Abstract
The aim of this research was to characterise the bio-oil produced by pyrolysis of Acacia mangium wood through gas chromatography–mass spectrometry (GC–MS). Experimental study was employed using two experiment models: two-level factorial design (TLFD) and response surface methodology–Box–Behnken (RSM–BB). TLFD was used to analyse the final temperature, heating rate and particle size effect on the bio-oil yield, while RSM–BB was conducted to determine the optimum conditions for bio-oil production. The statistical analysis showed that the factors of pyrolysis temperature and particle size had the greater effect, while the heating rate was significant, but had a lesser effect. By utilising RSM, these factors presented the optimal conditions obtained at pyrolysis temperature of 499.57 °C, heating rate of 12 °C min−1 and particle size of 0.46 mm. With the GC–MS result, it was observed that the percentage of phenol and derivatives was much higher than the rest of the components.
This is a preview of subscription content, access via your institution.






References
Abreu NR, Foppa PE, Riva G, Romero RO (2010) Caracterización energética del Marabú (Energetic characterization of Marabu). DYNA Ingeniería e Industria 85(7):581–592 (In Spanish)
Akhtar J, Saidina Amin N (2012) A review on operating parameters for optimum liquid oil yield in biomass pyrolysis. Renew Sustain Energy Rev 16:5101–5109
Amen-Chen C, Pakdel H, Roy C (1997) Separation of phenols from Eucalyptus wood tar. Biomass Bioenerg 13:25–37
Amidon TE, Liu S (2009) Water-based woody biorefinery. Biotechnol Adv 27:542–550
Anderson MJ, Whitcomb PJ (2015) DOE simplified: practical tools for effective experimentation. CRC Press, New York
Arteaga Crespo Y, Abreu Naranjo R, Vargas Burgos JC, Glauco Sanchez C, Sanchez Sanchez EM (2015) Thermogravimetric analysis of thermal and kinetic behavior of acacia mangium wood. Wood Fiber Sci 47:327–335
Aslan N, Cebeci Y (2007) Application of Box-Behnken design and response surface methodology for modeling of some Turkish coals. Fuel 86:90–97
ASTM-E1757-01 (2007) Standard practice for preparation of biomass for compositional analysis, ASTM International, West Conshohocken, PA
Ayllón M, Aznar M, Sánchez JL, Gea G, Arauzo J (2006) Influence of temperature and heating rate on the fixed bed pyrolysis of meat and bone meal Chem Eng J 121:85–96 d a fixed-bed reactor: effects of pyrolysis parameters on product yields and characterization of products. Energy 64:1002–1025
Aysu T, Küçük MM (2014) Biomass pyrolysis in a fixed-bed reactor: Effects of pyrolysis parameters on product yields and characterization of products. Energy 64:1002–1025. doi:10.1016/j.energy.2013.11.053
Ba T, Chaala A, Garcia-Perez M, Rodrigue D, Roy C (2004) Colloidal properties of bio-oils obtained by vacuum pyrolysis of softwood bark. Characterization of water-soluble and water-insoluble fractions. Energy Fuels 18:704–712
Barlin B, Gunawan G, Arifin A, Pratiwi DK (2016) Thermal evolution profile analysis for pyrolysis of coal—Acacia Mangium Wood Blends. IJTech 7(5):881–888
Bertero M, de la Puente G, Sedran U (2012) Fuels from bio-oils: bio-oil production from different residual sources, characterization and thermal conditioning. Fuel 95:263–271
Bertero M, Gorostegui HA, Orrabalis CJ, Guzmán CA, Calandri EL, Sedran U (2014) Characterization of the liquid products in the pyrolysis of residual chañar and palm fruit biomasses. Fuel 116:409–414
Bhattacharjee N (2016) Bio-oil production from fast pyrolysis of aquatic prostate herb (Achyranthes paludosa) Int J Latest Tech Eng Manag Appl Sci vol:9
