Abstract
The emergency landing is an important design criteria in airworthiness certification. It is associated to the cabin safety and consequently to the risk of serious injury for the occupant. The loads transmitted to the passengers during a hard landing can be fatal both in terms of intensity and duration time, and the energy absorbing systems play a fundamental role to dissipate the energies unleashed during the impacts. A barrel section was studied by the Finite Element Method to simulate the drop test consequences for the fuselage section of a wide body aircraft, and a medium velocity impact was applied to design devices and substructures able to dissipate the biggest amount of kinetic energy. A validation process was obtained following three different steps: firstly, investigating the materials, layups and material characteristics changing with load’s velocity, secondly different tests were performed on the demonstrators in order to verify the installation parameter of the devices devoted to absorb the energies, and finally the experimental results were extended on the lower lobe of the sub-cargo compartment tested at low velocity impact. These experimental results and the correlation with the numerical models allowed to extend the results on the barrel section and to evaluate the accelerations transmitted during the drop to the occupants. The satisfactory results estimated by the numerical solvers are able to aid the design and to reduce the experimental testing for the identification and the choice of different candidate solutions.
Similar content being viewed by others
References
K. E. Jackson. R. L. Boitnott. E. L. Fasanella. L. E. Jones and K. H. Lyle, “A History of Full-Scale Aircraft and Rotorcraft Crash Testing and Simulation at NASA Langley Research Center”, Nasa Technical Research Server, NASA TM 20040191337. 2004.
R. McGuire. W. J. Nissley and J. E. Newcomb, “Vertical Drop Test of a Fairchild Metro III”, FAA report DOT/FAA/CT-93/1, June 1993.
E. L. Fasanella and K. E. Jackson, “Crash Simulation of a Vertical Drop Test of a B737 Fuselage Section with Auxiliary Fuel Tank”, FAA Report, DOT/FAA/AR-02/62. August 2002.
A. Stockwell, “Evaluation of Modeling and Simulation Tools and Techniques for an Analytical Study of the Lear Fan Impact Test,” NASA report, CR-2002-211457, March 2002.
E. L. Fasanella and K. E. Jackson,“Best Practices for Crash Modeling and Simulation”. Technical Publication NASA/TM-2002-21944. Langley Research center, Hampton, Virginia. Oct 2002.
J. R. Dykman, “Lear Fan 2100 Impact Dynamics Analysis Engineering Report,” Report Number R45108, Lear Fan, Reno. N.V., April 22, 1985.
J. K. Morton. J. Lavoie and R. Boitnott, “Scaling of energy absorbing composite plates”. Journal of the American Helicopter Society; 39(1) pp. 17–23, 1994.
E. L. Fasanella and K. E. Jackson, “Analytical and Experimental Evaluation of Composite Energy-Absorbing Subfloor Concepts,” American Helicopter Society National Technical Specialists’ Meeting on Rotorcraft Crashworthiness, Phoenix, AZ, September 14–17, 1998.
Federal Aviation Regulation FAR 25.562 “Emergency landing dynamic conditions”. Federal Aviation Regulation. Federal Aviation Administration, 2006.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Guida, M., Marulo, F., di Caprio, F. et al. Occupants’ Injury during a Drop Test of an Advanced Composite Fuselage Section. Aerotec. Missili Spaz. 97, 129–134 (2018). https://doi.org/10.1007/BF03404766
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF03404766