Skip to main content
Log in

Boiling regimes in uncoated polydimethylsiloxane microchannels with a fine wire heater

  • Original
  • Published:
Heat and Mass Transfer Aims and scope Submit manuscript

Abstract

Polydimethylsiloxane (PDMS) is a type of gas permeable media widely used in microfluidic applications. In this work multiphase patterns and boiling curves in PDMS square microchannels were experimentally investigated. Very fine platinum wires with diameter of 50 μm were embedded through the microchannels and serving as heater. The multiphase patterns were visualized by means of high speed CCD camera with microscope. Curves of temperature versus heat flux on the wire heaters were plotted. Based on the evolution of multiphase patterns, five boiling regimes were classified, that is, single phase, bubble formation, slug formation, slug dominated and dry out. Interestingly, the bubbles were generated from the channel walls rather than the heater surface, and so-called “droplets-in-bubble” phenomenon drew attention in which bunches of microdroplets kept forming, growing, and disappearing within the big bubbles. The boiling curves were plotted and compared to boiling in open space and in glass tubes. The heat transfer in the PDMS microchannels got deteriorated when the bubbles formed.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13

Similar content being viewed by others

References

  1. Lin L, Pisano AP (2005) Thermal bubble powered microactuators. Microsyst Technol 1:51–58

    Article  Google Scholar 

  2. Tsai J-H, Lin L (2002) A thermal bubble actuated micro nozzle-diffuser pump. IEEE 409–412

  3. Laser DJ, Santiago JG (2004) A review of micropumps. J Micromech Microeng 14:35–64

    Article  Google Scholar 

  4. Lin L (1998) Microscale thermal bubble formation: thermophysical phenomena and applications. Nanoscale Microscale Thermophys Eng 2:71–85

    Article  Google Scholar 

  5. Maxwell RB, Gerhardt AL, Toner M, Gray ML, Schmidt MA (2003) A microbubble-powered bioparticle actuator. J Microelectromech Syst 12:630–640

    Article  Google Scholar 

  6. Jiang YY, Wang WC, Wang D, Wang BX (2001) Boiling heat transfer on machined porous surfaces with structural optimization. Int J Heat Mass Transf 44:443–456

    Article  MATH  MathSciNet  Google Scholar 

  7. Zhang Y, Bao N, Yu X-D, Xu J-J, Chen H-Y (2004) Improvement of heat dissipation for polydimethylsiloxane microchip electrophoresis. J Chromatogr A 1057:247–251

    Article  Google Scholar 

  8. Li HY, Tseng FG, Pan C (2004) Bubble dynamics in microchannels. Part II: two parallel microchannels. Int J Heat Mass Transf 47:5591–5601

    Article  Google Scholar 

  9. Wu HY, Cheng P (2003) Visualization and measurements of periodic boiling in silicon microchannels. Int J Heat Mass Transf 46:2603–2614

    Article  MathSciNet  Google Scholar 

  10. Wang G, Cheng P (2008) An experimental study of flow boiling instability in a single microchannel. Int Commun Heat Mass Transf 35:1229–1234

    Article  MathSciNet  Google Scholar 

  11. Peng XF, Wang BX (1993) Forced-convection and flow boiling heat transfer for liquid flowing through microchannels. Int J Heat Mass Transf 36:3421–3427

    Article  Google Scholar 

  12. Peng XF, Wang BX (1994) Evaporating space and fictitious boiling for internal evaporation of liquid. Sci Found China 2:55–60

    MathSciNet  Google Scholar 

  13. Chabinyc ML, Chiu DT, McDonald JC, Stroock AD, Christian JF, Karger AM, Whitesides GM (2001) An integrated fluorescence detection system in poly(dimethylsiloxane) for microfluidic applications. Anal Chem 73:4491–4498

    Article  Google Scholar 

  14. Diercks AH, Ozinsky A, Hansen CL, Spotts JM, Rodriguez DJ, Aderem A (2009) A microfluidic device for multiplexed protein detection in nano-liter volumes. Anal Biochem 386:30–35

