Abstract
This paper presents a 3D formalization of manufacturing tolerancing which associates the concept of small displacements, the functional constraints, and manufacturing process capability. This approach would make it possible to establish relations which limit the surface variations of the production mechanism by the functional specifications. These relations have a number of requirements imposed by designer and are sufficient to evaluate the manufacturing process. The variations of the manufacturing process are defined in relation to variations measured by 3D measuring.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Wade O (1967) Tolerance control in design and manufacturing. Industrial press
Bourdet P (1973) Chaînes de côtes de fabrication. L’ingénieur et le technicien de l’enseignement technique
Anselmetti B, Bourdet P (1993) Optimization of work piece considering production requirements, Revue Computers in industry
Bouzid Sai W, Dhifalli W, Zaghal A (2006) Modelling of tolerances and manufacturing dimensions. Int J Adv Manuf Technol 31:71–77
Bourdet P, Ballot É (1995) Geometrical behavior laws for computer aided tolerancing. University of Tokyo
Bourdet P, Ballot E (1995) Équations formelles et tridimensionnelles des chaînes de dimensions dans les mécanismes. University of Tokyo
Villeneuve F, Legoff O, Landon Y (2001) Tolerancing for manufacturing: a three dimensional model. Int J Prod Res 39:1625–1648
Anselmetti B, Mejbri H, Mawussi K (2003) Coupling experimental design-digital simulation of junctions for the development of complex tolerance chains. Comput Ind 50:277–292
Anselmetti B (2006) Generation of functional tolerancing based on positioning features. Comput Aided Des 38:902–919
Laifa M, Bouzid Sai W, Hbaieb M (2013) Modeling of three-dimensional functional tolerances by small displacements torsors. Online Int J Eng Technol Res 1:7–15
Zhang J, Qiao L (2013) Three dimensional manufacturing tolerance design using convex sets. Procedia CIRP 10:259–266
Xu S, Keyser J (2014) Geometric computation and optimization on tolerance dimensioning. Comput Aided Des 46:129–137
Franciosa P, Patalano S, Riviere A (2010) 3D tolerance specification: an approach for the analysis of the global consistency based on graphs. Int J Interact Des Manuf 4:1–10
Anselmetti B (2005), Génération de la cotation de fabrication en normes ISO. Casablanca, Morocco
Ballu A, Plantec JY, Mathieu L (2008) Geometrical reliability of overconstrained mechanisms with gaps. CIRP Ann Manuf Technol 57:159–162
Radouani M, Anselmetti B (2003) Contribution à la validation du modèle des chaînes de cotes : Etude expérimentale du comportement de la liaison plan sur plan. Conception et Production Intégré, Meknès, Morocco
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Laifa, M., Sai, W.B. & Hbaieb, M. Evaluation of machining process by integrating 3D manufacturing dispersions, functional constraints, and the concept of small displacement torsors. Int J Adv Manuf Technol 71, 1327–1336 (2014). https://doi.org/10.1007/s00170-013-5558-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00170-013-5558-9