Advertisement

Archive of Applied Mechanics

, Volume 88, Issue 8, pp 1325–1347 | Cite as

A time-domain system identification numerical procedure for obtaining linear dynamical models of multibody mechanical systems

  • Carmine M. Pappalardo
  • Domenico Guida
Original

Abstract

This paper is focused on the development of a numerical procedure for solving the system identification problem of linear dynamical models that mathematically describe multibody mechanical systems. To this end, an input–output representation of the time evolution of a general mechanical system based on a sequence of matrices referred to as Markov parameters is employed. The set of Markov parameters incorporate the state-space matrices that allow for describing the dynamic behavior of a general mechanical system considering the assumption of structural linearity. The system Markov parameters are defined by means of a discretization process applied to the analytical description of a mechanical system, and therefore, they are difficult to obtain directly from observable measurements. However, a state observer can be introduced in order to define a set of observer Markov parameters that can be readily recovered from input–output experimental data. The observer Markov parameters obtained by using a least-square approach allow for computing in a recursive manner the system Markov parameters as well as another discrete sequence of matrices referred to as observer gain Markov parameters. Subsequently, the system and observer gain Markov parameters identified from observable input–output data are used for constructing a sequence of generalized Hankel matrices from which a state-space model of the mechanical system of interest can be extracted. This fundamental step of the identification procedure is performed in the algorithm elaborated in this work employing a numerical procedure which relies on the use of the Moore–Penrose pseudoinverse matrix obtained by means of the singular value decomposition. In the paper, the principal analytical and numerical aspects of the proposed identification algorithm are described in detail. Furthermore, a numerical example based on a simple vehicle model is discussed in order to verify by means of numerical experiments the effectiveness of the identification procedure developed in this work.

Keywords

Multibody mechanical systems Applied system identification Markov parameters Singular value decomposition (SVD) Observer/Kalman filter identification method (OKID) Eigensystem realization algorithm (ERA) Modal parameter identification Full-car vehicle model 

