Abstract
Introduction
In total knee arthroplasty (TKA), the gap expansion effect by soft tissue laxity and bone resection amount influence directly on the proper gap size and ideal polyethylene insert thickness. In this study, we hypothesized if bone resection level could be controlled lesser as gap expansion effect resulted in the effects on gap expansion of the collateral release and lax lateral structure, appropriate gap size would be attained without extensive medial soft tissue release even in severe varus deformed knee. The purpose of this study was to show the usefulness of preoperative calculation of soft tissue laxity for determining the appropriate gap size for the targeted PE thickness in TKA.
Methods
The preoperative varus stress view was used to estimate the effect of soft tissue release on extension gap expansion after primary bone resection. The amount of bone resection was determined with a parallel bone resection device used in our institution. Lateral laxity amount was applied into the device. This study was a retrospective review of 850 TKAs [451 with <10º varus deformity of the mechanical femoro-tibial angle (group 1); 399 with ≥10º varus deformity (group 2)] with a minimum follow-up of 1 year. We compared the range of motion (ROM), the knee society score (KSS), and the incidence of surgical complications at postoperative 1 year between the two groups.
Results
The mean PE thickness was 10.8 ± 1.1 in group 1 and 10.9 ± 1.1 in group 2. The proportion of patients with appropriate PE thickness (i.e., 10–12 mm) was 97.6 % in group 1 and 97.2 % in group 2. The ROM and KSS did not differ significantly between groups.
Conclusion
This study showed the usefulness of preoperative calculation of soft tissue laxity for appropriate gap size for targeted polyethylene thickness and possibility to attain constant extension gap regardless of preoperative varus deformity.
Similar content being viewed by others
References
Bartel DL, Bicknell VL, Wright TM (1986) The effect of conformity, thickness, and material on stresses in ultra-high molecular weight components for total joint replacement. J Bone Joint Surg Am 68:1041–1051
Berend ME, Davis PJ, Ritter MA, Keating EM, Faris PM, Meding JB, Malinzak RA (2010) “Thicker” polyethylene bearings are associated with higher failure rates in primary total knee arthroplasty. J Arthroplasty 25:17–20
Berend ME, Small SR, Ritter MA, Buckley CA (2010) The effects of bone resection depth and malalignment on strain in the proximal tibia after total knee arthroplasty. J Arthroplasty 25:314–318
Bottros J, Gad B, Krebs V, Barsoum WK (2006) Gap balancing in total knee arthroplasty. J Arthroplasty 21:11–15
Bourne RB, Laskin RS, Guerin JS (2007) Ten-year results of the first 100 Genesis II total knee replacement procedures. Orthopedics 30:83–85
Brooks P (2009) Seven cuts to the perfect total knee. Orthopedics. doi:10.1007/s00421-008-0955-8
Cooke TD (2002) Definition of axial alignment of the lower extremity. J Bone Joint Surg Am 84-A:146–147
Cooke TD, Scudamore RA, Bryant JT, Sorbie C, Siu D, Fisher B (1991) A quantitative approach to radiography of the lower limb. Principles and applications. J Bone Joint Surg Br 73:715–720
Cooke TD, Sled EA, Scudamore RA (2007) Frontal plane knee alignment: a call for standardized measurement. J Rheumatol 34:1796–1801
Engh GA, Dwyer KA, Hanes CK (1992) Polyethylene wear of metal-backed tibial components in total and unicompartmental knee prostheses. J Bone Joint Surg Br 74:9–17
Fehring TK, Mason JB, Moskal J, Pollock DC, Mann J, Williams VJ (2006) When computer-assisted knee replacement is the best alternative. Clin Orthop Relat Res 452:132–136
Grood ES, Noyes FR, Butler DL, Suntay WJ (1981) Ligamentous and capsular restraints preventing straight medial and lateral laxity in intact human cadaver knees. J Bone Joint Surg Am 63:1257–1269
Insall JN, Dorr LD, Scott RD, Scott WN (1989) Rationale of the Knee Society clinical rating system. Clin Orthop Relat Res 248:13–14
Lanting BA, Snider MG, Chess DG (2012) Effect of polyethylene component thickness on range of motion and stability in primary total knee arthroplasty. Orthopedics 35:e170–e174
Laskin RS, Schob CJ (1987) Medial capsular recession for severe varus deformities. J Arthroplasty 2:313–316
Lee DH, Seo JG, Moon YW (2008) Synchronisation of tibial rotational alignment with femoral component in total knee arthroplasty. Int Orthop 32:223–227
Lee DH, Shin YS, Jeon JH, Suh DW, Han SB (2013) Flexion and extension gaps created by the navigation-assisted gap technique show small acceptable mismatches and close mutual correlations. Knee Surg Sports Traumatol Arthrosc (in press)
Matsueda M, Gengerke TR, Murphy M, Lew WD, Gustilo RB (1999) Soft tissue release in total knee arthroplasty. Cadaver study using knees without deformities. Clin Orthop Relat Res 366:264–273
