Skip to main content

The elastic–plastic behaviour of foam under shock loading

Shock Waves volume 23, pages 55–67 (2013)Cite this article

Abstract

An experimental investigation of the elastic–plastic nature of shock wave propagation in foams was undertaken. The study involved experimental blast wave and shock tube loading of three foams, two polyurethane open-cell foams and a low-density polyethylene closed-cell foam. Evidence of precursor waves was observed in all three foam samples under various compressive wave loadings. Experiments with an impermeable membrane are used to determine if the precursor wave in an open-cell foam is a result of gas filtration or an elastic response of the foam. The differences between quasi-static and shock compression of foams is discussed in terms of their compressive strain histories and the implications for the energy absorption capacity of foam in both loading scenarios. Through a comparison of shock tube and blast wave loading techniques, suggestions are made concerning the accurate measurements of the principal shock Hugoniot in foams.

This is a preview of subscription content, access via your institution.

Access options

Buy single article

Instant access to the full article PDF.

USD 39.95

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16

References

  1. Gibson, L.J., Ashby, M.F.: Cellular Solids: Structure and Properties. Pergamon, New York (1988)

    MATH  Google Scholar 

  2. Nerenberg, J.G.: Blast Wave Loading of Polymeric Foams. McGill University, M.Eng. Thesis (1998)

  3. Kitagawa, K., Takayama, K., Yasuhara, M.: Attenuation of shock waves propagating in polyurethane foams. Shock Waves 15, 437–445 (2006)

    Article  Google Scholar 

  4. Ouellet, S., Cronin, D.S., Worswick, M.: Compressive response of polymeric foams under quasi-static, medium and high strain rate conditions. Polymer Test. 25, 731–743 (2006)

    Article  Google Scholar 

  5. Seitz, M.W., Skews, B.W.: Effect of compressible foam properties on pressure amplification during shock wave impact. Shock Waves 15, 177–197 (2006)

    Article  Google Scholar 

  6. Drumheller, D.S.: Introduction to Wave Propagation in Nonlinear Fluids and Solids. Cambridge University Press, Cambridge (1998)

    Book  Google Scholar 

  7. Meyers, M.A.: Dynamic Behavior of Materials. Wiley, New York (1994)

    Book  MATH  Google Scholar 

  8. Davison, L.: Fundamentals of Shock Wave Propagation in Solids. Springer, Berlin (2008)

    MATH  Google Scholar 

  9. Gvozdeva, L.G., Faresov, Yu.M.: Approximate calculation of steady-state shock wave parameters in porous compressible materials. J. Appl. Mech. Tech. Phys. 27(1), 107–111 (1986)

    Google Scholar 

  10. Henderson, L.F., Virgona, R.J., Di, J., Gvozdeva, L.G.: Refraction of a normal shock wave from nitrogen into polyurethane foams. In: Current Topics in Shock Waves, AIP Conference Proceedings, vol. 208, pp. 814–818. American Institute of Physics, New York (1990)

  11. Skews, B.W.: The reflected pressure field in the interaction of weak shock waves with a compressible foam. Shock Waves 1, 205–211 (1991)

    Article  Google Scholar 

  12. Harrigan, J.J., Reid, S.R., Yaghoubi, A.S.: The correct analysis of shocks in a cellular material. Int. J. Impact Eng. 37, 918–927 (2010)

    Google Scholar 

  13. Li, Q.M., Meng, H.: Attenuation or enhancement a one-dimensional analysis on shock transmission in the solid phase of a cellular material. Int. J. Impact Eng. 27, 1049–1065 (2002)

    Article  Google Scholar 

  14. Gao, Z.Y., Yu, T.X.: One-dimensional analysis on the dynamic response of cellular chains to pulse loading. Proc. Inst. Mech. Eng. Part C J. Mech. Eng. Sci. 220(5), 679–689 (2006)

    Article  Google Scholar 

  15. Zaretsky, E., Asaf, Z., Ran, E., Aizik, F.: Impact response of high density flexible polyurethane foam. Int. J. Impact Eng. 39, 1–7 (2012)