Notes

Compliance with ethical standards

Conflict of interest

The authors declare that they have no conflict of interest

References

  1. 1.
    Ljung, L.: System Identification. Wiley, New York (1999)CrossRefzbMATHGoogle Scholar
  2. 2.
    Ljung, L.: Perspectives on system identification. Annu. Rev. Control 34(1), 1–12 (2010)MathSciNetCrossRefGoogle Scholar
  3. 3.
    Katayama, T.: Subspace Methods for System Identification. Springer, Berlin (2006)zbMATHGoogle Scholar
  4. 4.
    Reynders, E.: System identification methods for (operational) modal analysis: review and comparison. Arch. Comput. Methods Eng. 19(1), 51–124 (2012)MathSciNetCrossRefzbMATHGoogle Scholar
  5. 5.
    Tangirala, A.K.: Principles of System Identification: Theory and Practice. CRC Press, Boca Raton (2014)Google Scholar
  6. 6.
    Lus, H., De Angelis, M., Betti, R., Longman, R.W.: Constructing second-order models of mechanical systems from identified state space realizations. Part I: theoretical discussions. J. Eng. Mech. 129(5), 477–488 (2003)CrossRefGoogle Scholar
  7. 7.
    Lus, H., De Angelis, M., Betti, R., Longman, R.W.: Constructing second-order models of mechanical systems from identified state space realizations. Part II: numerical investigations. J. Eng. Mech. 129(5), 489–531 (2003)CrossRefGoogle Scholar
  8. 8.
    Gagg Filho, L.A., Da Conceicao, S.M., Vasques, C.H., De Abreu, G.L.C.M., Lopes Jr., V., Brennan, M.J.: Experimental identification and control of a cantilever beam using ERA/OKID with a LQR controller. J. Control Autom. Electr. Syst. 25(2), 161–173 (2014)CrossRefGoogle Scholar
  9. 9.
    Mercere, G., Prot, O., Ramos, J.A.: Identification of parameterized gray-box state-space systems: from a black-box linear time-invariant representation to a structured one. IEEE Trans. Autom. Control 59(11), 2873–2885 (2014)MathSciNetCrossRefzbMATHGoogle Scholar
  10. 10.
    Ramos, J.A., Mercere, G.: Subspace algorithms for identifying separable-in-denominator 2d systems with deterministic stochastic inputs. Int. J. Control 89(12), 2584–2610 (2016)MathSciNetCrossRefzbMATHGoogle Scholar
  11. 11.
    Guida, D., Nilvetti, F., Pappalardo, C.M.: Parameter identification of a two degrees of freedom mechanical system. Int. J. Mech. 3(2), 23–30 (2009)Google Scholar
  12. 12.
    Guida, D., Pappalardo, C.M.: Sommerfeld and mass parameter identification of lubricated journal bearing. WSEAS Trans. Appl. Theor. Mech. 4(4), 205–214 (2009)Google Scholar
  13. 13.
    Schiehlen, W.: Multibody Systems Handbook. Springer, Berlin (1990)CrossRefzbMATHGoogle Scholar
  14. 14.
    Shabana, A.A.: Dynamics of Multibody Systems, 4th edn. Cambridge University Press, Cambridge (2013)CrossRefzbMATHGoogle Scholar
  15. 15.
    Sayers, M.W., Han, D.: A generic multibody vehicle model for simulating handling and braking. Veh. Syst. Dyn. 25(S1), 599–613 (1996)CrossRefGoogle Scholar
  16. 16.
    Blundell, M., Harty, D.: The Multibody Systems Approach to Vehicle Dynamics. Elsevier, Amsterdam (2004)Google Scholar
  17. 17.
    Quatrano, A., De Simone, M.C., Rivera, Z.B., Guida, D.: Development and implementation of a control system for a retrofitted CNC machine by using arduino. FME Trans. 45(4), 578–584 (2017)CrossRefGoogle Scholar
  18. 18.
    Concilio, A., De Simone, M.C., Rivera, Z.B., Guida, D.: A new semi-active suspension system for racing vehicles. FME Trans. 45(4), 578–584 (2017)CrossRefGoogle Scholar
  19. 19.
    Guida, D., Pappalardo, C.M.: Control design of an active suspension system for a quarter-car model with hysteresis. J. Vib. Eng. Technol. 3(3), 277–299 (2015)Google Scholar
  20. 20.
    Schutte, A.D., Udwadia, F.E.: New approach to the modeling of complex multibody dynamical systems. J. Appl. Mech. 78(2), 1–11 (2010)Google Scholar
  21. 21.
    Patel, M.D., Orzechowski, G., Tian, Q., Shabana, A.A.: A new multibody system approach for tire modeling using ANCF finite elements. Proc. Inst. Mech. Eng. Part K J. Multi-body Dyn. 230(1), 1–16 (2016)Google Scholar
  22. 22.
    Pappalardo, C.M., Patel, M.D., Tinsley, B., Shabana, A.A.: Contact force control in multibody pantograph/catenary systems. Proc. Inst. Mech. Eng. Part K J. Multibody Dyn. 230(4), 307–328 (2016)Google Scholar
  23. 23.
    Pappalardo, C.M.: A natural absolute coordinate formulation for the kinematic and dynamic analysis of rigid multibody systems. Nonlinear Dyn. 81(4), 1841–1869 (2015)MathSciNetCrossRefzbMATHGoogle Scholar
  24. 24.
    Pappalardo, C.M., Guida, D.: On the use of two-dimensional Euler parameters for the dynamic simulation of planar rigid multibody systems. Arch. Appl. Mech. 87(10), 1647–1665 (2017)CrossRefGoogle Scholar
  25. 25.
