Skip to main content
Log in

Biomechanical compression tests with a new implant for thoracolumbar vertebral body replacement

  • Original Article
  • Published:
European Spine Journal Aims and scope Submit manuscript

Abstract.

The authors present an investigation into the biomechanical functioning of a new titanium implant for vertebral body replacement (Synex). Possible indications are fractures and/or dislocations with damage of the anterior column, post-traumatic kyphosis and tumors of the thoracolumbar spine. The construction must be supplemented by a stabilizing posterior or anterior implant. For best fit and contact with adjacent end-plates, Synex is distractable in situ. We performed comparative compression tests with Synex and MOSS ("Harms mesh cage") on human cadaveric specimens of intact vertebrae (L1). The aim of the study was to measure the compressive strength of the vertebral body end-plate in uniaxial loading via both implants to exclude collapse of Synex in vivo. Twelve human cadaveric specimens of intact vertebrae (L1) were divided into two identical groups (matched pairs) according to bone mineral density (BMD), determined using dual-energy quantitative computed tomography (DE-QCT). The specimens were loaded with an axial compression force at a constant speed of 5 mm/min to failure, and the displacement was recorded with a continuous load-displacement curve. The mean ultimate compression force (F max) showed a tendency towards a higher reading for Synex: 3396 N versus 2719 N (non-significant). The displacement until F max was 2.9 mm in the Synex group, which was half as far as in the MOSS group (5.8 mm). The difference was significant (P<0.001). The compression force was twice as high, and significantly (P<0.05) higher with Synex at displacements of 1 mm, 1.5 mm and 2 mm. A significant (P<0.001) correlation (R=0.89) between F max and BMD was found. Synex was found to be at least comparable to MOSS concerning the compressive performance at the vertebral end-plate. A possible consequence of the significantly higher mean compression forces between 1 and 2 mm displacement might be decreased collapse of the implant into the vertebral body in vivo.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Subscribe and save

Springer+ Basic
EUR 32.99 /Month
  • Get 10 units per month
  • Download Article/Chapter or Ebook
  • 1 Unit = 1 Article or 1 Chapter
  • Cancel anytime
Subscribe now

Buy Now

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

Author information

Authors and Affiliations

Authors

Additional information

Electronic Publication

Rights and permissions

Reprints and permissions

About this article

Cite this article

Knop, C., Lange, U., Bastian, L. et al. Biomechanical compression tests with a new implant for thoracolumbar vertebral body replacement. Eur Spine J 10, 30–37 (2001). https://doi.org/10.1007/s005860000211

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s005860000211

Navigation