    Article  Google Scholar 

  16. Reid, S.R., Peng, C.: Dynamic uniaxial crushing of wood. Int. J. Impact Eng. 19, 531–570 (1997)

    Article  Google Scholar 

  17. Tan, P.J., Reid, S.R., Harrigan, J.J., Zou, Z., Li, S.: Dynamic compressive strength properties of aluminium foams. Part I experimental data and observations. J. Mech. Phys. Solids 53, 2174–2205 (2005)

    Google Scholar 

  18. Tan, P.J., Reid, S.R., Harrigan, J.J.: On the dynamic mechanical properties of open-cell metal foams—A re-assessment of the simple-shock theory. Int. J. Solids Struct. 49, 2744–2753 (2012)

    Google Scholar 

  19. Davison, L., Horie, Y., Shahinpoor, M.: High-Pressure Shock Compression of Solids IV: Response of Highly Porous Solids to Shock Loading. Springer, New York (1997)

    Book  Google Scholar 

  20. Zaretsky, E., Ben-Dor, G.: Compressive stress-strain relations and shock hugoniot curves of flexible foams. J. Eng. Mater. Technol. 117, 278–284 (1995)

    Article  Google Scholar 

  21. Petel, O.E., Higgins, A.J.: Shock wave propagation in dense particle suspensions. J. Appl. Phys. 108, 114918 (2010)

    Google Scholar 

  22. Davison L.: Attenuation of longitudinal elastoplastic pulses. In: High-Pressure Shock Compression of Solids III, pp. 277–328. Springer, Berlin (1997)

  23. Lopatnikov, S.L., Gama, B.A., Haque, M.J., Krauthauser, C., Gillespie Jr, J.W.: High-velocity plate impact of metal foams. Int. J. Impact Eng. 30, 421–445 (2004)

  24. Nesterenko, V.F., Afanasenko, S.I., Ipatiev, A.S., Klapovski, V.E., Grigoriev, G.S.: Shock impulse transformation by laminar porous materials (in russian). In: Proceedings X All-Union Conference on Computer Modeling of Elasticity and Plasticity Problems, pp. 231–236. Institute of Theoretical and Applied Mechanics, Novosibirsk (1988)

  25. Nesterenko, V.F.: Nonlinear Phenomena under Impulse Loading of Heterogeneous Condensed Media (in Russian). Ph.D. Thesis, Lavrentyev Institute of Hydrodynamics, Novosibirsk (1988, in Russian).

  26. Nesterenko, V.F.: Dynamics of Heterogeneous Materials. Springer, New York (2001)

    Google Scholar 

  27. Skews, B.W., Atkins, M.D., Seitz, M.W.: The impact of a shock wave on porous compressible foams. J. Fluid Mech. 253, 245–265 (1993)

    Article  Google Scholar 

  28. Yasuhara, M., Watanabe, S., Kitagawa, K., Yasue, T., Mizutani, M.: Experiment on effects of porosity in the interaction of shock wave and foam. JSME Int. J. Ser. B 39(2), 287–293 (1996)

    Article  Google Scholar 

  29. Skews, B.W.: Experimental studies of shock wave interactions with porous media. In: Shock Wave Science and Technology Reference Library, pp. 271–295. Springer, Berlin (2007)

  30. Lagutov, Y.P., Gvozdeva, L.G., Sharov, Y.L., Sherbak, N.B.: Experimental investigation of gas percolation through porous compressible material under the effect of shock wave. Phys. A 241, 111–117 (1997)

    Article  Google Scholar 

  31. Britan, A., Ben-Dor, G., Elperin, T., Igra, O., Jiang, J.P.: Mechanism of compressive stress formation during weak shock waves impact with granular materials. Exp. Fluids 22, 507–518 (1997)

    Article  Google Scholar 

  32. Ben-Dor, G., Britan, A., Elperin, T., Igra, O., Jiang, J.P.: Experimental investigation of the interaction between weak shock waves and granular layers. Exp. Fluids 22(5), 432–443 (1997)

    Article  Google Scholar 

  33. Britan, A., Ben-Dor, G.: Shock tube study of the dynamical behavior of granular materials. Int. J. Multiphase Flow 32, 623–642 (2006)

