Experimental protocol
Since in our previous study the most pronounced beneficial effects on diffuse alveolar damage (DAD) were observed at moderately high concentrations of PFH, the present work compared the animals of the GV, PLV, and 5% PFH groups. The detailed protocol of the animal experiments was described in our previous work [8] and is presented in the Electronic Supplementary Material (ESM) accompanying this article. Briefly, 18 piglets (30.9 ± 3.3 kg) were anesthetized and ventilated with an FIO2 of 1.0, PEEP 5 cmH2O, inspiratory/expiratory ratio 1:1.7, and tidal volume 9 ml/kg. Respiratory rates were adjusted to achieve a PaCO2 of 35–45 mmHg at baseline and maintained unchanged thereafter. Following instrumentation lung injury was induced by central venous infusion of oleic acid until the PaO2/FIO2 ratio fell below 200 mmHg and did not improve spontaneously within 30 min. After lung injury animals were randomly assigned to one of the following groups (n = 6 each): (a) GV, (b) PLV with 30 ml/kg perfluoroctane, (c) administration of PFH. Two hours after randomization a decremental PEEP trial was performed, and PEEP was set according to the minimal lung elastance (open lung approach). Ventilator settings were then kept constant for a further 4 h, yielding a total observation period of 6 h.
PFH (C6F14; ABCR, Karlsruhe, Germany) was administered by means of two standard bypass vaporizers type 19n (Drägerwerke, Lübeck, Germany). PLV was performed after careful instillation of 30 ml/kg perfluorooctane (C8F18; ABCR) into the trachea (functional residual capacity dose). Gas exchange, lung mechanics, and functional residual capacity (only PFH and GV groups) were assessed at baseline, after induction of lung injury (t
0), 2 h thereafter (t
2) and 2 (t
4) and 4 h after adjustment of PEEP (t
4) using standard procedures which are described in detail in the ESM. Finally, animals were killed by means of intravenous boluses of thiopental (2 g) and KCl (50 mEq) and the lungs extracted at atmospheric pressure for further analysis.
Tissue processing
Tissue samples were taken from central and peripheral regions in the upper and lower lobes of the right lungs at atmospheric pressure according to a standardized protocol. Blocks of lung tissue (approx. 8 cm3) were taken from the outermost apex of both right upper and lower lobes, representing peripheral regions and from central areas, using the proximal part of the lobar bronchus as anatomical landmark. In a simplified manner lung specimens taken from the upper lobes representing gravitational nondependent (ventral) regions, whereas specimens of the lower lobes stood for gravitational dependent (dorsal) lung regions. Samples of each region were fixed by immersion in a 4% buffered formaldehyde solution, embedded in paraffin, stained with hematoxylin-eosin, and cut in slices for morphometric and histological analysis according to routine histological procedures.
Digital image processing
Photomicrographs were obtained from four nonoverlapping fields of view per section using a light microscope (DM RB, Leica, Wetzlar, Germany). Images were digitized and processed by means of a computer-based system and image-analyzing software (AnalySIS, version 3.1, Soft Imaging System, Münster, Germany). For morphometric analysis digitized photomicrographs were binarized, with black portions representing parenchyma, edema, or infiltration (nonaerated) and white portions representing aerated areas. Raster electron-microscopy was performed in representative lung specimen using a scanning electron microscope (LEO S430, Carl Zeiss, Oberkochen, Germany).
Histological analysis
DAD was quantified by an expert in lung pathology blinded to the experimental protocol and the therapy groups using a weighted scoring system described in detail in the ESM. Structural effects on lung parenchyma were determined by systematic morphometric quantification of chord length and area in air in the binarized photomicrographs using standard tools of the image-analyzing system.
Statistical analysis
Statistical procedures used are shown in detail in the ESM. Values of PEEP, amount of oleic acid, and time to achieve injury were compared using one-way analysis of variance. Effects of injury on functional variables (baseline vs. t
0) were determined by paired t test, and their time courses were tested using analysis of variance with repeated measures followed by post-hoc analysis (Student-Newmann-Keuls test). The t test and analysis of variance used the software SPSS version 11.5 (SPSS, Chicago, Ill., USA). The regional distribution of DAD score characteristics and morphometric correlates were determined by means of mixed linear models with repeated measures (procedure mixed, SAS version 8, SAS Institute, Cary, N.C., USA). Differences between means were tested by the post-hoc Tukey-Kramer test. The global significance level was 0.05 in all performed tests.