Abstract
This work proposes an improved DC–DC converter having modular multiport configuration for bipolar outputs using single switch. This converter has capability to be scaled for n bipolar or 2n unipolar outputs. It uses only one DC source and single switch to achieve the above-mentioned modularity, and each bipolar level employs a combination of SEPIC and Ćuk converter. This helps in generating one bipolar or two unipolar outputs, having opposite polarity at every port. The modularity of this converter depends on the switch rating. The proposed converter can have n outputs depending on the voltage and current rating of switch used. Key advantages of the proposed converter are (1) reduced component count, (2) Self-balancing of output side capacitor voltage levels, (3) no cross-regulation and (4) low ripple in input and output current both. It makes this converter suitable for low voltage application. To improve the system response during dynamic load change, control scheme has been designed. Stability analysis for the control system has been presented. The proposed converter is validated experimentally up to 2 kW load rating to analyse the feasibility of the proposed modular configuration.
Similar content being viewed by others
References
Chen G, Liu Y, Qing X, Ma M, Lin Z (2021) Principle and topology derivation of single-inductor multi-input multi-output DC–DC converters. IEEE Trans Ind Electron 68(1):25–36. https://doi.org/10.1109/TIE.2020.2965490
Pal S, Singh B, Shrivastava A, Chandra A, Kamal-Al-Haddad (2015) Improved power quality opto-couplerless Cuk converter for flickerless LED lighting. In: 2015 IEEE Energy Convers Congr Expo ECCE. pp 3239–3246 https://doi.org/10.1109/ECCE.2015.7310115
Wang Y, Qi N, Guan Y, Cecati C, Xu D (2017) A single-stage LED driver based on SEPIC and LLC circuits. IEEE Trans Ind Electron 64(7):5766–5776. https://doi.org/10.1109/TIE.2016.2613921
Dong Z, Li Z, Li XL, Tse CK, Zhang Z (2021) Single-inductor multiple-input multiple-output converter with common ground, high scalability, and no cross-regulation. IEEE Trans Power Electron 36(6):6750–6760. https://doi.org/10.1109/TPEL.2020.3036704
Dong Z, Tse CK, Hui SYR (2018) Current-source-mode single-inductor multiple-output LED driver with single closed-loop control achieving independent dimming function. IEEE J Emerg Sel Top Power Electron 6(3):1198–1209. https://doi.org/10.1109/JESTPE.2018.2831686
Kumari N, Kumar SS, Laxmi V (2021) Design of an efficient bipolar converter with fast MPPT algorithm for DC nanogrid application. Int J Circuit Theory Appl 49(9):2812–2839. https://doi.org/10.1002/cta.3020
Trevisan D, Mattavelli P, Tenti P (2008) Digital control of single-inductor multiple-output step-down DC–DC converters in CCM. IEEE Trans Ind Electron 55(9):3476–3483. https://doi.org/10.1109/TIE.2008.921234
Dongsheng M, Wing-Hung K, Chi-Ying T, Mok PKT (2003) Single-inductor multiple-output switching converters with time-multiplexing control in discontinuous conduction mode. IEEE J Solid-State Circuits 38(1):89–100. https://doi.org/10.1109/JSSC.2002.806279
Ma D, Ki W-H, Tsui C-Y (2003) A pseudo-CCM/DCM SIMO switching converter with freewheel switching. IEEE J Solid-State Circuits 38(6):1007–1014. https://doi.org/10.1109/JSSC.2003.811976
Ma D, Ki W-H (2007) Fast-transient PCCM switching converter with freewheel switching control. IEEE Trans Circuits Syst II Express Briefs 54(9):825–829. https://doi.org/10.1109/TCSII.2007.900903
Chen B-W, Chang-Chien L-R (2015) Digitally controlled low cross-regulation single-inductor dual-output (SIDO) buck converter. IEEE Int Symp Circuits Syst (ISCAS) 2015:2497–2500. https://doi.org/10.1109/ISCAS.2015.7169192
Fuzato GHF, Aguiar CR, Bastos RF, Machado RQ (2018) Evaluation of an interleaved boost converter powered by fuel cells and connected to the grid via voltage source inverter. IET Power Electron 11:10. https://doi.org/10.1049/iet-pel.2017.0788
Rigogiannis N, Voglitsis D, Papanikolaou N (2018) Microcontroller based implementation of peak current control method in a bidirectional buck-boost DC–DC converter. In: 2018 20th International Symposium on Electrical Apparatus and Technologies (SIELA), pp 1–4 https://doi.org/10.1109/SIELA.2018.8447148.
