Advertisement

Experiments in Fluids

, 57:40 | Cite as

Closed-loop separation control over a sharp edge ramp using genetic programming

  • Antoine Debien
  • Kai A. F. F. von Krbek
  • Nicolas Mazellier
  • Thomas Duriez
  • Laurent Cordier
  • Bernd R. Noack
  • Markus W. Abel
  • Azeddine Kourta
Research Article

Abstract

We experimentally perform open and closed-loop control of a separating turbulent boundary layer downstream from a sharp edge ramp. The turbulent boundary layer just above the separation point has a Reynolds number \(Re_{\theta }\approx 3500\) based on momentum thickness. The goal of the control is to mitigate separation and early re-attachment. The forcing employs a spanwise array of active vortex generators. The flow state is monitored with skin-friction sensors downstream of the actuators. The feedback control law is obtained using model-free genetic programming control (GPC) (Gautier et al. in J Fluid Mech 770:442–457, 2015). The resulting flow is assessed using the momentum coefficient, pressure distribution and skin friction over the ramp and stereo PIV. The PIV yields vector field statistics, e.g. shear layer growth, the back-flow area and vortex region. GPC is benchmarked against the best periodic forcing. While open-loop control achieves separation reduction by locking-on the shedding mode, GPC gives rise to similar benefits by accelerating the shear layer growth. Moreover, GPC uses less actuation energy.

Keywords

Feedback flow control Turbulent boundary layer Active vortex generators Machine learning control Genetic programming 

Notes

Acknowledgments

This work was supported by French National Research Agency (ANR) via the SepaCoDe Project (ANR-11-BS09-018) and the TUCOROM Chair of Excellence (ANR-10-CEXC-0015).

