Skip to main content
Log in

Diagnostics of the fluctuating wall shear rate components using an uncalibrated three-segment electrodiffusion sensor

  • Research Article
  • Published:
Experiments in Fluids Aims and scope Submit manuscript


An inverse problem is used to significantly improve the frequency response of a three-segment electrodiffusion (ED) sensor subjected to strong inertial effects in high-amplitude unsteady flows. It is shown that the fluctuating component of the wall shear rate’s magnitude and direction can be accurately determined when both variables exhibit simultaneous large-amplitude variations, even when using an uncalibrated probe. Measurements are performed in the vicinity of a rotating cylinder in motion in a highly viscous fluid with poor electrochemical diffusivity, thus establishing a harsh environment for an ED sensor. Results using the inverse problem showed strong concordance with PIV complementary measurements in most cases and further expose the potential of this non-intrusive technique for thorough wall shear stress diagnostics.

Graphical Abstract

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11

Similar content being viewed by others


  1. One can show that \(k^*=\sum {\textit{Sh}}^*_{\text {num},\,m}\) when \({\textit{Pe}}\rightarrow \infty\), but \(k^*\) can vary when dealing with experimental signals (cf. Sect. 2.2).

  2. While no simulation was performed for the OC motion, one can expect similar conclusions as velocities and frequencies are comparable, except for case OC2.

  3. Especially on A, as the active area of a probe can be altered during measurements by probe poisoning (Sobolík et al. 1998; Bard and Faulkner 2001).

  4. Based on errors of \(\sim 2\%\) and \(\sim 3\%\) on A and D, respectively (cf. Sect. 2.1).

  5. Such a motion could be achieved by disabling smoothing parameters in the motor drive.


  • Arvia AJ, Marchiano SL, Podesta JJ (1967) The diffusion of ferrocyanide and ferricyanide ions in aqueous solutions of potassium hydroxide. Electrochim Acta 12(3):259–266

    Article  Google Scholar 

  • Bard AJ, Faulkner LR (2001) Electrochemical methods: fundamentals and applications, 2nd edn. Wiley, Hoboken

    Google Scholar 

  • Berger FP, Ziai A (1983) Optimisation of experimental conditions for electrochemical mass transfer measurements. Chem Eng Res Des 61(6):377–382

    Google Scholar 

  • Deslouis C, Tribollet B, Tihon J (2004) Near-wall turbulence in drag reducing flows investigated by the photolithography-electrochemical probes. J Non-Newtonian Fluid Mech 123(2):141–150

    Article  Google Scholar 

  • Fourrié G, Keirsbulck L, Labraga L (2013) Wall shear stress characterization of a 3d bluff-body separated flow. J Fluids Struct 42:55–69

    Article  Google Scholar 

  • Hanratty TJ, Campbell JA (1996) Measurement of wall shear stress. In: Goldstein R (ed) Fluid mechanics measurements, 2nd edn. Taylor & Francis, Hoboken, pp 575–648

    Google Scholar 

  • He S, Ariyaratne C, Vardy AE (2011) Wall shear stress in accelerating turbulent pipe flow. J Fluid Mech 685:440–460

    Article  Google Scholar 

  • Jordan J, Ackerman E, Berger RL (1956) Polarographic diffusion coefficients of oxygen defined by activity gradients in viscous media. J Am Chem Soc 78(13):2979–2983

    Article  Google Scholar 

  • Labraga L, Bourabaa N, Berkah T (2002) Wall shear stress from a rotating cylinder in cross flow using the electrochemical technique. Exp Fluids 33(3):488–496

    Article  Google Scholar 

  • Lamarche-Gagnon MÉ (2018) Développement de la méthode électrodiffusionnelle pour la mesure instantanée des deux composantes du frottement pariétal. PhD thesis, Polytechnique Montréal (Canada)