    Article  MATH  Google Scholar 

  34. Fowles, R., Williams, R.F.: Plane stress wave propagation in solids. J. Appl. Phys. 41(1), 360–363 (1970)

    Google Scholar 

  35. Fowles, G.R.: Shock wave compression of hardened and annealed 2024 aluminum. J. Appl. Phys. 32(8), 1475–1487 (1961)

    Google Scholar 

  36. Curran, D.R.: Nonhydrodynamic attenuation of shock waves in aluminum. J. Appl. Phys. 34(9), 2677–2685 (1963)

    Article  Google Scholar 

  37. Cooper, P.: Explosives Engineering. Wiley, New York (1996)

    Google Scholar 

  38. Davison, L., Graham, R.A.: Shock compression of solids. Phys. Rep. 55(4), 255–379 (1979)

    Article  Google Scholar 

  39. Petel, O.E., Jetté, F.X., Goroshin, S., Frost, D., Ouellet, S.: Blast wave attenuation through a composite of varying layer distribution. Shock Waves 21(3), 215–224 (2011)

    Article  Google Scholar 

  40. Mazor, G., Ben-Dor, G., Igra, O., Sorek, S.: Shock wave interaction with cellular materials. Part I: analytical investigation and governing equations. Shock Waves 3, 159–165 (1994)

    Article  MATH  Google Scholar 

  41. Zheng, Z., Liu, Y., Yu, J., Reid, S.R.: Dynamic crushing of cellular materials: continuum-based wave models for the transitional and shock modes. Int. J. Impact Eng. 42, 66–79 (2012)

    Article  Google Scholar 

  42. Gel’fand, B.E., Gubin, S.A., Kogarko, S.M., Popov, O.E.: Investigation of the special characteristics of the propagation and reflection of pressure waves in a porous medium. J. Appl. Mech. Tech. Phys. 6, 74–77 (1975)

    Google Scholar 

  43. Levy, A., Ben-Dor, G., Skews, B.W., Sorek, S.: Head-on collision of normal shock waves with rigid porous materials. Exp. Fluids 15, 183–190 (1993)

    Article  Google Scholar 

  44. Ben-Dor, G., Mazor, G., Igra, O., Sorek, S., Onodera, H.: Shock wave interaction with cellular materials. Part ii: open cell foams; experimental and numerical results. Shock Waves 3, 167–179 (1994)

    Article  Google Scholar 

  45. Cooper, G.J., Townend, D.J., Cater, S.R., Pearce, B.P.: The role of stress waves in thoracic visceral injury from blast loading: modification of stress transmission by foams and high-density materials. J. Biomech. 24(5), 273–285 (1991)

    Article  Google Scholar 

Download references

Acknowledgments

The authors would like to thank Jacques Blais of Defence Research and Development Canada Valcartier for his assistance in producing the SEM images of the foams. The authors are grateful to Jeffrey Nerenberg for the provision of some data from his M.Eng. Thesis, to Samuel Goroshin for assistance with the blast wave experiments, as well as to François Jetté, Jason Loiseau, and Vitali Nesterenko for useful discussions related to this topic. The authors would also like to thank Gaby Ciccarelli for providing some of the shock tube data used in the present study and Duane Cronin for providing the low-rate compression data for LD45.

Author information

Authors and Affiliations

  1. Department of Mechanical Engineering, McGill University, 817 Sherbrooke W., Montréal, QC, H3A 2K6, Canada

    O. E. Petel, A. J. Higgins & D. L. Frost

  2. Defence Research and Development Canada Valcartier, 2459 Pie XI Nord, Val-Bélair, QC, G3J 1X5, Canada

    S. Ouellet

Authors
  1. O. E. Petel
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. S. Ouellet
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. A. J. Higgins
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. D. L. Frost
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to O. E. Petel.

Additional information

Communicated by A. Hadjadj.

Rights and permissions

Reprints and Permissions

About this article

Cite this article

Petel, O.E., Ouellet, S., Higgins, A.J. et al. The elastic–plastic behaviour of foam under shock loading. Shock Waves 23, 55–67 (2013). https://doi.org/10.1007/s00193-012-0414-7

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00193-012-0414-7

Keywords

  • Polymeric foam
  • Shock tube
  • Blast wave
  • Elastic–plastic material
  • Gas filtration
  • Blast mitigation
  • Blast protection