    Article  Google Scholar 

  15. Pan T, McDonald SJ, Kai EM, Ziaie B (2005) A magnetically driven PDMS micropump with ball check-valves. J Micromech Microeng 15:1021–1026

    Article  Google Scholar 

  16. Choban ER, Markoski LJ, Wieckowski A, Kenis PJA (2004) Microfluidic fuel cell based on laminar flow. J Power Sources 128:54–60

    Article  Google Scholar 

  17. Shah K, Shin WC, Besser RS (2004) A PDMS micro proton exchange membrane fuel cell by conventional and non-conventional microfabrication techniques. Sens Actuators B Chem 97:157–167

    Article  Google Scholar 

  18. Maltezos G, Rajagopal A, Scherer A (2006) Evaporative cooling in microfluidics channels. Appl Phys Lett 89:074107-1–074107-3

    Google Scholar 

  19. Shin YS, Cho K, Lim SH, Chung S, Park S-J, Chung C, Han D-C, Chang JK (2003) PDMS-based micro PCR chip with Parylene coating. J Micromech Microeng 13:768–774

    Article  Google Scholar 

  20. Kim JA, Lee JY, Seong S, Cha SH, Lee SH, Kim JJ, Park TH (2006) Fabrication and characterization of a PDMS-glass hybrid continuous-flow PCR chip. Biochem Eng J 29:91–97

    Article  Google Scholar 

  21. Liu H-B, Gong H-Q, Ramallingam N, Jiang Y, Dai C-C, Hui KM (2007) Micro air bubble formation and its control during polymerase chain reaction (PCR) in polydimethylsiloxane (PDMS) microreactors. J Micromech Microeng 17:2055–2064

    Article  Google Scholar 

  22. Garstecki P, Fuerstman MJ, Fischbach MA, Sia SK, Whitesides GM (2006) Mixing with bubbles: a practical technology for use with portable microfluidic devices. Lab Chip 6:207–212

    Article  Google Scholar 

  23. Singh SG, Kulkarni A, Duttagupta SP, Puranik BP, Agrawal A (2008) Impact of aspect ratio on flow boiling of water in rectangular microchannels. Exp Therm Fluid Sci 33:153–160

    Article  Google Scholar 

  24. Francais O, Jullien MC, Rousseau L, Poulichet P, Desportes S, Chouai A, Lefevre JP, Delaire J (2007) An active chaotic micromixer integrating thermal actuation associating PDMS and silicon microtechnology. In: DTIP of MEMS & MOEMS. arXiv:0711.3290v1

  25. Niu ZQ, Chen WY, Shao SY, Jia XY, Zhang WP (2006) DNA amplification on a PDMS-glass hybrid microchip. J Micromech Microeng 16:425–433

    Article  Google Scholar 

  26. Toriello NM, Liu CN, Mathies RA (2006) Multichannel reverse transcription-polymerase chain reaction microdevice for rapid gene expression and biomarker analysis. Anal Chem 78:7997–8003

    Article  Google Scholar 

  27. Huh C, Kim J, Kim MH (2007) Flow pattern transition instability during flow boiling in a single microchannel. Int J Heat Mass Transf 50:1049–1060

    Article  Google Scholar 

  28. Huh C, Kim MH (2006) An experimental investigation of flow boiling in an asymmetrically heated rectangular microchannel. Exp Therm Fluid Sci 30:775–784

    Article  Google Scholar 

  29. Duffy DC, McDonald JC, Schueller OJA, Whitesides GM (1998) Rapid prototyping of microfluidic systems in poly(dimethylsiloxane). Anal Chem 70:4974–4984

    Article  Google Scholar 

Download references

Acknowledgments

This work was supported by the National Natural Science Foundation of China, Grant No. 50706001. The authors thank Laboratory of Phase Change and Interfacial Transport Phenomena at Tsinghua University for the assistances during chip fabrication.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Hao Wang.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Lu, Y., Wang, F. & Wang, H. Boiling regimes in uncoated polydimethylsiloxane microchannels with a fine wire heater. Heat Mass Transfer 46, 1253–1260 (2010). https://doi.org/10.1007/s00231-010-0655-x

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00231-010-0655-x

Keywords

Navigation