References

  1. Amitay M, Glezer A (2002) Role of actuation frequency in controlled flow reattachment over a stalled airfoil. AIAA J 40(2):209–216CrossRefGoogle Scholar
  2. Benard N, Moreau E, Griffin J, Cattafesta LN III (2010) Slope seeking for autonomous lift improvement by plasma surface discharge. Exp Fluids 48(5):791–808CrossRefGoogle Scholar
  3. Benedict LH, Gould RD (1996) Towards better uncertainty estimates for turbulence statistics. Exp Fluids 22(2):129–136CrossRefGoogle Scholar
  4. Browand FK, Troutt TR (1985) The turbulent mixing layer: geometry of large vortices. J Fluid Mech 158:489–509CrossRefGoogle Scholar
  5. Brunton SL, Noack BR (2015) Closed-loop turbulence control: progress and challenges. Appl Mech Rev 67(5):050,801:01–050,801:48CrossRefGoogle Scholar
  6. Castro IP, Haque A (1987) The structure of a turbulent shear layer bounding a separation region. J Fluid Mech 179:439–468CrossRefGoogle Scholar
  7. Cherry NJ, Hillier R, Latour MEMP (1984) Unsteady measurements in a separated and reattaching flow. J Fluid Mech 144:13–46CrossRefGoogle Scholar
  8. Cordier L, Noack BR, Tissot G, Lehnasch G, Delville J, Balajewicz M, Daviller G, Niven RK (2013) Identification strategy for model-based control. Exp Fluids 54:1580CrossRefGoogle Scholar
  9. Cuvier C, Braud C, Foucault JM, Stanislas M (2011) Flow control over a ramp using active vortex generators. In: Seventh International Symposium on Turbulence and Shear Flow Phenomena, Ottawa, CanadaGoogle Scholar
  10. Dandois J, Garnier E, Sagaut P (2007) Numerical simulation of active separation control by a synthetic jet. J Fluid Mech 574(1):25–58CrossRefzbMATHGoogle Scholar
  11. Debien A, Aubrun S, Mazellier N, Kourta A (2014) Salient and smooth edge ramps inducing turbulent boundary layer separation: flow characterization for control perspective. C R Mécanique 342(6–7):356–362Google Scholar
  12. Debien A, Aubrun S, Mazellier N, Kourta A (2015) Active separation control process over a sharp edge ramp. In: Ninth International Symposium on Turbulence and Shear Flow Phenomena, Melbourne, AustraliaGoogle Scholar
  13. Duriez T, Parezanović V, Laurentie JC, Fourment C, Delville J, Bonnet JP, Cordier L, Noack BR, Segond M, Abel MW, Gautier N, Aider JL, Raibaudo C, Cuvier C, Stanislas M, Brunton S (2014) Closed-loop control of experimental shear layers using machine learning (Invited). In: 7th AIAA Flow Control Conference, Atlanta, Georgia, USA, pp 1–16Google Scholar
  14. Gautier N, Aider JL (2013) Control of the separated flow downstream of a backward-facing step using visual feedback. Proc R Soc A 469(2160):20130,404CrossRefGoogle Scholar
  15. Gautier N, Aider JL, Duriez T, Noack BR, Segond M, Abel M (2015) Closed-loop separation control using machine learning. J Fluid Mech 770:442–457CrossRefGoogle Scholar
  16. Gerhard J, Pastoor M, King R, Noack BR, Dillmann A, Morzyński M, Tadmor G (2003) Model-based control of vortex shedding using low-dimensional Galerkin models. In: 33rd AIAA Fluids Conference and Exhibit, Orlando, Florida, USA, paper 2003-4262Google Scholar
  17. Godard G, Stanislas M (2006a) Control of a decelerating boundary layer. Part 1: optimization of passive vortex generators. Aerosp Sci Technol 10(3):181–191CrossRefGoogle Scholar
  18. Godard G, Stanislas M (2006b) Control of a decelerating boundary layer. Part 3: optimization of round jets vortex generators. Aerosp Sci Technol 10(6):455–464CrossRefGoogle Scholar
  19. Greenblatt D, Wygnanski IJ (2000) The control of flow separation by periodic excitation. Prog Aerosp Sci 36(7):487–545CrossRefGoogle Scholar
  20. Hasan MAZ (1992) The flow over a backward-facing step under controlled perturbation: laminar separation. J Fluid Mech 238:73–96CrossRefGoogle Scholar
  21. Jovic S (1996) An experimental study of a separated/reattached flow behind a backward-facing step. \(Re_h = 37{,}000\). NASA Tech Memo 110384Google Scholar
  22. Kaiser E, Noack BR, Cordier L, Spohn A, Segond M, Abel MW, Daviller G, Östh J, Krajnović S, Niven RK (2014) Cluster-based reduced-order modelling of a mixing layer. J Fluid Mech 754:365–414CrossRefzbMATHGoogle Scholar
  23. King R (ed) (2007) Active flow control I, no. 95 in notes on numerical fluid mechanics and interdisciplinary design. Springer, BerlinGoogle Scholar
  24. King R (ed) (2010) Active flow control II, no. 108 in notes on numerical fluid mechanics and interdisciplinary design. Springer, BerlinGoogle Scholar
  25. Koza JR (1992) Genetic programming: on the programming of computers by means of natural selection. The MIT Press, BostonzbMATHGoogle Scholar
  26. Koza JR, Bennett FH III, Stiffelman O (1999) Genetic programming as a Darwinian invention machine, vol 1598., Lecture notes in computer scienceSpringer, BerlinGoogle Scholar
  27. Lin JC (2002) Review of research on low-profile vortex generators to control boundary-layer separation. Prog Aerosp Sci 38(4):389–420CrossRefGoogle Scholar
  28. Mabey DG (1972) Analysis and correlation of data on pressure fluctuations in separated flow. J Aircraft 9(9):642–645CrossRefGoogle Scholar
  29. Mittal R, Kotapati R, Cattafesta III L (2005) Numerical study of resonant interactions and flow control in a canonical separated flow. In: AIAA 43rd Aerospace Sciences Meeting and Exhibit, Reno, NV, USAGoogle Scholar
  30. Murphy KP (2012) Machine learning: a probabilistic perspective. MIT Press, CambridgezbMATHGoogle Scholar
  31. Parezanovic V, Laurentie JC, Fourment C, Delville J, Bonnet JP, Spohn A, Duriez T, Cordier L, Noack BR, Abel M, Segond M, Shaqarin T, Brunton S (2015) Mixing layer manipulation experiment—from open-loop forcing to closed-loop machine learning control. Flow Turbul Combust 94:155–173CrossRefGoogle Scholar
  32. Pastoor M, Henning L, Noack BR, King R, Tadmor G (2008) Feedback shear layer control for bluff body drag reduction. J Fluid Mech 608:161–196CrossRefzbMATHGoogle Scholar
  33. Petz C, Kasten J, Prohaska S, Hege HC (2009) Hierarchical vortex regions in swirling flow. Comput Graph Forum 28(3):863–870CrossRefGoogle Scholar
  34. Rowley CW, Williams DR (2006) Dynamics and control of high-Reynolds number flows over open cavities. Annu Rev Fluid Mech 38:251–276MathSciNetCrossRefzbMATHGoogle Scholar
  35. Seifert A, Pack LG (2003) Effects of sweep on active separation control at high Reynolds numbers. J Aircraft 40(1):120–126CrossRefGoogle Scholar
  36. Shaqarin T, Braud C, Coudert S, Stanislas M (2011) Open and closed-loop experiments to reattach a thick turbulent boundary layer. In: Seventh International Symposium on Turbulence and Shear Flow Phenomena, Ottawa, CanadaGoogle Scholar
  37. Shaqarin T, Braud C, Coudert S, Stanislas M (2013) Open and closed-loop experiments to identify the separated flow dynamics of a thick turbulent boundary layer. Exp Fluids 54(2):1–22CrossRefGoogle Scholar
  38. Song S, DeGraaff DB, Eaton JK (2000) Experimental study of a separating, reattaching, and redeveloping flow over a smoothly contoured ramp. Int J Heat Fluid Flow 21(5):512–519CrossRefGoogle Scholar
  39. Tennekes H, Lumley J (1972) A first course in turbulence. MIT Press, CambridgezbMATHGoogle Scholar
  40. Zaman KBMQ, Hussain AKMF (1981) Turbulence suppression in free shear flows by controlled excitation. J Fluid Mech 103:133–159CrossRefGoogle Scholar

Copyright information

© Springer-Verlag Berlin Heidelberg 2016

Authors and Affiliations

  • Antoine Debien
    • 1
  • Kai A. F. F. von Krbek
    • 2
  • Nicolas Mazellier
    • 1
  • Thomas Duriez
    • 3
  • Laurent Cordier
    • 2
  • Bernd R. Noack
    • 4
    • 5
  • Markus W. Abel
    • 6
  • Azeddine Kourta
    • 1
  1. 1.Université d’Orléans, INSA-CVL, PRISME EA 4229OrléansFrance
  2. 2.Institute PPRIME, CNRS - Université de Poitiers - ENSMA, UPR 3346, Département Fluides, Thermique, Combustion, CEATPoitiers CedexFrance
  3. 3.CONICET, Universidad de Buenos AiresCiudad Autonoma de Buenos AiresArgentina
  4. 4.LIMSI, CNRSCampus Universitaire d′OrsayOrsay CedexFrance
  5. 5.Institut für Strömungsmechanik, Technische Universität BraunschweigBraunschweigGermany
  6. 6.Ambrosys GmbHPotsdamGermany

Personalised recommendations