Matziolis G, Matziolis D, Perka C (2012) Pre-operative frontal plane malalignment predicts the extension gap asymmetry in knee osteoarthritis. Int Orthop 36:79–82
McGrory JE, Trousdale RT, Pagnano MW, Nigbur M (2002) Preoperative hip to ankle radiographs in total knee arthroplasty. Clin Orthop Relat Res 404:196–202
Mihalko WM, Saleh KJ, Krackow KA, Whiteside LA (2009) Soft-tissue balancing during total knee arthroplasty in the varus knee. J Am Acad Orthop Surg 17:766–774
Mizu-uchi H, Matsuda S, Miura H, Okazaki K, Akasaki Y, Iwamoto Y (2008) The evaluation of post-operative alignment in total knee replacement using a CT-based navigation system. J Bone Joint Surg Br 90:1025–1031
Mullaji A, Sharma A, Marawar S, Kanna R (2009) Quantification of effect of sequential posteromedial release on flexion and extension gaps: a computer-assisted study in cadaveric knees. J Arthroplasty 24:795–805
Mullaji AB, Padmanabhan V, Jindal G (2005) Total knee arthroplasty for profound varus deformity: technique and radiological results in 173 knees with varus of more than 20 degrees. J Arthroplasty 20:550–561
Okamoto S, Okazaki K, Mitsuyasu H, Matsuda S, Iwamoto Y (2013) Lateral soft tissue laxity increases but medial laxity does not contract with varus deformity in total knee arthroplasty. Clin Orthop Relat Res 471:1334–1342
Schnurr C, Csecsei G, Nessler J, Eysel P, Konig DP (2011) How much tibial resection is required in total knee arthroplasty? Int Orthop 35:989–994
Seo JG, Kim BK, Moon YW, Kim JH, Yoon BH, Ahn TK, Lee DH (2009) Bony landmarks for determining the mechanical axis of the femur in the sagittal plane during total knee arthroplasty. Clin Orthop Surg 1:128–131
Seo JG, Moon YW, Lim JS, Park SJ, Kim SM (2012) Mechanical axis-derived femoral component rotation in extramedullary total knee arthroplasty: a comparison between femoral transverse axis and transepicondylar axis. Knee Surg Sports Traumatol Arthrosc 20:538–545
Seo JG, Moon YW, Park SH, Shim JW, Kim SM (2012) An alternative method to create extramedullary references in total knee arthroplasty. Knee Surg Sports Traumatol Arthrosc 20:1339–1348
Stockl B, Nogler M, Rosiek R, Fischer M, Krismer M, Kessler O (2004) Navigation improves accuracy of rotational alignment in total knee arthroplasty. Clin Orthop Relat Res 426:180–186
Takahashi T, Wada Y, Yamamoto H (1997) Soft-tissue balancing with pressure distribution during total knee arthroplasty. J Bone Joint Surg Br 79:235–239
Teeny SM, Krackow KA, Hungerford DS, Jones M (1991) Primary total knee arthroplasty in patients with severe varus deformity. A comparative study. Clin Orthop Relat Res 273:19–31
Tsao A, Mintz L, McRae CR, Stulberg SD, Wright T (1993) Failure of the porous-coated anatomic prosthesis in total knee arthroplasty due to severe polyethylene wear. J Bone Joint Surg Am 75:19–26
Vince KG, Abdeen A, Sugimori T (2006) The unstable total knee arthroplasty: causes and cures. J Arthroplasty 21:44–49
Warren LA, Marshall JL, Girgis F (1974) The prime static stabilizer of the medical side of the knee. J Bone Joint Surg Am 56:665–674
Wasielewski RC, Galante JO, Leighty RM, Natarajan RN, Rosenberg AG (1994) Wear patterns on retrieved polyethylene tibial inserts and their relationship to technical considerations during total knee arthroplasty. Clin Orthop Relat Res 299:31–43
Weng YJ, Hsu RW, Hsu WH (2009) Comparison of computer-assisted navigation and conventional instrumentation for bilateral total knee arthroplasty. J Arthroplasty 24:668–673
Whiteside LA (2002) Soft tissue balancing: the knee. J Arthroplasty 17:23–27
Wright TM, Bartel DL (1986) The problem of surface damage in polyethylene total knee components. Clin Orthop Relat Res 2085:67–74
Wright TM, Rimnac CM, Stulberg SD, Mintz L, Tsao AK, Klein RW, McCrae C (1992) Wear of polyethylene in total joint replacements. Observations from retrieved PCA knee implants. Clin Orthop Relat Res 276:126–134
Yagishita K, Muneta T, Yamamoto H, Shinomiya K (2001) The relationship between postoperative ligament balance and preoperative varus deformity in total knee arthroplasty. Bull Hosp Jt Dis 60:23–28
Yercan HS, Ait Si Selmi T, Sugun TS, Neyret P (2005) Tibiofemoral instability in primary total knee replacement: a review Part 2: diagnosis, patient evaluation, and treatment. Knee 12:336–340
Zhang GQ, Chen JY, Chai W, Liu M, Wang Y (2011) Comparison between computer-assisted-navigation and conventional total knee arthroplasties in patients undergoing simultaneous bilateral procedures: a randomized clinical trial. J Bone Joint Surg Am 93:1190–1196
Conflict of interest
None.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Seo, J.G., Lee, B.H., Moon, YW. et al. Soft tissue laxity should be considered to achieve a constant polyethylene thickness during total knee arthroplasty. Arch Orthop Trauma Surg 134, 1317–1323 (2014). https://doi.org/10.1007/s00402-014-2050-4
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00402-014-2050-4