Rigogiannis N, Voglitsis D, Jappe T, Papanikolaou N (2020) Voltage transients mitigation in the DC distribution network of more/all electric aircrafts. Energies 13(16):4123. https://doi.org/10.3390/en13164123
Nathan K, Ghosh S, Siwakoti Y, Long T (2019) A new DC–DC converter for photovoltaic systems: coupled-inductors combined Cuk-SEPIC converter. IEEE Trans Energy Convers 34(1):191–201. https://doi.org/10.1109/TEC.2018.2876454
Siwakoti YP, Blaabjerg F (2018) Common-Ground-Type Transformerless Inverters for Single-Phase Solar Photovoltaic Systems. IEEE Trans Ind Electron 65(3):2100–2111. https://doi.org/10.1109/TIE.2017.2740821
Chen W, Yang X, Zhang W, Song X (2016) Leakage current calculation for PV inverter system based on a parasitic capacitor model. IEEE Trans Power Electron, pp 1–1 https://doi.org/10.1109/TPEL.2016.2517740.
Khan MNH, Forouzesh M, Siwakoti YP, Li L, Kerekes T, Blaabjerg F (2020) Transformerless inverter topologies for single-phase photovoltaic systems: a comparative review. IEEE J Emerg Sel Top Power Electron 8(1):805–835. https://doi.org/10.1109/JESTPE.2019.2908672
Mansouri O, Aroquiadassou G, Mabwe AM (2013) Common-mode voltage reduction in static inverter using a pre-calculated switching method. In: IECON 2013 - 39th Annual Conference of the IEEE Industrial Electronics Society, pp 1992–1997 https://doi.org/10.1109/IECON.2013.6699437.
Bae Y, Kim R-Y (2014) Suppression of common-mode voltage using a multicentral photovoltaic inverter topology with synchronized PWM. IEEE Trans Ind Electron 61(9):4722–4733. https://doi.org/10.1109/TIE.2013.2289905
Bayrak G, Ghaderi D, Subramaniam U (2020) Leakage current repression and real-time spectrum analysis with chirp Z-transform for a novel high-efficiency PV-based inverter applicable in micro-grids. Electr Eng 102(4):2041–2057. https://doi.org/10.1007/s00202-020-01002-w
Jha A, Singh B (2018) Bridgeless SEPIC PFC converter for multistring LED driver. J Inst Eng Ser B 99(4):353–367. https://doi.org/10.1007/s40031-018-0328-6
Kathiresan R, Xiong TM, Panda SK, Das P, Reindl T (2016) A non-isolated converter design with time-multiplexing control topology for un-binned high-power LEDs in parallel operation for off-grid solar-PV streetlamps. In: 2016 IEEE International Conference on Sustainable Energy Technologies (ICSET), pp 359–363 https://doi.org/10.1109/ICSET.2016.7811810
Wu H, Wong S-C, Tse CK, Chen Q (2019) A PFC single-coupled-inductor multiple-output LED driver without electrolytic capacitor. IEEE Trans Power Electron 34(2):1709–1725. https://doi.org/10.1109/TPEL.2018.2829203
Bento F, Cardoso AJM (2019) Sensorless current control of large-scale LED lighting systems based on SIMO LED drivers. In: IECON 2019 - 45th Annual Conference of the IEEE Industrial Electronics Society, pp 4280–4285 https://doi.org/10.1109/IECON.2019.8927268.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
All authors declare that they have no conflict of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Kumari, N., Kumar, S.S. & Laxmi, V. Self-balanced single-inductor single-input multiple-output bipolar DC–DC converter based on SEPIC-Ćuk combination with no cross-regulation. Electr Eng 105, 1267–1285 (2023). https://doi.org/10.1007/s00202-022-01730-1
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00202-022-01730-1