wei CH (2004) Numerical simulation on mining-induced water inrushes related to geologic structures using a damage-based hydromechanical model. Rock Mech Rock Eng 37(1):25–56
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Shukla, R., Ranjith, P.G., Choi, S.K. et al. Mechanical Behaviour of Reservoir Rock Under Brine Saturation. Rock Mech Rock Eng 46, 83–93 (2013). https://doi.org/10.1007/s00603-012-0246-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00603-012-0246-x