Abstract
In the frequency-response masking (FRM) approach, the complexity of two masking filters is heavily dependent on the interpolation factor and the cutoff frequencies of the bandedge shaping filter. In this paper, we propose a novel structure that decouples the masking filters from the bandedge shaping filter. The design equations together with the design procedures are presented. With the introduction of an additional decoupling stage, the complexity of the overall filter can be greatly reduced. Our example shows that more than 40% savings in the numbers of multipliers and adders can be achieved compared with the original FRM approach.
Similar content being viewed by others
Author information
Authors and Affiliations
Corresponding authors
Rights and permissions
About this article
Cite this article
Lian, Y., Yang, C. Complexity Reduction By Decoupling The Masking Filters From The Bandedge Shaping Filter In The FRM Technique. Circuits Syst Signal Process 22, 115–135 (2003). https://doi.org/10.1007/s00034-004-7023-3
Received:
Revised:
Issue Date:
DOI: https://doi.org/10.1007/s00034-004-7023-3