Optimization of stress–strain behavior parameters by genetic algorithms method: Application to soft-matrix two-phase alloys

Abstract

 Deformation behavior of soft-matrix two-phase alloys has been computed using a continuum mechanics model based on an Isostrain condition, while the stress is distributed by the rule of mixtures. A genetic algorithm (GA) was used to optimize the mechanical modeling parameters such as the resistance and the formability of each phase. The stress–strain curves have been calculated as a function of volume fraction and mechanical properties of phases. The calculated and experimental stress–strain curves are compared and good agreement is found. The resistances increases with the rise of the hard phase volume fraction; this is more important with the presence of the hard phase than with the soft one. A linear law of variation of the phase resistance allows to interpolate and extrapolate the model, a good agreement is found with the evolution of the mechanical behavior.