# Reducing neutral-point voltage fluctuation in NPC three-level active power filters

- 114 Downloads

## Abstract

Shunt active power filters (SAPFs) have been widely used to improve power quality of the grid by mitigating harmonics injected from nonlinear loads. This paper presents a new method for improving the performance of SAPFs using neutral-point-clamped (NPC) three-level inverters. NPC three-level inverters often suffer excessive voltage fluctuations at the neutral-point of DC-link capacitors, which may damage switching devices and cause additional high harmonic distortion of the output voltage. In order to solve the problem, two compensating schemes are proposed to restrict voltage fluctuation in the inverters. The first is voltage dependent, adopting a voltage compensation method, while the second is current dependent, using a current compensation method. The paper describes the respective circuit architectures and principles of operation. Corresponding models are mathematically formulated and evaluated under typical balanced and unbalanced working load conditions. The results show that both schemes are able to alleviate considerably voltage oscillations and hence harmonic distortions, and the current-compensated NPC inverter outperforms the voltage-compensated NPC inverter. Consequently, it is shown that the proposed approaches are effective and feasible for improving power quality of the grid when connected to nonlinear loads.

## Keywords

Shunt active power filter (SAPF) Three-level inverter Neutral-point-clamped (NPC) DC-link Voltage compensation Current compensation## Abbreviations

- SAPF
Shunt active power filters

- NPC
Neutral point clamped

- DG
Distributed generation

- PV
Photovoltaics

- THD
Total harmonic distortion

- SVPWM
Space voltage vector pulse-width modulation

- VNPCI
Voltage-dependent NPC three-level inverter

- CNPCI
Current-controlled NPC three-level inverter

- IGBT
Insulated gate bipolar transistor

- \(u_\mathrm{sa}, u_\mathrm{sb}, u_\mathrm{sc}\)
Three-phase alternating-current supply

- \(i_\mathrm{sa}, i_\mathrm{sb}, i_\mathrm{sc}\)
Grid currents

- \(i_\mathrm{La}, i_\mathrm{Lb}, i_\mathrm{Lc}\)
Load currents

- \(i_\mathrm{ca}, i_\mathrm{cb}, i_\mathrm{cc}\)
Compensation currents provided by the SAPF

- \(u_\mathrm{o}\)
Neutral-point voltage of the three-phase bridge arm

- \(u_\mathrm{N}\)
Neutral-point voltage of the DC-link capacitors

- \(u_\mathrm{c}\)
Voltage of the primary side of the transformer

- \(u_\mathrm{b}\)
Compensating voltage

- \(u_\mathrm{s}\)
DC-link voltage applied across the capacitors

- \(S_{1}, S_{2}, S_{3}, S_{4}\)
IGBT power switches

*T*Coupling transformer

*L*, \({C}_{f}\)LC filter

- \(u_\mathrm{dc}\)
DC voltage applied to the single-phase full-bridge inverter

- \(u_{i}\)
Voltage output of the single-phase inverter

- \(i_{1}\)
Current through the filter inductor

- \(i_{2}\)
Transformer primary side current

- \(i_\mathrm{cf}\)
Current through the filter capacitor

- \({D}_{1}\)
Diode used to prevent reverse current flow

- \({L}_{2}, {C}_{3}\)
LC filter

- \(u_\mathrm{dc1}\)
Voltage input of the boost DC/DC converter

- \(u_\mathrm{dc2}\)
Voltage output of the boost DC/DC convertor

- \(i_{\mathrm{c3(off})}\)
Current in capacitor \({C}_{3}\) when switching device \({S}_{5}\) is turned off

- \(i_{3}\)
Current in the inductor \({L}_{1}\)

- \(i_{4}\)
Compensating current

- \(u_{\mathrm{L1(off})}\)
Voltage across the inductor \({L}_{1}\) when switching device \({S}_{5}\) is turned off

- \(u_{\mathrm{L1(on})}\)
Voltage across inductor \({L}_{1}\) when switch \({S}_{5}\) is turned on

*D*Duty cycle of the switching device \({S}_{5}\)

