Abstract
In this paper, the contribution of tool wear to the energy balance was determined for precision hard turning using chamfered CBN cutting tools. The tool nose wear VBC and the corresponding changes of component forces F c, F f and F p resulting from tool wear evolution were continuously measured during wear tests. Based on the cutting mechanics, specific cutting and ploughing energies were calculated for a number of tool wear states. In particular, changes of energy balance due to tool wear under variable feed rate, depth of cut and tool nose radius were discussed. A distinction between material removal conditions resulting from precision cutting and grinding at a very low uncut chip thickness is considered.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Davim JP (2011) Machining of hard materials. Springer, London
Byrne G, Dornfeld D, Denkena D (2003) Advancing cutting technology. CIRP Ann Manuf Technol 52(2):483–507
Tönshoff HK, Arendt C, Ben Amor R (2000) Cutting of hardened steel. CIRP Ann Manufact Technol 49(2):547–566
Dornfeld D, Lee D-E (2008) Precision machining. Springer, New York
Chinchanikar S, Choudhury SK (2015) Machining of hardened steel—experimental investigations, performance modelling and cooling techniques: a review. Int J Mach Tools Manuf 89:95–109
Li JG, Lu Y, Zhao H, Li P, Yao YX (2014) Optimization of cutting parameters for energy saving. Int J Adv Manuf Technol 70(1–4):117–124
Mativenga PT, Rajemi MF (2011) Calculation of optimum cutting parameters based on minimum energy footprint. CIRP Ann Manufact Technol 60(1):149–152
Mayer R, Köhler J, Denkena B (2012) Influence of the tool corner radius on the tool wear and process forces during hard turning. Int J Adv Manuf Technol 58(9–12):933–940
Zhou JM, Walter H, Andersson M, Stahl JE (2003) Effect of chamfer angle on wear of PCBN cutting tool. Int J Mach Tools Manuf 43(3):301–305
Chou YK, Song H (2014) Tool nose radius effect on finish hard turning. J Mater Process Technol 148(2):259–268
Boothroyd G, Knight WA (2005) Fundamentals of machining and machine tools. Taylor & Francis, New York
Abrams premium steel. Steel guide. Internet at www.steel-guide.ue
Huang Y, Chou YK, Liang S (2007) CBN tool wear in hard turning: a survey on research progress. Int J Adv Manuf Technol 34(5):443–453
Grzesik W (2008) Advanced machining processes of metallic materials. Elsevier, Amsterdam
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
Open Access This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.
About this article
Cite this article
Grzesik, W., Denkena, B., Żak, K. et al. Energy consumption characterization in precision hard machining using CBN cutting tools. Int J Adv Manuf Technol 85, 2839–2845 (2016). https://doi.org/10.1007/s00170-015-8091-1
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00170-015-8091-1