Bridgwater AV (2003) Renewable fuels and chemicals by thermal processing of biomass. Chem Eng J 91:87–102
Chen T, Zhang J, Wu J (2016) Kinetic and energy production analysis of pyrolysis of lignocellulosic biomass using a three-parallel Gaussian reaction model. Bioresour Technol 211:502–508
Choi G-G, Oh S-J, Lee S-J, Kim J-S (2015) Production of bio-based phenolic resin and activated carbon from bio-oil and biochar derived from fast pyrolysis of palm kernel shells. Bioresour Technol 178:99–107
Czernik S, Bridgwater AV (2004) Overview of applications of biomass fast pyrolysis oil. Energy Fuels 18:590–598
Demiral İ, Şensöz S (2006) Fixed-bed pyrolysis of Hazelnut (Corylus Avellana L.) Bagasse: influence of pyrolysis parameters on product yields. Energy Source Part A Recovery Util Environ Eff 28:1149–1158
Donald LK (2004) Biomass for renewable energy and fuels. In: Cutler JC (ed) Encyclopedia of Energy. Elsevier, New York, pp 193–212
Effendi A, Gerhauser H, Bridgwater AV (2008) Production of renewable phenolic resins by thermochemical conversion of biomass: a review. Renew Sustain Energy Rev 12:2092–2116
Fonts I, Azuara M, Gea G, Murillo MB (2009) Study of the pyrolysis liquids obtained from different sewage sludge. J Anal Appl Pyrolysis 85:184–191
Gayubo AG, Valle B, Aguayo AT, Olazar M, Bilbao J (2010) Olefin production by catalytic transformation of crude bio-oil in a two-step process. Ind Eng Chem Res 49:123–131
Gronli MG, Várhegyi G, Di Blasi C (2002) Thermogravimetric analysis and devolatilization kinetics of wood. Ind Eng Chem Res 41:4201–4208
Gu X, Ma X, Li L, Liu C, Cheng K, Li Z (2013) Pyrolysis of poplar wood sawdust by TG–FTIR and Py–GC/MS. J Anal Appl Pyrolysis 102:16–23
Güllü D, Demirbas A (2001) Biomass to methanol via pyrolysis process. Energy Convers Manag 42:1349–1356
Isa KM, Daud S, Hamidin N, Ismail K, Saad SA, Kasim FH (2011) Thermogravimetric analysis and the optimisation of bio-oil yield from fixed-bed pyrolysis of rice husk using response surface methodology (RSM). Ind Crop Prod 33:481–487
Islam M, Beg M (2004) The fuel properties of pyrolysis liquid derived from urban solid wastes in Bangladesh. Bioresour Technol 92:181–186
Jahirul MI, Rasul MG, Chowdhury AA, Ashwath N (2012) Biofuels production through biomass pyrolysis—a technological review. Energies 5:4952–5001
Jeguirim M, Trouvé G (2009) Pyrolysis characteristics and kinetics of Arundo donax using thermogravimetric analysis. Bioresour Technol 100:4026–4031
Kan T, Strezov V, Evans TJ (2016) Lignocellulosic biomass pyrolysis: a review of product properties and effects of pyrolysis parameters. Renew Sustain Energy Rev 57:1126–1140
Kiran B, Pathak K, Kumar R, Deshmukh D (2016) Statistical optimization using central composite design for biomass and lipid productivity of microalga: a step towards enhanced biodiesel production. Ecol Eng 92:73–81
Krisnawati H, Kallio M, Kanninen M (2011) Acacia mangium Willd.: ecology, silviculture and productivity. CIFOR (C. f. I. F. Research Ed.). Indonesia
Liu S (2010) Woody biomass: niche position as a source of sustainable renewable chemicals and energy and kinetics of hot-water extraction/hydrolysis. Biotechnol Adv 28:563–582
Liu S, Amidon TE, Francis RC, Ramarao BV, Lai Y-Z, Scott GM (2006) From forest biomass to chemicals and energy Biorefinery initiative in New York State. Ind Biotechnol 2:113–120
Luo Z, Wang S, Liao Y, Zhou J, Gu Y, Cen K (2004) Research on biomass fast pyrolysis for liquid fuel. Biomass Bioenergy 26:455–462