- \(K_{p}, K_{i}\)
Parameters of the PI controller

## References

- 1.Pepermans G, Driesen J, Haeseldonckx D, Belmans R, D’haeseleer W (2005) Distributed generation: definition, benefits and issues. Energy Policy 33:787–798CrossRefGoogle Scholar
- 2.Pouresmaeil E, Montesinos-Miracle D, Gomis-Bellmunt O, Sudrià-Andreu A (2011) Instantaneous active and reactive current control technique of shunt active power filter based on the three-level NPC inverter. Int Trans Electric Energy Syst 21:2007–2022Google Scholar
- 3.Allmeling JH (2004) A control structure for fast harmonics compensation in active filters. IEEE Trans Power Electron 19(2):508–514CrossRefGoogle Scholar
- 4.Liang W, Donglai Z, Yi W, Bin W, Hussain SA (2016) Power and voltage balance control of a novel three-phase solid-state transformer using multilevel cascaded H-bridge inverters for microgrid applications. IEEE Trans Power Electron 31(4):3289–3301CrossRefGoogle Scholar
- 5.Roodsari BN, Nowicki EP (2013) Fast space vector modulation algorithm for multilevel inverters and its extension for operation of the cascaded H-bridge inverter with non-constant DC sources. IET Power Electron 6:1288–1298CrossRefGoogle Scholar
- 6.Ke M, Frede B (2012) The impact of power switching devices on the thermal performance of a 10 MW wind power NPC converter. Energies 5(7):2559–2577CrossRefGoogle Scholar
- 7.Muyeen SM, Takahashi R, Tamura J (2010) Wind power and hydrogen generation system with cooperatively controlled three-level NPC-VSC based energy capacitor. Int Trans Electric Energy Syst 20:1071–1081Google Scholar
- 8.Zaveri T, Bhalja BR, Zaveri N (2012) Load compensation using DSTATCOM in three-phase, three-wire distribution system under various source voltage and delta connected load conditions. Int J Electric Power Energy Syst 41:34–43CrossRefGoogle Scholar
- 9.Saad S, Zellouma L (2009) Fuzzy logic controller for three-level shunt active filter compensating harmonics and reactive power. Electric Power Syst Res 79:1337–1341CrossRefGoogle Scholar
- 10.Celanovic N, Boroyevich D (2000) A comprehensive study of neutral-point voltage balancing problem in three-level neutral-point-clamped voltage source PWM inverters. IEEE Trans Power Electron 15:242–249CrossRefGoogle Scholar
- 11.Ui-Min C, Frede B, Kyo-Beum L (2015) Method to minimize the low-frequency neutral-point voltage oscillations with time-offset injection for neutral-point-clamped inverters. IEEE Trans Ind Appl 51:1678–1691CrossRefGoogle Scholar
- 12.Rodriguez J, Bernet S (2010) A survey on neutral-point-clamped inverters. IEEE Trans Ind Electron 57:2219–2230CrossRefGoogle Scholar
- 13.Helle L, Nielsen SM, Enjeti P (2002) Generalized discontinuous DC-link balancing modulation strategy for three-level inverters. In: Power conversion conference, Osaka, Japan, vol 2, pp 359–366Google Scholar
- 14.Yazdani A, Iravani R (2005) Generalized state-space averaged model of the three-level NPC converter for systematic DC-voltage-balancer and current-controller design. IEEE Trans Power Deliv 20:1105–1114CrossRefGoogle Scholar
- 15.Zaragoza J, Pou J, Ceballos S, Robles E, Jaen C (2009) Voltage-balance compensator for a carrier-based modulation in the neutral-point-clamped converter. IEEE Trans Ind Electron 56:305–314CrossRefGoogle Scholar
- 16.Ui-Min C, June-Seok L, Kyo-Beum L (2014) New modulation strategy to balance the neutral-point voltage for three-level neutral-clamped inverter systems. IEEE Trans Energy Convers 29:91–100CrossRefGoogle Scholar
- 17.Pulikanti SR, Dahidah SA (2011) Voltage balancing control of three-level active NPC converter using SHE-PWM. IEEE Trans Power Deliv 26:258–267CrossRefGoogle Scholar
- 18.Ghennam T, Berkouk EM, Francois B (2010) A novel space–vector current control based on circular hysteresis areas of a three-phase neutral point-clamped inverter. IEEE Trans Ind Electron 57:2669–2678CrossRefGoogle Scholar
- 19.Lewicki A, Krzeminski Z, Abu-Rub H (2011) Space–vector pulse width modulation for three-level NPC converter with the neutral point voltage control. IEEE Trans Ind Electron 58:5076–5086CrossRefGoogle Scholar
- 20.Xiyou C, Kazerani M (2006) Space vector modulation control of an AC–DC–AC converter with a front-end diode rectifier and reduced dc-link capacitor. IEEE Trans Power Electron 21:1470–1478CrossRefGoogle Scholar
- 21.Huibin Z, Finney SJ, Massoud A, Williams BW (2008) An SVM algorithm to balance the capacitor voltages of the three-level NPC active power filter. IEEE Trans Power Electron 23:2694–2702CrossRefGoogle Scholar
- 22.Bouhali O, Francois B, Berkouk EM (2007) DC link capacitor voltage balancing in a three-phase diode clamped inverter controlled by a direct space vector of line-to-line voltages. IEEE Trans Power Electron 22:1636–1648CrossRefGoogle Scholar
- 23.Dongsheng Z, Didier GR (2001) Experimental comparisons of space vector neutral point balancing strategies for three-level topology. IEEE Trans Power Electron 16:872–879CrossRefGoogle Scholar
- 24.Nikola C, Dushan B (2000) A comprehensive study of neutral-point voltage balancing problem in three-level neutral-point-clamped voltage source PWM inverters. IEEE Trans Power Electron 15:242–249Google Scholar
- 25.Sergio B, Josep B, Dushan B, Sergio S (2004) The nearest three virtual space vector PWM–A modulation for the comprehensive neutral-point balancing in the three-level NPC inverter. IEEE Power Electron Lett 2:11–15CrossRefGoogle Scholar
- 26.Mishra MK, Joshi A, Ghosh A (2003) Control schemes for equalization of capacitor voltages in neutral clamped shunt compensator. IEEE Trans Power Deliv 18:538–544CrossRefGoogle Scholar
- 27.Yong L, Yanjian P, Fang L, Denis S, Daniil P, Chonggan L, Long L, Yijia C (2016) A controllably inductive filtering method with transformer-integrated linear reactor for power quality improvement of shipboard power system. In: IEEE transactions on power deliveryGoogle Scholar
- 28.Shengwei L, Yongli L, Jingliao S, Qiang J, Xuguang L (2009) A novel control algorithm for inverter-based distributed generation in unbalanced three phase power systems, In: International conference on sustainable power generation and supply, Nanjing, China, pp 1–6Google Scholar