Abstract
In order to make clear the effects of mirror grinding conditions on the ground surfaces in the surface mirror grinding of sintered carbide adopting an in-process electrolytic dressing method, experiments are conducted to measure the vibration signals of the workpiece during grinding and the profile of the ground surface. It is found that components with low frequency vibration signals have a very close relation to the undulation of a ground surface and components with high frequencies to the surface roughness .
Similar content being viewed by others
References
Bifano TG, Dow TA (1991) Ductile-regime grinding: a new technology for machining brittle materials. Trans ASME J Eng Ind 113:184–189
Inasaki I (1987) Grinding of hard and brittle materials. Ann CIRP 36(2):463–471
Ohmori H, Nakagawa T (1990) Mirror surface grinding on silicon wafers with electrolytic in-process dressing. Ann CIRP 39:329–332
Kim JD, Lee ES (1995) Development of optimization in-process electrolytic dressing, and characteristics by control. Korean Soc Mech Eng 19(3):680–687
Ohmori H, Nakagawa T (1990) Analysis of mirror surface generation of hard and brittle materials by Electrolytic In-Process Dressing(ELID) grinding with superfine grain metallic bond wheels. Ann CIRP 39:329–332
Kato H, Uetake A (1985) Generation of chatter marks in surface grinding by using horizontal spindle-reciprocation table type machine. Bull Soc Eng 19(4):266–272
Hoshi T, et al. (1986) Suppression of wheel regenerative grinding vibration by alternating wheel speed. Ann CIRP 35(1):231–234
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kim, Jd., Lee, Dh. & Lee, Kb. The effects of dynamic characteristics on the surface texture in mirror grinding. Int J Adv Manuf Technol 27, 274–280 (2005). https://doi.org/10.1007/s00170-004-2177-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00170-004-2177-5