Abstract
This work investigates the roundness of holes by application of Taguchi methods to BTA deep-hole drilling with reference to process factors. Taguchi methods and statistical techniques are used in experimental layout, in the analysis of each control factor, and in prediction of the optimum setting for control factors. A set of confirmatory tests is then conducted to verify the estimated response. Influences of the control factors are discussed, and the levels of factors that produce holes of desired roundness with sufficient robustness are presented.
Similar content being viewed by others
References
Rao PKR, Shunmugam MS (1987a) Accuracy and surface finish in BTA drilling. Int J Prod Res 25(1):31–44
Rao PKR, Shunmugam MS (1987b) Investigation: stress in boring trepanning association machining. Wear 119:89–100
Rao PKR, Shunmugam MS (1987c) Analysis of axial and transverse profiles of holes obtained in B.T.A. machining. Int J Mach Tools Manuf 27:505–515
Rao PKR, Shunmugam MS (1988) Wear studies in boring trepanning associationdrilling. Wear 124:33–43
EI-Khabeery MM, Saleh SM, Ramadan MR (1991) Some observations of surface integrity of deep drilling holes. Wear 142:331–349
Montgomery DC (1984) Design and analysis of experiments, Wiley, New York
Ross PJ (1989) Taguchi techniques for quality engineering. McGraw-Hill, New York
Bryne DM, Taguchi S (1989) The Taguchi approach to parameter design. In: Bendell S, Disney J, Pridmore WA (eds) Taguchi methods: applications in world industry. IFS, London
Fisher RA (1925) Statistical methods for research worker. Oliver & Boyd, London
Montgomery DC (1985) Introduction to statistical quality control. Wiley, New York
Chandrashekhar S, Osman MOM, Sankar TS (1984) An analytical time domain evaluation of the cutting forces in BTA deep hole machining using the thin shear plane model. Int J Prod Res 22(2):697–721
Shigley JE, Mischke CR (1989) Mechanical engineering design. McGraw-Hill, Singapore
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Deng, CS., Chin, JH. Hole roundness in deep-hole drilling as analysed by Taguchi methods. Int J Adv Manuf Technol 25, 420–426 (2005). https://doi.org/10.1007/s00170-003-1825-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00170-003-1825-5