Marsoem SN, Irawati D (2016) Basic properties of Acacia mangium and Acacia auriculiformis as a heating fuel. In: AIP Conference Proceedings, 2016. doi:10.1063/1.4958551
McKendry P (2002) Energy production from biomass (part 1): overview of biomass. Bioresour Technol 83:37–46
Meier D, Faix O (1999) State of the art of applied fast pyrolysis of lignocellulosic materials—a review. Bioresour Technol 68:71–77
Mohan D, Pittman CU, Steele PH (2006) Pyrolysis of wood/biomass for bio-oil: a critical review. Energy Fuels 20:848–889
Muley PD, Henkel C, Abdollahi KK, Marculescu C, Boldor D (2016) A critical comparison of pyrolysis of cellulose, lignin, and pine sawdust using an induction heating reactor. Energy Convers Manag 117:273–280
Önal EP, Uzun BB, Pütün AE (2011) Steam pyrolysis of an industrial waste for bio-oil production. Fuel Process Technol 92:879–885
Oramahi HA, Diba F (2013) Maximizing the production of liquid smoke from bark of durio by studying its potential compounds. Procedia Environ Sci 17:60–69
Pappa A, Tzamtzis N, Statheropoulos M, Fasseas C (2000) The pyrolytic behavior of Pinus halepensis needles observed by transmission light microscopy and stereoscopy. J Anal Appl Pyrolysis 55(2):195–202
Qu T, Guo W, Shen L, Xiao J, Zhao K (2011) Experimental study of biomass pyrolysis based on three major components: hemicellulose cellulose, and lignin. Ind Eng Chem Res 50:10424–10433
Sharma A, Pareek V, Zhang D (2015) Biomass pyrolysis—a review of modelling, process parameters and catalytic studies. Renew Sustain Energy Rev 50:1081–1096
Shen DK, Gu S, Jin B, Fang MX (2011) Thermal degradation mechanisms of wood under inert and oxidative environments using DAEM methods. Bioresour Technol 102:2047–2052
Sobeih KL, Baron M, Gonzalez-Rodriguez J (2008) Recent trends and developments in pyrolysis–gas chromatography. J Chromatogr A 1186:51–66
Turnbull JW, Midgley SJ, Cossalter C (1988) Tropical acacias planted in Asia: an overview ACIAR Proc 82
Valle B, Gayubo Ana G, Atutxa A, Alonso A, Bilbao J (2007) Integration of thermal treatment and catalytic transformation for upgrading biomass pyrolysis oil. Int J Chem React Eng. doi:10.2202/1542-6580.1559
Vamvuka D, Kakaras E, Kastanaki E, Grammelis P (2003) Pyrolysis characteristics and kinetics of biomass residuals mixtures with lignite☆. Fuel 82:1949–1960
Xiu S, Shahbazi A (2012) Bio-oil production and upgrading research: a review. Renew Sustain Energy Rev 16:4406–4414
Yorgun S, Yıldız D (2015) Slow pyrolysis of paulownia wood: effects of pyrolysis parameters on product yields and bio-oil characterization. J Anal Appl Pyrolysis 114:68–78
Zanzi R, Sjöström K, Björnbom E (2002) Rapid pyrolysis of agricultural residues at high temperature. Biomass Bioenergy 23:357–366
Zhang Q, Chang J, Wang T, Xu Y (2007) Review of biomass pyrolysis oil properties and upgrading research. Energy Convers Manag 48:87–92
Acknowledgements
The authors are grateful to the Biomass Laboratory of the Department of Thermal and Fluid Engineering, State University of Campinas, Brazil. The authors would also like to thank the anonymous reviewers and editor for their thoughtful comments that contributed to the improvement in this work.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Crespo, Y.A., Naranjo, R.A., Quitana, Y.G. et al. Optimisation and characterisation of bio-oil produced by Acacia mangium Willd wood pyrolysis. Wood Sci Technol 51, 1155–1171 (2017). https://doi.org/10.1007/s00226-017-0913-x
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00226-017-0913-x
Keywords
- Lignin
- Pyrolysis
- Hemicellulose
- Pyrolysis Temperature
- Biomass Pyrolysis