    Oberpeilsteiner, S., Lauss, T., Nachbagauer, K., Steiner, W.: Optimal Input design for multibody systems by using an extended adjoint approach. Multibody Syst. Dyn. 40, 1–12 (2016)MathSciNetzbMATHGoogle Scholar
  26. 26.
    Lauss, T., Oberpeilsteiner, S., Steiner, W., Nachbagauer, K.: The discrete adjoint gradient computation for optimization problems in multibody dynamics. J. Comput. Nonlinear Dyn. 12(3), 031016 (2017)CrossRefzbMATHGoogle Scholar
  27. 27.
    Nachbagauer, K., Oberpeilsteiner, S., Sherif, K., Steiner, W.: The use of the adjoint method for solving typical optimization problems in multibody dynamics. J. Comput. Nonlinear Dyn. 10(6), 061011 (2015)CrossRefGoogle Scholar
  28. 28.
    Vyasarayani, C.P., Uchida, T., McPhee, J.: Nonlinear parameter identification in multibody systems using homotopy continuation. J. Comput. Nonlinear Dyn. 7(1), 011012 (2012)CrossRefGoogle Scholar
  29. 29.
    Vyasarayani, C.P., Uchida, T., McPhee, J.: Parameter identification in multibody systems using Lie series solutions and symbolic computation. J. Comput. Nonlinear Dyn. 6(4), 041011 (2011)CrossRefGoogle Scholar
  30. 30.
    Ayusawa, K., Venture, G., Nakamura, Y.: Identifiability and identification of inertial parameters using the underactuated base-link dynamics for legged multibody systems. Int. J. Robot. Res. 33(3), 446–468 (2014)CrossRefGoogle Scholar
  31. 31.
    Verhaegen, M., Dewilde, P.: Subspace model identification part 1. The output-error state-space model identification class of algorithms. Int. J. Control 56(5), 1187–1210 (1992)CrossRefzbMATHGoogle Scholar
  32. 32.
    Verhaegen, M., Dewilde, P.: Subspace model identification part 2. Analysis of the elementary output-error state-space model identification algorithm. Int. J. Control 56(5), 1211–1241 (1992)CrossRefzbMATHGoogle Scholar
  33. 33.
    Verhaegen, M.: Subspace model identification part 3. Analysis of the ordinary output-error state-space model identification algorithm. Int. J. Control 58(3), 555–586 (1993)CrossRefzbMATHGoogle Scholar
  34. 34.
    Kim, H.J., Yoo, W.S., Ok, J.K., Kang, D.W.: Parameter identification of damping models in multibody dynamic simulation of mechanical systems. Multibody Syst. Dyn. 22(4), 383–398 (2009)CrossRefzbMATHGoogle Scholar
  35. 35.
    Serban, R., Freeman, J.S.: Identification and identifiability of unknown parameters in multibody dynamic systems. Multibody Syst. Dyn. 5(4), 335–350 (2001)CrossRefzbMATHGoogle Scholar
  36. 36.
    Sandu, C., Andersen, E.R., Southward, S.: Multibody dynamics modelling and system identification of a quarter-car test rig with McPherson strut suspension. Veh. Syst. Dyn. 49(1–2), 153–179 (2011)CrossRefGoogle Scholar
  37. 37.
    Van Overschee, P., De Moor, B.: N4SID: Subspace algorithms for the identification of combined deterministic-stochastic systems. Automatica 30(1), 75–93 (1994)MathSciNetCrossRefzbMATHGoogle Scholar
  38. 38.
    Van Overschee, P., De Moor, B.L.: Subspace Identification for Linear Systems: Theory-Implementation-Applications. Springer, Berlin (2012)zbMATHGoogle Scholar
  39. 39.
    Juang, J.N.: Applied System Identification. Prentice Hall, Upper Saddle River (1994)zbMATHGoogle Scholar
  40. 40.
    Juang, J.N., Phan, M.Q.: Identification and Control of Mechanical Systems. Cambridge University Press, Cambridge (2001)CrossRefGoogle Scholar
  41. 41.
    ElMadany, M.M., Qarmoush, A.O.: Dynamic analysis of a slow-active suspension system based on a full car model. J. Vib. Control 17(1), 39–53 (2011)CrossRefzbMATHGoogle Scholar
  42. 42.
    Choi, S.B., Choi, Y.T., Park, D.W.: A sliding mode control of a full-car electrorheological suspension system via hardware in-the-loop simulation. J. Dyn. Syst. Meas. Control 122(1), 114–121 (2000)CrossRefGoogle Scholar
  43. 43.
    Elbeheiry, E.M., Karnopp, D.C., Elaraby, M.E., Abdelraaouf, A.M.: Suboptimal control design of active and passive suspensions based on a full car model. Veh. Syst. Dyn. 26(3), 197–222 (1996)CrossRefGoogle Scholar
  44. 44.
    Esmailzadeh, E., Fahimi, F.: Optimal adaptive active suspensions for a full car model. Veh. Syst. Dyn. 27(2), 89–107 (1997)CrossRefGoogle Scholar
  45. 45.
    Jahromi, A.F., Zabihollah, A.: Linear quadratic regulator and fuzzy controller application in full-car model of suspension system with magnetorheological shock absorber. In: IEEE/ASME international conference on mechatronics and embedded systems and applications (MESA), pp. 522–528 (2010)Google Scholar

Copyright information

© Springer-Verlag GmbH Germany, part of Springer Nature 2018

Authors and Affiliations

  1. 1.Department of Industrial EngineeringUniversity of SalernoFiscianoItaly

Personalised recommendations