Abstract
The cylinder bore is of interest for functional and production development processes. The cylinder bore of the piston stroke engine is the place of the highest friction efficiency and its topographical design is decisive for the oil consumption and the emission of modern motor-vehicles, a challenge for engine development and production engineers. Gehring GmbH & Co.KG, Ostfildern, Germany, is an experienced partner for the realization of efficient cylinder bores. On the basis of the tribological requirements present honing variants are described.
Similar content being viewed by others
References
Abeln, T.: Reibungsminderung durch Laseroberflächenstrukturierung im Motorenbau. 3. VDI-Fachtagung ÄZylinderlaufbahn, Kolben, Pleuel“, 7.bis 8. März 2006, VDI-Berichte 1906
Jocsak, J.; Li, Y.; Tian, T.; Wong, V.: Modeling and Optimizing Honing Texture for Reduced Friction in Internal Combustion Engines. In: SAE technical paper series 2006-01-0647
Haasis, G.; Weigmann, U.: Neues Honverfahren für umweltfreundliche Verbrennungsmotoren. In: WB Werkstatt und Betrieb, Jahrgang 132 (1999) Nr. 3, S. 29 ff.
Robota, A.; Zwein, F.: Einfluss der Zylindertopographie auf den Ölverbrauch und die Partikelemissionen eines DI-Dieselmotors. In: MTZ Motortechnische Zeitschrift 60 (1999) Nr. 4, S. 246 ff.
Benz, W.: Oberflächengüte und Bearbeitungsverfahren. In: VDI-Zeitschrift Bd. 90, Nr. 10, Oktober 1948, S. 325–326
Microhoning Automotive Cylinder Bores. In: Cross Hatch, Vol. 9, No. 4, Nov.- Dec-.1957, Schrift der Fa. Micromatic Hone Corporation, Detroit, Michigan
Trautwein, R.: Bewertung der Oberfläche von Zylinderlaufbahnen. Firmenschrift, Fa. Mahle, Technische Information, Folge 13, September 1973
DIN 4776, Ausgabe Mai 1990: Kenngrößen Rk, Rpk, Rvk, Mr1, Mr2 zur Beschreibung des Materialanteils im Rauheitsprofil (Messbedingungen und Auswerteverfahren)
MBN 31007-9: Theoretisches Ölhaltevolumen nach Kolbenringsimulation. Werksnorm Mercedes-Benz
Golloch, R.: Downsizing bei Verbrennungsmotoren. Berlin, Heidelberg: Springer-Verlag, 2005
Rights and permissions
About this article
Cite this article
Flores, G., Abeln, T. & Klink, U. Functionally adapted final machining for cylinder bores made of cast iron. MTZ Worldw 68, 6–9 (2007). https://doi.org/10.1007/BF03226811
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF03226811