Abstract
The milling process of Arboform was analysed by cutting force measurements and compared with experiments on MDF and chipboard. Under similar and practice-specific conditions, the specific cutting forces of Arboform were slightly higher than the ones of MDF and chipboard but below the values for HDF taken from literature.
Similar content being viewed by others
Literatur
Burkhardt-Karrenbrock A, Seegmüller S, Burk R (2001) Flüssigholz – Ein Überblick. Holz Roh- Werkst 59:13–18
Gottlöber C (2003) Ein Weg zur Optimierung von Spanungsprozessen am Beispiel des Umfangplanfräsens von Holz und Holzwerkstoffen. Dissertation, TU Dresden
Heisel U, Tröger J (2001) Untersuchungen zur Zerspanbarkeit von Arboform. HOB:210–216
Roland K (Hrsg.) (1988) Wissensspeicher Holztechnik: Grundlagen. VEB Fachbuchverlag Leipzig, Leipzig
Svoboda MA (2003) Werkstoffe aus nachwachsenden Rohstoffen. Dissertation, Montanuniversität Leoben
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Pfriem, A., Zauer, M., Oertel, M. et al. Vergleichende Untersuchungen zur Zerspanbarkeit von ligninbasierenden Werkstoffen, mitteldichten Faserplatten sowie Spanplatten . Holz Roh Werkst 66, 379–380 (2008). https://doi.org/10.1007/s00107-008-0245-5
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00107-008-0245-5