Abstract
High-velocity metal forming was the focus of much research approximately 30 years ago. It appears that this technology responds well to many of the challenges facing sheet metal forming today: formability is enhanced, springback is minimized, and die tryout time should be minimized.
Similar content being viewed by others
References
P. Eisenberger, ed., Basic Research Needs for Vehicles of the Future (Princeton, NJ: Princeton Materials Institute, 1995), pp. 19–25.
M.C. Noland, “Designing For the High-Velocity Metal-working Processes,” Machine Design, 39 (August 17,1967), pp. 163–182.
Frank W. Wilson, ed., American Society of Tool and Manufacturing Engineers: High Velocity Forming of Metals (Englewood Cliffs, NJ: Prentice Hall, 1964).
R. Davies and E.R. Austin, Developments in High Speed Metal Forming, American edition (New York: Industrial Press Inc., 1970).
R.W. Curver, “Explosive Fabrication,” High Velocity Forming of Metals, F. W. Wilson, ed. (Englewood Cliffs, NJ: Prentice Hall Inc., 1964), pp. 39–76.
F.C. Moon, Magneto-Solid Mechanics (New York: John Wiley and Sons, 1984).
M.M. Plum, “Electromagnetic Forming,” Metals Handbook, Volume 14,9th Edition (Materials Park, OH: ASM, 1989), pp, 645–653.
W.H. Gourdin, J. Appl. Phys., 65 (1989), p. 411.
CALE Users Manual, Version 950101, R. Tipton, Lawrence Livermore National Laboratory, Mau]l Stop L-35, P.O. Box 808, Livermore, CA 94550.
G. Fenton, research in progress, Ohio State University/ Battelle Columbus Labs (Columbus, OH: 1995).
V.S. Balanethiram and G.S. Daehn, Scripta Metall., 27 (1992), pp. 1783.
V.S. Balanethiram and G.S. Daehn, Scripta Metall., 30 (1992), p. 515.
X. Hu and G.S. Daehn, Acta Metall. (1995).
M. Altynova, X. Hu, and G.S. Daehn, Metall. Trans. (1995).
P. Knoche and A. Needleman, Eur. J. Mech., A/Solids, 12 (1993), pp. 585–601.
B. Reed, Boeing Georgia, communicated in abstract submitted for TMS sheet forming symposium (1995).
Author information
Authors and Affiliations
Additional information
Editor's Note
On Tuesday, October 31, the afternoon session of the Sheet Metal Forming symposium at the TMS/ ASM Materials Week in Cleveland, Ohio, (October 29–November 2,1995) will focus on high-velocity deformation and forming by electromagnetic force.
Rights and permissions
About this article
Cite this article
Daehn, G.S., Altynova, M., Balanethiram, V.S. et al. High-velocity metal forming—An old technology addresses new problems. JOM 47, 42–45 (1995). https://doi.org/10.1007/BF03221230
Issue Date:
DOI: https://doi.org/10.1007/BF03221230