  • Lamarche-Gagnon MÉ, Vétel J (2018) An inverse problem to assess the two-component unsteady wall shear rate. Int J Therm Sci 130:278–288

    Article  Google Scholar 

  • Mao ZX, Hanratty TJ (1991a) Analysis of wall shear stress probes in large amplitude unsteady flows. Int J Heat Mass Transfer 34(1):281–290

    Article  Google Scholar 

  • Mao ZX, Hanratty TJ (1991b) Application of an inverse mass transfer method to the measurement of turbulent fluctuations in the velocity gradient at the wall. Exp Fluids 11(1):65–73

    Article  Google Scholar 

  • Mao ZX, Hanratty TJ (1992) Measurement of wall shear rate in large amplitude unsteady reversing flows. Exp Fluids 12(4):342–350

    Article  Google Scholar 

  • Maquinghen T (1999) Métrologie tridimensionnelle instationnaire à l’aide de la méthode polarographique. PhD thesis, Valenciennes

  • Naughton JW, Sheplak M (2002) Modern developments in shear-stress measurement. Prog Aerosp Sci 38(6):515–570

    Article  Google Scholar 

  • Ozisik MN (2000) Inverse heat transfer: fundamentals and applications. CRC Press, Routeledge

    Google Scholar 

  • Pauli J, Sobolik V, Onken U (1991) Oxygen as depolarizer in electrodiffusion diagnostics of flow. Chem Eng Sci 46(12):3302–3304

    Article  Google Scholar 

  • Rehimi F, Aloui F, Nasrallah SB, Doubliez L, Legrand J (2006) Inverse method for electrodiffusional diagnostics of flows. Int J Heat Mass Transfer 49(7):1242–1254

    Article  Google Scholar 

  • Reiss LP, Hanratty TJ (1963) An experimental study of the unsteady nature of the viscous sublayer. AlChE J 9(2):154–160

    Article  Google Scholar 

  • Schlichting H, Gersten K (2000) Boundary-layer theory. Springer, Berlin

    Book  Google Scholar 

  • Selman JR, Tobias CW (1978) Mass-transfer measurements by the limiting-current technique. Adv Chem Eng 10:211–318

    Article  Google Scholar 

  • Sobolík V, Wein O, Čermák J (1987) Simultaneous measurement of film thickness and wall shear stress in wavy flow of non-newtonian liquids. Collect Czech Chem Commun 52(4):913–928

    Article  Google Scholar 

  • Sobolík V, Tihon J, Wein O, Wichterle K (1998) Calibration of electrodiffusion friction probes using a voltage-step transient. J Appl Electrochem 28(3):329–335

    Article  Google Scholar 

  • Tihon J (2014) Application of the electrodiffusion method for near-wall flow diagnostics. EPJ Web Conf 67:2117

    Article  Google Scholar 

  • Wein O, Sobolík V (1987) Theory of direction sensitive probes for electrodiffusion measurement of wall velocity gradients. Collect Czech Chem Commun 52(9):2169–2180

    Article  Google Scholar 

Download references


The authors would like to acknowledge the financial support of the Canadian Foundation for Innovation (CFI), the Natural Sciences and Engineering Research Council of Canada (NSERC) and the Fonds de recherche du Québec—Nature et technologies (FRQNT). We also acknowledge the technical support of T. Lafrance from MËKANIC and J.-M. Béland for their cooperation in the design and fabrication of the experimental setup and the reviewers for valuable recommendations in the revision process.

Author information

Authors and Affiliations


Corresponding author

Correspondence to M.-É. Lamarche-Gagnon.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Electronic supplementary material

Below is the link to the electronic supplementary material.

Supplementary material 1 (avi 7534 KB)

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Lamarche-Gagnon, MÉ., Sobolík, V. & Vétel, J. Diagnostics of the fluctuating wall shear rate components using an uncalibrated three-segment electrodiffusion sensor. Exp Fluids 59, 168 (2018).

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • DOI: