Abstract
The Tournemire Underground Research Laboratory (Aveyron, France), developed by the French Institute for Radiological Protection and Nuclear Safety, is composed of a tunnel excavated in an argillaceous geological layer belonging to a limestone–argillite–limestone sub-horizontal sedimentary sequence. Sub-vertical fault zones are intercepted by drifts and boreholes excavated from the tunnel in the argillaceous layer at a depth of about 250 m. These fault zones are characterized by velocities lower than those of the embedding rocks. In this study, we assess the capacity of first arrival traveltime tomography to detect and characterize such fault zones in a surface-to-depth transmission configuration with a limited angle aperture. The source at the surface is a sledgehammer and turns out to be very repetitive. The source trigger is transmitted to the acquisition bay via a VHF transmitter. Receivers are located at depth in underground works. First arrivals are clear and traveltime picking is straightforward. Before inverting real data, we conduct synthetic tests with the real acquisition geometry to assess limits and validity of first arrival traveltime tomography to detect a lower velocity fault zone using different initial configurations and inversion constraints during the inversion. We show that introducing a priori information on velocities in the shallow subsurface, limestones and argillaceous layers and constraints on maximum velocities greatly helps improving results and subsequent interpretation. Velocities obtained from the real data display a main lower velocity zone that extends from the galleries in the argillaceous layer right up to the surface in limestones. The location and extension of this lower velocity zone are consistent with fault and fracture zones mapped from geological observations.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Baina, R., & Podvin, P. (1994). Seeking inconsistencies in crosswell seismic tomography, Technical Program, 64th Annual SEG Meeting, Society of Exploration Geophysicists, Expanded abstracts, 54–57.
Boisson, J., Cabrera, J., & de Windt, L. (1996). Investigating faults and fractures in an argillaceous formation at the IPSN Tournemire research site. In: Proceedings of OECD/NEA-E.C. International Workshop on Fluid Flow through Faults and Fractures in Argillaceous Formation, Berne, 10–12 June
Bonin, B. (1998). Deep geological disposal in argillaceous formations: Studies at the Tournemire test site. Journal of Contaminant Hydrology, 35, 315–330. https://doi.org/10.1016/S0169-7722(98)001326.
Bretaudeau, F., Gélis, C., Leparoux, D., Brossier, R., Cabrera, J., & Côte, P. (2014). High-resolution quantitative seismic imaging of a strike-slip fault with small vertical offset in clay rocks from underground galleries: Experimental platform of Tournemire, France. Geophysics, 79(1), B1–B18. https://doi.org/10.1190/geo2013-0082.1.
Cabrera, J. (2001). Characterization of discontinuities in an argillaceous medium (Tournemire site): key questions related to safety assessment of radioactive waste disposal. Eurosafe, 5–6 November 2001, Paris. http://www.eurosafe-forum.org/eurosafe2001.
Cabrera, J. (2002). Evaluation of the 3D seismic high-resolution methodat argillaceous Tournemire IRSN site. Eurosafe, 4–5 November 2002, Berlin. http://www.eurosafe-forum.org/eurosafe2002.
Cabrera, J., DeWindt, L., Bruno, G., Rejeb, A., Genty, A., & Volant, P. (2000). The argillaceous indurated media as a potential geological barrier for deep radioactive waste disposal: studies at the experimental IPSN Tournemire site. Safewaste 2000 International Conference, Nuclear Waste: From Research to Industrial Maturity, Montpellier (France), expanded abstracts, 607–623.
Gélis, C., Noble, M., Cabrera, J., Penz, S., Chauris, H., & Cushing, E. M. (2016). Ability of high-resolution resistivity tomography to detect fault and fracture zones: Application to the Tournemire experimental platform, France. Pure and Applied Geophysics, 173(2), 573–589. https://doi.org/10.1007/s00024-015-1110-1.
Gélis, C., Revil, A., Cushing, M. E., Jougnot, D., Lemeille, F., Cabrera, J., et al. (2010). Potential of electric resistivity tomography to detect fault zones in limestone and argillaceous formations in the experimental platform of Tournemire, France. Pure Applied Geophysics, 167(11), 1405–1418. https://doi.org/10.1007/s00024-010-0097-x.
Gill, P. E., Murray, W., & Wright, M. H. (1981). Practical Optimization. USA: Academic Press.
Greenhalgh, S., Zhou, B., & Cao, S. (2003). A crosswell seismic experiment for nickel sulphide exploration. Journal of Applied Geophysics, 53, 77–89. https://doi.org/10.1016/S0926-9851(03)00029-6.
Gritto, R., Korneev, V., Daley, T., Feighner, M., Majer, E., & Peterson, J. (2004). Surface-to-tunnel seismic tomography studies at Yucca Mountain, Neveda. Journal of Geophysical Research, 109, B03310. https://doi.org/10.1029/2002JB002036.
Leroy, P., Revil, A., Altmann, S., & Tournassat, C. (2007). Modeling the composition of the pore water in a clay-rock geological formation (Callovo-Oxfordian, France). Geochimica et Cosmochimica Acta, 71(5), 1087–1097. https://doi.org/10.1016/j.gca.2006.11.009.
Manukyan, E., Maurer, H., Marelli, S., Greenhalgh, S., & Green, A. (2012). Two-dimensional frequency-domain visco-elastic full waveform inversion: Parallel algorithms, optimization and performance. Geophysics, 77(6), EN73–EN83. https://doi.org/10.1190/geo2011-0420.1.
Maufroy, E., Gaffet, S., Operto, S., Guglielmi, Y., & Boyer, D. (2014). Travel time inversion from ground level to gallery: protocol for the characterization of P-wave signature in a fractured-porous Urgonian platform at hectometric scale. Near Surface Geophysics. https://doi.org/10.3997/1873-0604.2014025.
Nicollin, F., Gibert, D., Bossart, P., Nussbaum, C., & Guervilly, C. (2008). Seismic tomography of the excavation damaged zone of the gallery 04 in the Mont Terri Rock Laboratory. Geophysical Journal International, 172(1), 226–239. https://doi.org/10.1111/j.1365-246X.2007.03615.x.
Noble, M., Gesret, A., & Belayouni, N. (2014). Accurate 3-D finite difference computation of traveltimes in strongly heterogeneous media. Geophysical Journal International, 199, 1572–1585. https://doi.org/10.1093/gji/ggu358.
Noble, M., Thierry, P., Taillandier, C., & Calandra, H. (2010). High-performance 3D first-arrival traveltime tomography. Leading Edge, 29(1), 86–93. https://doi.org/10.1190/1.3284057.
Pratt, R., & Worthington, M. (1990). Inverse theory applied to multi-source cross-hole tomography. I: Acoustic wave-equation method. Geophysical Prospecting, 38, 287–310. https://doi.org/10.1111/j.1365-2478.1990.tb01846.x.
Taillandier, C., Noble, M., Chauris, H., & Calandra, H. (2009). First-arrival traveltime tomography based on the adjoint-state method. Geophysics, 74(6), WCB1–WCB10. https://doi.org/10.1190/1.3250266.
Trouiller, A. (2006). The Callovo–Oxfordian of the Paris basin: from its geological context to the modelling of its properties. Comptes Rendus Geosciences, 338, 815–823.
Vi Nhu Ba, E., Noble, M., Gélis, C., Gesret, A., & Cabrera, J. (2013). Geophysical imaging of near subsurface layers to detect fault and fractured zones in the Tournemire experimental Platform, France. EGU General Assembly Conference Abstracts, 15, 7783.
Vi Nhu Ba, E. (2014). Détection des zones de failles par tomographie en transmission: Application à la station expérimentale de Tournemire., PhD thesis, Centre de Geosciences, Mines ParisTech, PSL University.
Yven, B., Sammartino, S., Géraud, Y., Homand, Y., & Villiéras, F. (2007). Mineralogy, texture and porosity of Callovo-Oxfordian argillites of the Meuse/Haute-Marne region (eastern Paris bassin). Bulletin de la Société Géologique de France, 178, 73–90.
Zillmer, M., Marthelot, J.-M., Gélis, C., Cabrera, J., & Druivenga, G. (2014). In situ seismic measurements in claystone at Tournemire (France). Geophysical Journal International, 199(3), 1798–1807. https://doi.org/10.1093/gji/ggu363.
Zinszner, B., Meynier, P., Cabrera, J., & Volant, P. (2002). Vitesse des ondes ultrasonores, soniques et sismiques dans les argilites du tunnel de Tournemire. Effet de l’anisotropie et de la fracturation naturelle. Oil and Gas Science and Technology, 57, 341–353. https://doi.org/10.2516/ogst:2002022.
Acknowledgments
This project was partly funded by the GNR TRASSE IRSN-CNRS 2008–2011 project. The authors are grateful to P. Desveaux who participated to the seismic experiment in Tournemire and to R. Ruau from ABEME for his discussion about Wireless Trigger Box acquisition system. The authors greatly thank M. Zillmer and an anonymous reviewer for their constructive comments and suggestions that helped improving this manuscript.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Ba, E.V.N., Noble, M., Gélis, C. et al. Potential of Surface-to-Tunnel Seismic Tomography to Detect Vertical Faults: Application to the Tournemire Underground Research Laboratory, France. Pure Appl. Geophys. 177, 4143–4159 (2020). https://doi.org/10.1007/s00024-020-02505-0
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00024-020-02505-0